low beam GREAT WALL FLORID 2008 User Guide

Downloaded from www.Manualslib.com manuals search engine GWFLORID Maintenance Manual180
Combination Meter
If something is wrong with the meter, check the relevant component and circuit according to the connector defi-
nition. If the failure still cannot be eliminated, check whether the instrument itself has malfunctioned in the fur-
ther steps. The following diagram shows the view of the meter connector and its numb\
er.
Pin definition of each combination meter
32-core connector
Pin No.FunctionPin No.Function
1Meter ground17Signal ground
2Speed signal input18Internal lighting (+)
3Vehicle speed signal input19Airbag indicator lamp
4Fuel gauge input20Door open warning lamp
5Water temperature gauge input21Seat belt unfastened indicator lamp
6Vehicle speed signal output22Battery
7Central door lock signal23Ignition
8Clock test24High beam ( - )
9Meter interior communication25High beam (+)
10Empty26Right turn signal lamp
11ABS failure indicator27Left turn signal lamp
12Engine failure indicator28Charging indicator
13Brake system failure indicator29Engine maintenance indicator
14Oil pressure indicator30EBD indicator
15Rear fog lamp indicator31O/D switch indicator
16Parking brake indicator32Front fog lamp indicator
12-core connector
Pin No.FunctionPin No.Function
1P position7Master lighting switch indicator
2R position8Rear deforster indicator
3N position9CAN H
4D position10CAN L
52nd gear11Oil/water separator indicator
61st gear12Diesel engine preheating indicator
12-core connector32-core connector

Downloaded from www.Manualslib.com manuals search engine GWFLORID Maintenance Manual260
2. Remove the nut and gasket.
Screw off the hexagon nut for flange face from the rear bum-
per left & right side central mounting bolt, and the rubber
cushion of the rear bumper left & right side central mounting
bracket.
3. Remove the expansion button connecting the left &
right side bracket below the rear bumper and vehicle
body.
4. Remove the bumper mounting bolt.
Screw off the rear bumper mounting bolt connecting the left
& right side above the rear bumper and vehicle body.
5. Pull the bumper out.
Pull the rear bumper out of the left & right side bracket of
the rear bumper, and make the central part of the rear bum-
per slide out along the rear bumper central mounting bracket
bolt.
6. Remove the three rear bumper plastic buffer anchor
from the rear impact beam.Rear bumper body
Rear bumper body
Rear bumper body
Rear bumper body
Rear bumper
Rear bumper plastic buffer anchor
Central left mounting bracket of the rear bumperRear mounting bracket LH of the rear bumper
Front mounting bracket LH of the rear bumper
Rear bumper central mounting bracket bolt
Rear bumper mounting bolt
Expansion button
Hexagon nut for flange face
Rubber cushion of the rear bumper central mounting bracket