spare wheel GEELY CK 2008 Workshop Manual

292Section 3 Removal and InstallationI.Precautions for Removal1. Use the scan meter to locate the fault causes before proceeding to service.
2. wipe the surface clean with the cleaning agent without mineral oil before service; be careful to keep it
clean during service, only the lint-free cloth can be used to wipe the removed parts.
3. Only the original spare part can be used, and the package of the new spare part shall not be removed until
the installation.
4. Return liquid pump motor and the HCU is a type of integral structure and can not be separated.
5. When the system is opened, do not use compressed air or move the vehicle.
6. Use proper plug to clog each hydraulic outlet as soon as the ABS assembly is removed.
7. Remove other components that may interfere.
8. Please use the DOT 4 brake fluid, do not use the mineral oil.
9. Use the brake fluid to immerse the seal and the O ring, do not use the engine oil or brake grease.
10. After service, check the regular brake system and ABS brake function for normal and reliable operation.
11. Check all hydraulic pipe union for leakage.II. HECU Removal1. Turn off the ignition switch and disconnect the battery negative ground cable.
2. Remove the wire connector from the ABS HECU assembly.
3. Depress the brake pedal >60mm and hold it with the pedal retainer to close the master cylinder center
valve so that the brake fluid will not flow out from the outlet when the system is opened.
4. Put a clean cushion under the hydraulic regulator.
5. Remove the brake pipe (A, B) on the HCU connected to the master cylinder and place the mark, then
use a plug to clog the outlet immediately.
6. Remove the brake fluid pipe(1-4) leading to the wheels, then use a plug to clog the outlet immediately.
7. Remove the nut attaching the HECU to the bracket.

348(XIV) Rear trunk Inside TrimRear trunk inside Trim Diagram :
Rear trunk Inside Trim Diagram
1. Right Rear Quarter Trim 2. Left Rear Quarter Trim 3. Lower Rear Board Trim Assembly
4. Spare Tire Press Plate Assembly 5. Rear trunk Stuck Plate 6. Right Rear Combination Lamp Access
Hole Cover 7. Left Rear Combination Lamp Access Hole Cover 8. Rear Partition Inside Trim
9. Rear trunk Miscelleaneous Box10. J-Clip ( Rear Quarter Trim ) 11. Right Outside
Sound Insulator 13. Right Rear Wheel-
house Sound Insulator 14. Right Rear Wheelhouse Sound Insulator15. Right Speaker Grill
16. Left Speaker Grill17. Rear Damper Cover
1. Removal
1Remove the connector and remove the high mounted stop lamp;
2Remove C pillar upper inside trim;
3Remove the rear partition inside trim ;
4Remove the right speaker grill and left speaker grill with a cross screwdriver;
5Remove the lower rear board trim assembly clip with opener. Remove the lower rear board trim assembly;
6Remove the right rear combination lamp access hole cover, left rear combination lamp access hole cover
7Remove the clip installed at the left and right rear quarter trim with a cross screwdriver;
8Remove the clip installed at the left and right rear quarter trim with an opener;
9Remove the rear damper cover; 1
2 3 4
5 6
7 8
9 1011
12 13 14
15 16 17 12. Left Outside Wheelhouse Wheelhouse
Sound Insulator