warning GMC ACADIA 2007 Get To Know Guide

Getting to Know YourAcadia2
Instrument Panel
A
B
D
E
A
F
A
H
I
J
K
L
M
N
O
P
V
G
DRIVER INFORMATION
Q
C
R
S
P
T
See Section 3 of your Owner Manual.
A.Air Outlets
B.Turn Signal/Windshield
Wipers/Multifunction Lever
C.Instrument Panel Cluster
D.Driver Information Center Buttons
(if equipped)
E.Audio System/Navigation System
(if equipped)
F.Hazard Warning Flashers Button
G.Passenger Air Bag Status IndicatorH.Exterior Lamps Control
I.Instrument Panel Brightness
Control
J.Hood Release
K.Cruise Controls
L.Tilt and Telescopic Steering
Wheel Lever
M.HornN.Audio Steering Wheel Controls
(if equipped)
O.Climate Controls
P.Heated Seat Buttons (if equipped)
Q.Shift Lever
R.Traction Control Button
S.Tow/Haul Mode Button (if equipped)
T.Power Liftgate Button (if equipped)
U.Accessory Power Outlet
V.Glove Box
U
Acadia 2007 A 10/3/06 3:06 PM Page 2

3
Instrument Panel Cluster
A
B
C
D
E
F
L
G
H
I
K
J
See Section 3 of your Owner Manual.
Your vehicle’s instrument panel is
equipped with this cluster or one verysimilar to it. The instrument panel cluster
includes these key features:
A.Engine Coolant Temperature Gauge
B.Tachometer
C.Malfunction Indicator Lamp (Check
Engine Light)
D.Tire Pressure Warning Light
E.Driver Information CenterF.Fuel Gauge
G.Speedometer
H.Security Light
I.Cruise Control Set Light
J.Antilock Brake System
Warning Light
K.StabiliTrak Warning Light
L.Voltmeter
Note:
The instrument panel cluster
is designed to let you know aboutmany important aspects of yourvehicle’s operation. It is important
toread your Owner Manual and
become familiar with the informationbeing relayed to you by the lights,gauges and indicators, as well aswhat action can be taken to ensuresafety and to prevent damage.
Acadia 2007 A 10/3/06 3:06 PM Page 3

Your vehicle’s Driver Information Center
(DIC) provides vehicle information, vehicle feature customization, and vehicle
warning messages. The DIC messageswill be shown on the instrument panel
cluster display.
DIC Reset Stem
On vehicles with the base DIC, press
the reset stem located on the instrumentpanel cluster while the vehicle is
parked to display the Odometer, Trip
Odometers, Oil Life, Park Assist (if
equipped), Tire Pressure SystemProgramming, Units, and DisplayLanguage.
DIC Buttons (if equipped)
The uplevel DIC includes the following
buttons located below the radio on theinstrument panel:
(Set/Reset):Press this button to set
or reset DIC information while it is displayed or to acknowledge a warningmessage.
Getting to Know YourAcadia4
(Customization):Press this button
to scroll through the following customization settings:
• Display Language
• Auto Door Lock
• Auto Door Unlock
• Remote Door Lock
• Remote Door Unlock
• Delay Door Lock
• Exit Lighting
• Approach Lighting
• Chime Volume
• Park Tilt Mirrors (if equipped)
• Easy Exit Seat (if equipped)
• Memory Seat Recall (if equipped)
•Remote Start (if equipped)
• Factory Settings
(Vehicle Information):Press this
button to display the following vehicleinformation:
•Oil Life
• Park Assist (if equipped)
•Units
•Tire Pressure
•Tire Pressure System Programming
• Remote Keyless Entry Programming
(Trip/Fuel):Press this button to
display the following trip and fuelinformation:
• Odometer
• Trip Odometers
Driver Information Center
Acadia 2007 A 10/3/06 3:07 PM Page 4

The HeadUp
Display (HUD)projects arange of vehicleinformation onthe windshield,reducing the need to look away from theroad. The information appears as an
image toward the front of the vehicle.
The information displayed by the HUDmay include the speedometer reading,RPM reading, transmission position,outside air temperature, highbeamheadlamps and turn signal indicators, abrief display of the current radio station
or CD track, and TurnbyTurnNavigation information (if equipped).
The following HUD controls are located
on the instrument panel to the right ofthe steering wheel:
(Off): To turn off the HUD image,
rotate the dimming knob fullycounterclockwise.
Brightness: Rotate the dimming knob
clockwise to brighten and counterclock
wise to dim the HUD image.
(Up) (Down):Press the up or
down arrow to adjust the position of theHUD image on the windshield. (It cannotbe adjusted sidetoside.)
5
HeadUp Display (if equipped)
Customization Settings with DIC
Buttons
To customize features:
1. With the vehicle in Park, turn on the
ignition.
2. Press the (Customization) button
to enter the Feature Settings menu.
3. Press the button to scroll through
the available customization features.
4. With the desired feature displayed,
press the (Set/Reset) button toaccess the settings.
5. Press the button to scroll through
the available settings.
6. With the desired setting displayed,
press the button to select it.
7.Press the button to scroll to the
next available customization feature.
8. To exit the Feature Settings menu,
press the button until FEATURE
SETTINGS EXIT is displayed, and
then press the button; or press
the button or the button.
Warnings and Messages
The DIC provides a variety of vehicle
warning messages (depending onoptional equipment) if a problem is
sensed in a vehicle system. To acknowledge a message and clear it from the
display, press the DIC reset stem or anyDIC button. Some urgent messages
cannot be cleared from the DIC display.
If you have a current OnStar subscrip
tion, and a warning message appears,you can press the blue OnStar buttonand speak to an OnStar Advisor. In
many vehicles, OnStar Advisors can
access certain diagnostic information
and can tell you how serious the problem is and what you should do about it.
See Section 3 of your Owner Manual.
Note: Your vehicle’s warnings and mes
sages provide critical information thatcan prevent damage to your vehicle.Review your Owner Manual to becomefamiliar with the information displayedand the action required.
Acadia 2007 A 10/3/06 3:07 PM Page 5

21
There are several ways to open and
close the power liftgate:
• Press and hold the (Power
Liftgate) button on the RemoteKeyless Entry transmitter until theliftgate starts moving. Press it againto reverse operation.
• Press the (Power Liftgate) button
on the center console in front of the
shift lever. Press it again to reverse
operation.
• Press the touchpad on the liftgate
handle to open. Press it again toreverse operation.
• Press the
button on thebottom of theliftgate, next tothe liftgatelatch, to close.Press it again to reverse operation.
To disable all power liftgate controls,
switch the button on the center
console to the OFF position. The liftgate
can be opened and closed manually.
See Section 2 of your Owner Manual.
Power Liftgate (if equipped)
Remote Vehicle Start
(if equipped)
This feature allows you to start the
engine from outside the vehicle by using
the RKE transmitter. The remote startcapability must be turned on using theDriver Information Center.
The vehicle’s automatic climate control
system (if equipped) will default to aheating or cooling mode based onoutside temperature, and the manualclimate control system will turn on at the
same setting as when the vehicle was
last turned off.
Starting the Vehicle
To remote start the vehicle:
1.Aim the RKE transmitter at the
vehicle. (Transmitter range is withinapproximately 195 feet of the vehicle.)
2. Press and release the (Lock)
button on the transmitter.
3. Immediately press and hold the
(Remote Start) button for about fourseconds. When the vehicle starts, theparking lamps will light and remain on
while the engine is running. The enginewill continue running for 10 minutes.
4. Repeat these steps for a 10minute
time extension. Only two consecutiveremote starts are allowed.
When you enter the vehicle after a
remote start, the key must be inserted inthe ignition and turned to the On positionbefore driving.
Canceling a Remote Start
If you wish to turn off the engine instead
of driving after a remote start, performone of the following functions:
•Press and hold the (Remote Start)
button until the parking lamps turn off.
•Press and release the Hazard
Warning Flashers button. Press it
again to turn off the flashers.
• Turn the key in the ignition switch to
the On position and then off.
See Section 2 of your Owner Manual.
Note:The Remote Vehicle Start feature
will not operate if the key is in the ignition, the hood or liftgate is open, or theCheck Engine light is illuminated on the
instrument panel cluster.
Acadia 2007 A 10/3/06 3:07 PM Page 21

23
Tire Pressure Monitor
The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light on the instru
ment panel. The low tire pressurewarning light will remain on until youcorrect the tire pressure.
A CHECK TIRE PRESSURE message
may appear on the DIC.
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to the
proper tire inflation pressure. The Tire
and Loading Information label, located
on the center pillar below the driver’sdoor latch, shows the correct inflationpressure for the tires when they’re cold.“Cold” means your vehicle has beensitting for at least three hours or drivenno more than one mile.
You can temporarily remove the DIC
message by acknowledging it with yourDIC controls. However, at the next
vehicle startup, the DIC message will
reappear if the tire pressure has notbeen corrected.
You may notice during cooler conditions
that the low tire pressure warning lightwill appear when the vehicle is first
started and then turn off as you start todrive the vehicle. This could be an early
indicator that your tire pressures are getting low and need to be inflated to theproper pressure.
See Section 5 of your Owner Manual.
Note:The Tire Pressure Monitor can
alert you about low tire pressure, but itdoesn’t replace normal monthly tiremaintenance.
Resetting the Oil Life System
The Oil Life System calculates engine oil
life based on vehicle use and displays
CHANGE OIL SOON in the Driver
Information Center (DIC) when it’snecessary to change your engine oil and
filter. The Oil Life System should bereset to 100% only following an oilchange.
To reset the Oil Life System (without
DIC):
1. Turn on the ignition, with the engine
off.
2. Fully press and release the accelera
tor pedal slowly three times withinfive seconds.
3. Turn off the ignition.
To reset the Oil Life System (with DIC):
1. Turn on the ignition, with the engine
off.
2. Press the (Vehicle Information)
button until the DIC displays OILLIFE
REMAINING.
3. Press and hold the (Set/Reset)
button until 100% is displayed.
4. Turn off the ignition.
See Section 5 of your Owner Manual.
Acadia 2007 A 10/3/06 3:07 PM Page 23