7-55
07
After checking the fuse box in the
engine compartment securely
close the fuse box cover inside
the engine compartment, until it
clicks.
If the fuse box is not closed prop-
erly, water may leak in side, possi-
bly causing a malfunction with the
electrical system.
Main fuse
If the main fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery
cable.
3. Remove the fuse panel cover by
pressing the tab and pulling it up.
4. Remove the nuts shown in the pic-
ture above.
5. Replace the fuse with a new one
of the same rating.
6. Reinstall in the reverse order of
removal.
Information
If the main fuse is blown, consult an
authorized retailer of Genesis Branded
products.
Multi fuse
If the multi fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery
cable.
3. Remove the fuse panel cover by
pressing the tab and pulling it up.
4. Remove the nuts shown in the pic-
ture above.
5. Replace the fuse with a new one
of the same rating.
6. Reinstall in the reverse order of
removal.
Information
If the multi fuse is blown, consult an
authorized retailer of Genesis Branded
products.
i
i
NOTICE
OHI078026
OHI078027
7-67
07
Trunk fuse panel
(Battery junction block)
Inside the fuse/relay box covers, you
can find the fuse/relay label describ-
ing fuse/relay names and ratings.
Information
Not all fuse panel descriptions in this
manual may be applicable to your
vehicle; the information is accurate at
the time of printing. When you inspect
the fuse box on your vehicle, refer to
the fuse box label.
i
OHI078088L
OHI078065
7-68
Maintenance
Trunk fuse panel
Fuse nameFuse rating Circuit protected
B+9100A
Rear Sub Junction Block (Fuse - REAR HEATED, POWER
TRUNK, DOOR LOCK2, RDM LH, P/SEAT (RR RH) 2, AIR
BAG, RDM RH, AMP, S/HEATER (RR RH), P/SEAT (RR
RH) 1, P/SEAT (RR RH) 3, P/SEAT (RR LH) 3, ECS, FUEL
LID, DOOR LOCK1, TRUNK, S/HEATER (RR LH), BLOW-
ER RR)
START80AMetal Core Block (PCB #2 Fuse - START, ECU1, TCU1,
IG1)
AMS10ABattery Sensor