FORD F250 2013 Owners Manual

FORD F250 2013 Owners Manual F250 2013 FORD FORD https://www.carmanualsonline.info/img/11/58774/w960_58774-0.png FORD F250 2013 Owners Manual
Trending: check transmission fluid, horn, navigation update, pairing phone, service reset, service indicator, garage door opener

Page 321 of 577

FORD F250 2013  Owners Manual 3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one minute.
5. Turn the A/C on and allow the engine to idle for at least one minute.
6. Releas

Page 322 of 577

FORD F250 2013  Owners Manual Battery Management System (If Equipped)
The battery management system (BMS) monitors battery conditions
and takes actions to extend battery life. If excessive battery drain is
detected, the system may

Page 323 of 577

FORD F250 2013  Owners Manual CHANGING THE WIPER BLADES
1. To remove the wiper blade,
pull the wiper arm away from the
vehicle. Pry open the lock cover (A)
with your thumb to release the
blade.
2. Press the retaining clip to
disen

Page 324 of 577

FORD F250 2013  Owners Manual AIR FILTER CHECK
Refer toScheduled Maintenance Informationfor the appropriate
intervals for changing the air filter element.
When changing the air filter element, use only the Motorcraft® air filter

Page 325 of 577

FORD F250 2013  Owners Manual 3. Clean the area around the air
tube to air cover connection to
prevent debris from entering the
system and then loosen the bolt on
the air tube clamp so the clamp is
no longer snug to the air tube.

Page 326 of 577

FORD F250 2013  Owners Manual 10. Reconnect the mass air flow
sensor electrical connector to the
outlet tube. Make sure the locking
tab on the connector is in the
“locked” position (connector shown
from below for clarity).
ADJ

Page 327 of 577

FORD F250 2013  Owners Manual 4.On the wall or screen you will
observe a light pattern with a distinct
horizontal edge towards the right.
If this edge is not at the horizontal
reference line, the beam will need
to be adjusted so t

Page 328 of 577

FORD F250 2013  Owners Manual These are examples of unacceptable moisture (usually caused by a lamp
water leak):
•Water puddle inside the lamp.
•Large water droplets, drip marks or streaks present on the interior of
the lens.

Page 329 of 577

FORD F250 2013  Owners Manual 10. For the headlamp bulb,
remove the bulb by turning it
counterclockwise and pulling it
straight out.
11. For the park or turn lamp bulb,
remove the bulb by turning it
counterclockwise and pulling it

Page 330 of 577

FORD F250 2013  Owners Manual Replacing Front Clearance and Identification Lamp Bulbs
(If Equipped)
1. Make sure the headlamps are off.
2. Remove the screw and lens from
the lamp assembly.
3. Pull the bulb straight out of the
sock
Trending: fuel consumption, climate settings, octane, overheating, TPMS, maintenance reset, fold seats