lock Hyundai Coupe 2003 Owners Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2003, Model line: Coupe, Model: Hyundai Coupe 2003Pages: 310, PDF Size: 2.87 MB
Page 288 of 310

OWNER MAINTENANCE 6-13
WARNING: Brake fluid is hygroscopic and should neverbe stored in an unsealed container. The pres-ence of water in the braking system will causevapour locks and increase the possibility ofbrake fade along with promoting corrosionwithin the braking system. The brake fluidmust be changed at the specified time ormileage interval to ensure continued safeoperation of the system. Brake fluid will causerapid and serious damage to paintwork. Ifaccidental spillage occurs, the affected areamust be rinsed with water immediately. Donot allow brake fluid to come into contactwith the eyes or to be ingested and ensurethat fluid is safely stored away form the reachof children. SG130A1-C CHECKING THE CLUTCH FLUID (Not all models)To Check the Clutch Fluid The clutch fluid level in the master cylinder should be checked when performing other under bonnetchecks. The system should be checked for leak-age at the same time.Ensure that the clutch fluid level is always be-tween the "MAX" and "MIN" level markings onthe fluid reservoir. Fill as required. Fluid lossindicates a leak in the clutch system whichshould be inspected and repaired immediately.
SG130B2-E Adding FluidRecommended brake fluid conforming to DOT 3 or DOT 4 should be used. The reservoir cap mustbe fully tightened to avoid contamination fromforeign matter or moisture. CAUTION: Brake fluid is hygroscopic and should neverbe stored in an unsealed container. Do notallow petroleum base fluid to contaminatethe brake fluid since damage to the rubberseals of the system may result. WARNING: Brake fluid will cause rapid and serious dam-age to paintwork. If accidental spillage oc-curs, the affected area must be rinsed withwater immediately. Do not allow brake fluidto come into contact with the eyes or to beingested and ensure that fluid is safely storedaway form the reach of children. SG140A1-E AIR CONDITIONING SYSTEMMAINTENANCE Condenser Ensure that the condenser is periodically in- spected and that accumulations of dirt, deadinsects and leaves etc, are removed to ensurethat the efficiency of the system is not impaired.Care must be exercised to ensure that the con-denser fins are not damaged during cleaning.
HGK215
HGK216-D
Page 298 of 310

OWNER MAINTENANCE 6-23
DESCRIPTION
IG COIL
AMP
B/UP LAMP
A/BAG IND A/BAG
HTD MIR
HAZARD
R/WIPER
TAIL-RH
F/WIPER A/C SW
RR DEFOG STOP
TAIL-LH
A/CON ECU
CLUSTER
ROOM LP
P/WINDOW T/GATE IGN
RR FOG
C/LIGHT S/ROOF
S/HTR ABS
AUDIO
G200D01GK-GAT Inner Panel
HGK204-E
PROTECTED COMPONENTS
Ignition Coil, ECM
AMP. Multi Gauge Unit B/Up Lamp Air Bag Indicator Air Bag Outside Mirror Defroster Hazard Warning LightRear Window WiperTaillightFront Window WiperA/ConditionerRear Window Defroster Stop Light Tail lightA/ConditionerECM, Multi Gauge Unit, TCMClusterMap Light, Clock, Audio Power Window Hatchback door OpenA/Con, A.Q.S Sensor Rear Fog C/Lighter, Outside MirrorSunroof Seat Warmer ABS. TCS Audio, Clock
FUSERATING
20A20A 10A 10A 15A10A 10A 15A10A20A10A30A15A 10A 10A10A10A 10A 30A 15A10A 10A 15A15A20A 10A 10A
Page 300 of 310

EMISSION CONTROL SYSTEM
7-2
hicle operator in order to prevent operational problems arising from damage to the catalyst.Damage to the catalyst will result if contamina-tion occurs through the use of leaded fuel. Whilstthe vehicle is fitted with a reduced diameter fillerneck to prevent charging of the fuel tank with aleaded fuel pump nozzle, it is possible that theuse of funnels or jerry cans will permit leaded fuelto be introduced into the fuel tank.The catalyst is intolerant of unburnt fuel andtherefore if an engine misfire condition exists,damage to the catalyst will occur. It is imperativethat if a misfire condition develops, the vehicle isimmediately presented to a Hyundai dealer forrectification. Similarly, the practice of certainignition system diagnosis procedures which in-volve inducing a misfire (cylinder power balancetests for example) may result in catalyst dam-age.For these reasons, it is advisable that the ex-haust gas emission be tested at each routineservice with a gas analyzer having a Hydrocar-bon measuring facility to ensure continued reli-ability of the catalyst.Push or tow starting of the vehicle is to beavoided since unburnt fuel may be enter thecatalyst and result in damage. (Note, it is impos-sible to push or tow start a Hyundai modelequipped with fuel injection since the fuel pumpsafety interlock will prevent the pump from oper-ating under these conditions).Operation of the catalyst involves extremely hightemperatures being attained within the catalyticconvertor, and although the convertor is fitted
with heat shields, it is important that the vehicleis not parked over combustible or volatile mate-rial which may result in fire.If the above precautions are not adhered to andthe catalyst becomes inoperative, the resultantincrease in core temperature will result in a "meltdown" where the catalyst core will melt andsubsequently may block the exhaust system.Due to the fragile nature of the catalyst element,it is important that damage does not occur whenthe vehicle is raised by means of a garage jack.Care must also be exercised to avoid drivingover road hazards or debris which may causedamage to the catalyst element.
Page 301 of 310

CONSUMER INFORMATION 8-1
SI010B1-E Engine Number
SI010A1-E VEHICLE IDENTIFICATION NUMBER (VIN)
SI000A1-E
8. CONSUMER
INFORMATION
The vehicle identification number (VIN) is unique to each individual vehicle and is the number(sometimes referred to as chassis number) usedupon the vehicle registration document to iden-tify the vehicle.The VIN will be found stamped upon a plateattached to the engine bulkhead. The engine number is stamped on the engineblock as shown in the drawing. I030A01GK-EAT TYRE PRESSURES In modern high-speed motoring, correct tyre pressures are vitally important. Incorrect tyrepressures can affect vehicle safety by causingreduced adhesion, steering response and tyrefailure through overheating. The tyre pressuremust only be checked when the tyres are cold.The correct tyre pressures are indicated on thelabel affixed to the drivers door pillar and below. Tyre pressures should be increased by 3 psi when the vehicle is driven fully laden or underconditions of sustained high speed motoring. SI030A2-E SNOW TYRES If it is desired to fit snow tyres to the vehicle, it must be ascertained that the original size andload carrying capacity are met by the replace-ment tyres. When using snow tyres, the vehicleshould not be driven at speeds in excess of 60MPH.
8
I010B01GK
HGK220
HGK092-D
DOHC
V6
6.0Jx15 6.5Jx167.0Jx174Tx16 TIRE
SIZE
RIM
SIZE PRESSURE, kPa (PSI)
195/65R15205/55R16215/45R17
T125/70R16 REAR
210(30)210(30)210(30)420(60) FRONT
210(30)230(33)240(35)420(60)
UP TO 2
PERSONS UP TO
MAX. LOAD
REAR
210(30)230(33)230(33)420(60)
FRONT210(30)210(30)220(32)420(60)
Page 307 of 310

INDEX10-1
C CARE OF CAS
SETTE TAPE ........................................................... 1-65
CARE OF DISC ................................................................................ 1-65
CARE OF SEAT BELTS .................................................................. 1-12
CATALYTIC CONVERTOR OPERATING PRECAUTIONS .......7-1~7-2
CENTRAL DOOR LOCK .................................................................... 1-4
CHANGING A FLAT TYPE ................................................................ 3-3
CHECKING THE CLUTCH FLUID ................................................... 6-13
CHILD RESTRAINT SYSTEM ......................................................... 1-14
CIGAR LIGHTER .............................................................................. 1-37
CLUTCH PEDAL FREEPLAY .......................................................... 6-15
COMBINATION IGNITION SWITCH AND STEERING LOCK .......... 2-2
CRUISE CONTROL ......................................................................... 1-49
D DAILY OPERATING CHECKS ........................................................... 6-4
DEFROSTING/DEFOGGING ........................................................... 1-55
DIGITAL CLOCK .............................................................................. 1-37
DOOR LOCKS .................................................................................... 1-2 DOOR WINDOWS .............................................................................. 1-6
DRINK HOLDER .............................................................................. 1-38
DRIVE BELTS .................................................................................. 6-16
DRIVING FOR ECONOMY .............................................................. 2-10
JK000A2-EAT 10. INDEX
A AIR BAG ........................................................................................... 1-19
AIR CONDITIONING SWITCH ......................................................... 1-56
AIR CONDITIONING SYSTEM MAINTENANCE ............................6-13
AIR CLEANER ELEMENT REPLACEMENT ..................................... 6-9
AIR CONDITIONER FILTER ............................................................ 1-62
ANTENNA ......................................................................................... 1-67
ANTI-LOCK BRAKE SYSTEM ........................................................... 2-8
AUTOMATIC TRANSMISSION FLUID ............................................. 6-11
AUTOMATIC TRANSMISSION .......................................................... 2-5
BBATTERY MAINTENANCE .............................................................. 6-17
BEFORE FOLDING THE REAR SEATS ......................................... 1-10
BEFORE STARTING THE ENGINE .................................................. 2-2
BONNET RELEASE ......................................................................... 1-45
BRAKE PEDAL FREEPLAY ............................................................. 6-16
BRAKE SYSTEM CHECKING ......................................................... 6-12
10