remote start FORD MUSTANG 2001 4.G Owners Manual

Illuminated entry
The interior lamps illuminate when the remote entry
system is used to unlock the door(s) or sound the
personal alarm.
The system automatically turns off after 25 seconds
or when the ignition is turned to the START/RUN or
ACC position. The dome lamp control (if equipped)
mustnotbe set to the OFF position for the
illuminated entry system to operate.
The inside lights will not turn off if:
²
they have been turned on with the dimmer control or
²any door is open.
The battery saver will shut off the interior lamps 30
minutes after the ignition has been turned to the OFF
position, 10 minutes after if the door is left open, and
30 minutes after if the trunk is left open or the dome
lamp switch is left on.
Replacing lost transmitters
Take all your vehicle's
transmitters to your
dealer if service is
required.
If you purchase
additional transmitters
(up to four may be
programmed into
memory), perform the following procedure:
To reprogram the transmitters yourself, place the key
in the ignition and turn from LOCK to OFF and cycle
between OFF and ON eight times in rapid succession
(within 10 seconds) ending in ON. After doors
lock/unlock, press any control on all transmitters (up
to four). With each control press of the transmitters,
the door should cycle (lock/unlock) to confirm
programming. When completed, turn the ignition to
OFF. The door locks should cycle (lock/unlock) one
last time to confirm completion of programming.
All transmittersmustbe programmed at the same
time.
Controls and features
66

Replacing the batteries
The transmitter is powered by two coin type
three-volt lithium batteries. Typical operating range
will allow you to be up to 10 meters (33 feet) away
from your vehicle. A decrease in operating range can
be caused by:
²weather conditions
²nearby radio towers
²structures around the vehicle
²other vehicles parked next to the vehicle
To replace the
batteries:
1. Twist a thin coin
between the two halves
of the transmitter near
the key ring. DO NOT
TAKE THE FRONT
PART OF THE
TRANSMITTER
APART.
2. Place the positive
(+) side of new batteries down. Refer to the diagram
inside the transmitter unit.
3. Snap the two halves back together.
Replacement of the battery willnotcause the
remote transmitter to become deprogrammed from
your vehicle. The remote transmitter should operate
normally after battery replacement.
SECURILOCKYPASSIVE ANTI-THEFT SYSTEM
SecuriLockypassive anti-theft system is an engine
immobilization system. This system prevents the
engine from being started unless acoded key
programmed to your vehicleis used.
The SecuriLockypassive anti-theft system is not
compatible with non-Ford aftermarket remote start
systems. Use of these systems may result in vehicle
starting problems and a loss of security protection.
Controls and features
67

Safety seats for
children ...................... 95
Seat belts (see Safety
restraints) .................. 76
Seats .......................... 73
child safety seats .... 95
cleaning ......... 204±205
easy access/easyout
feature ..................... 75
SecuriLock passive
anti-theft
system .................. 67±69
Servicing your
vehicle ...................... 147
Spark plugs,
specifications ........... 206
, 209±210
Special notice .............. 3
Specification chart,
lubricants ......... 208±209
Speed control ............ 53
Speedometer ............. 15
Starting your
vehicle ...... 103±104, 106
jump starting ........ 141
Steering wheel
tilting ....................... 52
T
Tachometer ............... 16
Tires ......... 137, 175±177
changing ........ 137±138
checking the
pressure ................. 177
replacing ................ 178
rotating .................. 177snow tires and
chains .................... 179
tire grades ............. 176
treadwear .............. 175
Towing ..................... 124
recreational
towing .................... 127
trailer towing ........ 124
wrecker .................. 146
Traction
control ............... 50, 111
active light .............. 12
Traction-lok rear
axle .......................... 122
Transmission
automation
operation ............... 113
fluid, checking and
adding
(automatic) ........... 167
fluid, checking and
adding (manual) ... 170
fluid, refill
capacities ............... 206
lubricant
specifications. 208±209
manual operation .. 119
Trip odometer ........... 17
Trunk ......................... 71
remote release .. 50, 65
Turn signal ............ 8, 51
V
Vehicle
dimensions ............... 210
Vehicle Identification
Number (VIN) ......... 211
Index
234