sunroof GEELY FC 2008 Workshop Manual

Replacement.................................................
308
Left front door loudhailer....................................
309
Change..........................................................
309
Left front small loudhailer..................................
310
Change..........................................................
310
Rear loudhailer..................................................
311
Change..........................................................
311
Outdoor antenna...............................................
312
Change..........................................................
312
Circuitry
Power supply......................................................
313
Components..................................................
313
Horn system
Horn system.......................................................
316
Position..........................................................
316
Inspect...........................................................
316
Windshield/window glass/wing mirror
Electric window control system..........................
317
Position drawing............................................
317
Inspect the car...............................................
317
Malfunction phenomena table.......................
319
Inspect...........................................................
319
Front windscreen................................................
321
Change..........................................................
321
Rear ventilation window.....................................
324
Change..........................................................
324
Fog defrost system............................................
327
Position drawing...........................................
327
Malfunction phenomena table......................
327
Inspect...........................................................
328
Electric rearview mirror control system(option).
329
Inspect the vehicle.........................................
329
Position drawing...........................................
331
Trouble table.................................................
331
INSPECT.......................................................
332Panel / combination panel
combination panel
..............................................
334
Trouble table..................................................
334
Vehicle inspection..........................................
335
Inspection......................................................
339
Panel..................................................................
340
Preparation....................................................
340
Change..........................................................
340
Combination instrument assembly.....................
347
Disassembly and assembly...........................
347
Chair
Front chair..........................................................
348
Subassembly.................................................
348
Overhaul........................................................
349
Rear chair (separating type)...............................
352
Overhaul........................................................
352
Rear chair (fixing type).......................................
354
Overhaul........................................................
354
Anti-stealing and door lock
Electric door lock control system........................
355
Position of parts.............................................
355
Inspection on automobile...............................
355
Malfunction phenomenon table.....................
358
Inspection......................................................
359
Electronic anti-stealing system...........................
361
Electric sunroof
Sunroof.................................................................
362
Overhaul........................................................
362
Specification for sunroof function......................
364
Inspection for sunroof function......................
364
Inspection for sunroof switch........................
365
Position of parts............................................
365
Malfunction phenomenon table....................
365

Light--Light System
Switch positionsAvometer terminals regular situation
OFF 1-2 not conduction
ON 1-2 conduction
(d) Inspect conduction of front fog light switch
(1) Inspect switch on every positions, the conduction among terminals as following table.
Switch positionsAvometer terminals regular situation
OFF - not conduction
DOOR 1-2conduction
ON 2-bodywork earthconduction
2. Interior rear top light assembly [67010006]
(a) Inspect the conduction of interior rear top light
(1) Inspect switch on every position, the conduction among
terminals as following table.
Standard:
3. Room front top light assembly [67010007] (equipped
with electric sunroof [67010009])
(a) Inspect the conduction of room front roof light
(1) Inspect the conduction between terminal 1 and terminal
2,when switch works.
Standard:
ON: conduction
OFF: not conduction
4. Room front top light assembly [67010005](do not
equipped with electric sunroof)
(a) Inspect the conduction of room front roof light
(1) Inspect the conduction between terminal 1 and terminal
2,when switch works.
Standard:
ON: conduction
OFF: not conduction
5. Trunk lighting assemble [67000106]
(a) Inspect the conduction among terminals.
Standard: conduction
6. Inspect the B door pillar control switch assembly
[67000075]
1 2
 284 

Circuitry--Power supply
24. spare
25. OBD discharge test system
26. rear fog light
27. Anti-burglary
28. DOOR center control, light con-
trol system
29. Defrost load
30. spare
31. spare
32. eletric injection system, safety
airbag system, anti-burglary
system, instrument system
33. spare
34. spare
35. spare
36. front fog light
37. AMI ignition system
38. TAILposition light, number platelight
39. brake light
40. electric sunroof
41. instrument system, air condition
system, defrost system, Re-
verse Radar, rear light, turn light.
42. CIG air condition system, audio
system, electric rear view mirror,
cigarette lighter
43. washer
44. spare
45. wiper
46. spare
47. center control, light control
system, anti-burglary system,
ABS system
48. air condition system
49. rear defrost system
50. electric glass operator
 315 

Anti-stealing and door lock--Electric door lock control system
 357 
Power supply (+) Power supply (+)
Power supply
(+)
1G2 in Power supply
(+)
1G2 out Power supply (-)
Power supply (+) Power supply (+) Power supply (+) Power supply (+)
Power supply
(+)Power supply
(+)Power supply
(-) Power supply
(+)
Power supply (+)
Power supply (+)
Grounding wire
Sunroof
Rain wiperBrake light Anti-steal
Power supply
(+)
InstrumentRear fog light

Electric sunroof (optional)--Sunroof
Bolt
Screw cap
Electric sunroof (optional)
Sunroof
Overhaul
Hint: when assembling, please work by the sequence which is opposite with disassembling
sequence; but when it has items that need to pay special attention, it will add special specification.
1. Disassemble inner trim board of top (referring to page 390).
2. Disassemble the glass of sunroof.
(a) Use planetary wrench to disassemble planetary screw.
(b) Pull the glass upwards to disassemble it.
3. Disassemble waterproof adhesive tape of sunroof.
4. Disconnect connection of wiring harness.
5. Disassemble shell body of sunroof.
(a) Disassemble four drain hoses.
(b) Liking that shown in figure, disassemble four bolts and six screw caps, then disassemble shell body.
6. Disassemble trim sun shade of sunroof.
(a) Disassemble the screw and stopper.
(b) Disassemble trim sun shade of sunroof.
 362 

Electric sunroof (optional)--Sunroof
7. Use screw driver (twisted by adhesive tape) to align
the sunroof driving pull cable with right mark.
8. Assemble sunroof shell body assembly.
(a) Bolt.
Torque: 5.5 N
⋅ ⋅⋅ ⋅
⋅m
(b) Screw cap.
Torque: 5.0 N
⋅ ⋅⋅ ⋅
⋅m
9. Assemble the glass of sunroof.
(a) Check the phase difference between sunroof waterproof ad-
hesive tape and top gasket.
Front end and rear end: 0±1.5mm
Rear corner: 0±1.5mm
0-1.5mm
(b) Adjustment
Use T25 planetary wrench to loosen the screw to adjust
the sunroof on correct position, then lock the screw.
10. Inspection for water leakage.
(a) After the adjustment, check whether the sunroof leaks water.
(b) If sunroof leaks water, adjust it again.
Assembly mark
 363 

Electric sunroof (optional)--Sunroof system
Inspection for sunroof function
1. Inspection for sliding opening function.
(1) Turns ignition switch to ON, when spot contacting sunroof
switch keystroke 2, the sunroof will start automatic sliding
opening work, and it does not stop until it is at complete
opening state. If spot contacting it in running process, or
pressing keystroke 1 or 2 for long time, sunroof glass will
stop running immediately.
(2) Turns ignition switch to ON, when pressing keystroke 2 for
Sunroof system
Specification for sunroof function
1. Operation category
Spot contact: press the keystroke one time, then release immediately (the time is less than 0.3 seconds).
Long press: press the key stroke for long time (the time is more than 0.3).
2. Specification for function.
Anti-clamping function: spot contact the keystroke to make the sunroof could face 10 Kg resistance in the
process of closing from any position, at this time, electric motor turns oppositely, and the sunroof returns
turn-up or opening state.
Automatic closing function: when the key is pulled out from ignition locker, at this time, the sunroof is not
at closing state, it will close automatically in three seconds.
long time, the sunroof will start automatic sliding opening work, and it does not stop until it is at
complete opening state. If releasing keystroke 2 in running process, the sunroof glass will stop running
immediately.
2. Inspection for sliding closing function.
(1) Turns ignition switch to ON, if the sunroof is at opening state, when spot contacting sunroof switch
keystroke 1, the sunroof will automatically slide to closing state. If spot contacting it or pressing
keystroke 1 or 2 for long time in running process, sunroof glass will stop running immediately.
(2) Turns ignition switch to ON, if the sunroof is at opening state, when pressing sunroof switch keystroke
1 for long time, the sunroof will automatically slide to closing state. If releasing keystroke 1 in running
process, sunroof glass will stop running immediately.
3. Inspection for turn-up opening function
(1) Turns ignition switch to ON, if the sunroof is at closing state, when spot contacting sunroof switch
keystroke 1, the sunroof will automatically move to turn-up opening state. If spot contacting it again or
pressing keystroke 1 or 2 for long time in running process, sunroof glass will stop running immediately.
(2) Turns ignition switch to ON, if the sunroof is at closing state, when pressing sunroof switch keystroke
1 for long time, the sunroof will automatically slide to turn-up opening state. If releasing keystroke 1 in
running process, sunroof glass will stop running immediately.
4. Inspection for turn-up closing function
(1) Turns ignition switch to ON, if the sunroof is at turn-up opening state, when spot contacting sunroof
switch keystroke 2, the sunroof will automatically move to closing state. If spot contacting it again or
pressing keystroke 1 or 2 for long time in running process, sunroof glass will stop running immediately.
(2) Turns ignition switch to ON, if the sunroof is at turn-up opening state, when pressing sunroof switch
keystroke 2 for long time, the sunroof will automatically slide to closing state. If releasing keystroke 2
in running process, sunroof glass will stop running immediately.
 364 
Front
Rear

Electric sunroof (optional)--Sunroof system
Inspection for sunroof switch
(a) Check the function of switch. Disassemble front top light,
and disassemble the joint of front top light, then check the
joint at the side of switch liking that shown in figure.
Malfunction phenomenon table Position of parts
Malfunction phenomenon
Sunroof system does not work
Sunroof system works abnormallyPossible malfunction part
1. Ignition switch.
2. Control switch of sunroof.
3. 25A, 15# fuse.
4. Wiring harness
1. Control switch of sunroof.
2. Wiring harnessReference page
-
-
-
-
-
-
 365 
Terminal connected by avometer
2-4
2-5ConditionSpot contact or press
keystroke 2 for long time
Spot contact or press
keystroke 1 for long time
Regulated situa-
tion
Conduction
Conductiion
Shell body of sunroof
Motor of sunroof
Switch of sunroof

Exterior/inner trim board--Inner trim board of top29. Disassemble the pothook of sun shade [68010086]Turn the pothook of sun shade to left for 90°, then disassemble
it.30. Disassemble fixing pedestal of rear window sun
blind.Use screw driver to turn the fixing pedestal of sun blind for 90°,
then disassemble it.31. Disassemble trim tape of top sunroof [67010010]
32. Disassemble inner trim board of top [68010035](a) Use screw driver to disassemble inner trim board of top.
Hint: before using screw driver, its needled top should
be twisted by adhesive tape.
(b) Disassemble three fixing clamps and inner trim board of
top.
(c) Take out inner trim board of top from rear door.33. Assemble inner trim board of top [68010035](a) Liking that shown in figure, align the mark, then fix the wir-
ing harness of top with adhesive tape.
(b) Use three fixing clamps to assemble inner trim board of top.34. Assemble the pothook of sun shade [68010086]Turn the pothook of sun shade to make fixing claw proturde,
then assemble sun shade.35. Assemble rear row chair left backrest assembly
[68010078]
36. Assemble rear row chair right backrest assembly
[68010079]
37. Assemble rear row chair backrest assembly
[68010076]Fixing
clamp
Adhesive
tape393

Electric sunroof Electric chairElectrical schematic diagram--Electric sunroof Electric chair 399