length FORD MUSTANG 2003 Workshop Manual

FORD MUSTANG 2003 Workshop Manual MUSTANG 2003 FORD FORD https://www.carmanualsonline.info/img/11/56942/w960_56942-0.png FORD MUSTANG 2003 Workshop Manual

Page 41 of 4378

FORD MUSTANG 2003  Workshop Manual Lateral runout means measuring the movement or "wobble" of a wheel or tire at the sidewall. Radial 
runout means measuring the out-of-
round at the tread surface. 
Rustling 
Intermittent sound of vary

Page 61 of 4378

FORD MUSTANG 2003  Workshop Manual glass 
�zAir traveling up 
windshield molding 
along A- pillar.  �z
INSTALL foam rope the 
full length of the A- pillar. 
�z Windshield/backlite 
misaligned or not 
installed correctly.  �z
REINSTALL

Page 112 of 4378

FORD MUSTANG 2003  Workshop Manual 5. In the following steps, the movement of the contact pattern along the length is indicated as 
toward the" heel" or "toe" of the differential ring gear. 
6. Apply a marking compound to a third of th

Page 267 of 4378

FORD MUSTANG 2003  Workshop Manual Repair the axle as necessary. Make sure the axle lubricant is at the correct level. Refer to 
Specifications in this section. 
Axle Vent 
NOTE: 
If a plugged vent cannot be cleared, install a new one.

Page 274 of 4378

FORD MUSTANG 2003  Workshop Manual crayon or chalk. 
6. While holding the crayon or chalk against the tire, rotate the wheel slowly in the opposite  direction until the feeling of driving the rear axle is encountered again. 
7. Measure

Page 331 of 4378

FORD MUSTANG 2003  Workshop Manual 6. Remove the outer differential pinion bearing. 
7. Remove and discard the collapsible spacer (4662). 
8. Using the special tool and a suitable press, remove the inner differential pinion bearing (46

Page 494 of 4378

FORD MUSTANG 2003  Workshop Manual SPECIFICATIONS 
SECTION 205-
05: Rear Drive Halfshafts  2003 Mustang Workshop Manual General Specifications 
Item  Specification 
Halfshaft assembled length  817.6 mm (32.19 in) 
Torque Specifications

Page 495 of 4378

FORD MUSTANG 2003  Workshop Manual DESCRIPTION AND OPERATION 
Rear Drive Halfshafts 
The rear wheel drive halfshaft system consists of and operates as follows: 
�zHalfshafts (4K138) transmit engine torque from the rear axle housing to

Page 566 of 4378

FORD MUSTANG 2003  Workshop Manual REMOVAL AND INSTALLATION 
Brake Caliper Anchor Plate 
Removal 
1. Remove the pads. For additional information, refer to Pads  in this section. 
2. Remove the anchor plate (2B292).  1. Remove and disca

Page 617 of 4378

FORD MUSTANG 2003  Workshop Manual Brake Pressure Control Valve 
The brake pressure control valve proportions the pressure to the rear brakes. 
�zWhen the brake pedal is applied, brake fluid pressure passes through the proportioning va
Page:   1-10 11-20 21-30 31-40 41-50 ... 50 next >