spare tire GEELY CK 2008 Workshop Manual

348(XIV) Rear trunk Inside TrimRear trunk inside Trim Diagram :
Rear trunk Inside Trim Diagram
1. Right Rear Quarter Trim 2. Left Rear Quarter Trim 3. Lower Rear Board Trim Assembly
4. Spare Tire Press Plate Assembly 5. Rear trunk Stuck Plate 6. Right Rear Combination Lamp Access
Hole Cover 7. Left Rear Combination Lamp Access Hole Cover 8. Rear Partition Inside Trim
9. Rear trunk Miscelleaneous Box10. J-Clip ( Rear Quarter Trim ) 11. Right Outside
Sound Insulator 13. Right Rear Wheel-
house Sound Insulator 14. Right Rear Wheelhouse Sound Insulator15. Right Speaker Grill
16. Left Speaker Grill17. Rear Damper Cover
1. Removal
1Remove the connector and remove the high mounted stop lamp;
2Remove C pillar upper inside trim;
3Remove the rear partition inside trim ;
4Remove the right speaker grill and left speaker grill with a cross screwdriver;
5Remove the lower rear board trim assembly clip with opener. Remove the lower rear board trim assembly;
6Remove the right rear combination lamp access hole cover, left rear combination lamp access hole cover
7Remove the clip installed at the left and right rear quarter trim with a cross screwdriver;
8Remove the clip installed at the left and right rear quarter trim with an opener;
9Remove the rear damper cover; 1
2 3 4
5 6
7 8
9 1011
12 13 14
15 16 17 12. Left Outside Wheelhouse Wheelhouse
Sound Insulator

349VTake out the rear trunk carpet, spare tire cover board and the rear trunk miscelleaneous box. Screw the
spare tire press plate assembly to take out the spare tire.
2. Installation
1Clip the rear trunk inside trim onto the corresponding hole in the reserve order of the removal;
2Install the right rear and left rear combination lamp access hole cover;
3Install the right and left speaker grill to the rear partition inside trim with a cross screwdriver;
4Install the rear partition inside trim to the vehicle body;
5Install the high mounted stop lamp and the C- pillar upper inside trim.(XV) Engine Hood Inside TrimEngine Hood Inside Trim Diagram:
Engine Hood Inside Trim
1. Engine Hood Inside Trim 2. E-Clip
1. Removal
1Open the engine hood and gas spring;
2Remove the clip and remove the engine hood inside trim
2. Installation
1Open the installed engine hood and gas spring;
2Align the corresponding hole position in the the engine hood inside trim and press the clip in by hand.
2 1