parking brake GEELY FC 2008 Owner's Manual

Panel/combination instrument-combination instrument
13. Check the switch of indicating light of brake liquid level.
(1) Disassemble the cover and filter screen of liquid storage tank of brake main pump.
(2) Disassemble the joint.
(3) Check the conduction between switch side joints.
Float (switch is OFF): not conduction
(4) Use siphon and other tools to absorb brake liquid in storage tank.
(5) Check the conduction between switch side joint terminals.
Sink (switch is ON): conduction
(6) Pour brake liquid into storage tank.
Inspection
1. Check the switch of indicating light of brake liquid level.
Check the conduction between switch side joint terminals.
Float ((switch is OFF): not conduction
Sink (switch is ON): conduction
2. Check parking brake switch.
Check the conduction between switch side joint terminals.
When switch pin is released: conduction
When switch pin is pressed: not conduction
 339 

Panel/combination instrument-- panel
L
4 Fixing
clasp
3 Fixing
clasp
Fixing
clamp
25. Disassemble parking brake hole cover.
Use screw driver to unclench four fixing clamps, then disas-
semble parking brake hole cover.
Hint: before using screw driver, it is necessary to wrap its
needled top with adhesive tape.
26. Disassemble auxiliary panel assembly [68010002]
(a) Disassemble two L bolts, two C bolts and auxiliary panel
assembly.
27. Disassemble right front door pedal trim board
[68010021]
Use screw driver to unclench three fixing clamps, then disas-
semble right front door pedal trim board.
Hint: before using screw driver, it is necessary to wrap its
needled top with adhesive tape.
28. Disassemble left front door pedal trim board
[68010020]
29. Disassemble lower inner trim board of right de-
fender [68010016]
(a) Disassemble plastic nuts of lower inner trim board of right
defender.
(b) Unclench fixing clamp, then disassemble lower inner trim
board of right defender liking that shown in figure.
30. Disassemble lower inner trim board of left defender
[68010015]
31. Disassemble connecting board at the middle of
panel [68010006]
(a) Use screw driver to unclench four fixing clamps, then open
the connecting board at the middle of panel.
Hint: before using screw driver, it is necessary to wrap
its needled top with adhesive tape.
(b) Disassemble connecting board at the middle of panel.
 344