engine FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual SIERRA 1993 2.G FORD FORD https://www.carmanualsonline.info/img/11/5457/w960_5457-0.png FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual

Page 1 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual General
Fuel tank capacity:
All models except P100  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60.0 litres (13.2 gals)
P100 models  . . . . . . . . . . . . . . . . . . . . .

Page 4 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual 2.0 litre DOHC models
Inlet manifold nuts and bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20 to 2415 to 18
Exhaust manifold nuts . . . . . . . . . . . . . . . . . . . . . .

Page 5 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual air charge temperature sensor mounted in the
base of the air cleaner body, and disconnect
the breather hose from the camshaft cover.
Refitting
9Refitting is a reversal of removal, ensuring
that the di

Page 6 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual 5On some early pumps, the top cover can be
removed for access to the filter. Removing the
pump and cleaning the filter may cure the
problem. On models with a sealed pump, or
where cleaning the interio

Page 8 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual Removal
1Disconnect the battery negative lead.
2Remove the lower facia panel from the
driver’s side.
3Prise off the securing clip and disconnect
the end of the throttle cable from the top of
the ped

Page 13 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual Fuel and exhaust systems - carburettor  4A•13
4A
13.4f Exploded view of Weber 2V TLD carburettor
A  Anti-dieselling valve
B  Emulsion tubes
C  Air correction jets
D  Choke pull-down diaphragm assemb

Page 14 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual washers, and lift the carburettor from the inlet
manifold studs (see illustrations). Recover
the gasket.
Refitting
9Refitting is a reversal of removal, bearing in
mind the following points.
10Ensure t

Page 15 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual Refer to Chapter 1, Sections 15 and 16.
1Check the idle speed and mixture
adjustment. The idle speed must be correct
before attempting to check or adjust the fast
idle speed.
2With the engine at norma

Page 16 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual bracket (see illustration).
12Lift the inlet manifold from the cylinder
head, and recover the gasket (see
illustration).
13If desired, the carburettor can be removed
from the inlet manifold by unscrew

Page 17 of 20

FORD SIERRA 1993 2.G Fuel And Exhaust Systems Carburettor Workshop Manual Refitting
52Refitting is a reversal of removal, bearing
in mind the following points.
53Ensure that all mating faces are clean and
renew the gasket(s).
54Tighten the manifold securing nuts
progressive
Page:   1-10 11-20 next >