hood release HONDA ELEMENT 2010 1.G Owners Manual

ꭧ: If equipped
POWER DOOR
LOCK SWITCH
(P. 80)
POWER WINDOW SWITCHES
(P. 92)
HOOD RELEASE HANDLE
(P. 200)
A/T model with navigation system is shown. AUTOMATIC TRANSMISSION (P. 219)
MANUAL TRANSMISSION (P. 217)
PARKING BRAKE
(P. 94) HEATING/COOLINGCONTROLS
(P. 104)
PASSENGER'S
FRONT AIRBAG
(P. 9, 25)
DRIVER'S FRONT
AIRBAG (P. 9, 25)
INSTRUMENT PANEL (P. 57)
GAUGES (P. 64)
MIRROR CONTROLS
(P. 93)
USB ADAPTER CABLE
ꭧ
(P. 164, 177)
CONTINUED
Your Vehicle at a Glance
3
Your Vehicle at a Glance

ꭧ: If equipped
VEHICLE STABILITY
ASSIST (VSA) OFF
SWITCH (P. 231)
PARKING BRAKE
(P. 94)
AUDIO SYSTEM
(P. 109)
HEATING/COOLING CONTROLS
(P. 104)
A/T model with navigation system is shown. POWER DOOR
LOCK SWITCH
(P. 80)
MIRROR CONTROLS
(P. 93)
POWER WINDOW
SWITCHES
(P. 92)
INSTRUMENT PANEL (P. 57)
HOOD RELEASE HANDLE
(P. 200)
GAUGES (P. 64)
USB ADAPTER CABLEꭧ
(P. 164, 177)
AUTOMATIC TRANSMISSION (P. 219)
MANUAL TRANSMISSION (P. 217)
Control Locations
56
Table of Contents

Opening and Closing the Hood
1. Park the vehicle, and set theparking brake. Pull the hood
release handle located under the
lower left corner of the dashboard.
The hood will pop up slightly.
2. Put your fingers under the frontedge of the hood near the center.
The hood latch handle is above the‘‘H ’’logo. Push this handle up to
release it. Lift up the hood.
If the hood latch handle moves
stiffly, or if you can open the hood
without lifting the handle, the
mechanism should be cleaned andlubricated.3. Pull the support rod out of its clip and insert the end into the
designated hole in the hood.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
HOOD RELEASE HANDLE
LATCH
SUPPORT ROD
CLIP
Service Station Procedures
200
Table of Contents