atf capacity Hyundai H-1 (Grand Starex) 2003 Owner's Manual

IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
4-15
E120A01P-GATFUSES
FUSES FUSES
FUSES
FUSES
HSR4021
To prevent damage to the electrical system due to short-circuiting or overloading, each individ-ual current circuit is provided with a fuse. The fuse housing is located under the dash- board on the driver's side. E120B01P-GAT Fuse load capacity
Fuse load capacity Fuse load capacity
Fuse load capacity
Fuse load capacity
The fuse housing cover lists the names of the electrical systems and the fuse capacities. E120C01P-GAT
Spare fuse
Spare fuse Spare fuse
Spare fuse
Spare fuse
Spare fuses are contained in the fuse housing. Always use a fuse of the same capacity forreplacement.
GS40360A
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
(1)(1)
(1)(1)
(1) Do not allow the jumper cable clips to
Do not allow the jumper cable clips to Do not allow the jumper cable clips to
Do not allow the jumper cable clips to
Do not allow the jumper cable clips to
touch one another.
touch one another. touch one another.
touch one another.
touch one another.
(2)(2)
(2)(2)
(2) Do not connect the jumper cable to the
Do not connect the jumper cable to the Do not connect the jumper cable to the
Do not connect the jumper cable to the
Do not connect the jumper cable to the
negative terminal of the flat battery.
negative terminal of the flat battery. negative terminal of the flat battery.
negative terminal of the flat battery.
negative terminal of the flat battery.
The battery generates explosive gas, and
The battery generates explosive gas, and The battery generates explosive gas, and
The battery generates explosive gas, and
The battery generates explosive gas, and
a spark caused when the jumper cable is
a spark caused when the jumper cable is a spark caused when the jumper cable is
a spark caused when the jumper cable is
a spark caused when the jumper cable is
disconnected from the negative terminal
disconnected from the negative terminal disconnected from the negative terminal
disconnected from the negative terminal
disconnected from the negative terminal
could ignite this gas and cause an explo-
could ignite this gas and cause an explo- could ignite this gas and cause an explo-
could ignite this gas and cause an explo-
could ignite this gas and cause an explo-
sion.
sion. sion.
sion.
sion.
(3)(3)
(3)(3)
(3)
Be careful that the jumper cable becomes
Be careful that the jumper cable becomes Be careful that the jumper cable becomes
Be careful that the jumper cable becomes
Be careful that the jumper cable becomes
not caught in the cooling fan, etc.
not caught in the cooling fan, etc. not caught in the cooling fan, etc.
not caught in the cooling fan, etc.
not caught in the cooling fan, etc.
8. Start engine as described in "Starting the engine".
9. After the engine is started, disconnect the cables in the reverse order. E120D01P-GAT
Changing a fuse
Changing a fuse Changing a fuse
Changing a fuse
Changing a fuseGS40380A
Good
Blown
1. Before replacing a fuse, be sure to turn off the electrical item concerned.
2. Remove the fuse housing cover.
3. Referring to the fuse load capacity table, check the fuse pertaining to the problem.
4. If the fuse is blown, pull it straight out. If it is not blown, something else must be causing the problem; contact an authorizedHYUNDAI dealer to have the problemchecked.
5. Insert a new fuse of the same capacity securely into the clip.
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
(1)(1)
(1)(1)
(1) If the newly inserted fuse blows again
If the newly inserted fuse blows again If the newly inserted fuse blows again
If the newly inserted fuse blows again
If the newly inserted fuse blows again
after a short time, the cause should be
after a short time, the cause should be after a short time, the cause should be
after a short time, the cause should be
after a short time, the cause should be
diagnosed and corrected by an autho-
diagnosed and corrected by an autho- diagnosed and corrected by an autho-
diagnosed and corrected by an autho-
diagnosed and corrected by an autho-
rized HYUNDAI dealer.
rized HYUNDAI dealer. rized HYUNDAI dealer.
rized HYUNDAI dealer.
rized HYUNDAI dealer.

8-11
CONSUMER INFORMATION
CONSUMER INFORMATION CONSUMER INFORMATION
CONSUMER INFORMATION
CONSUMER INFORMATION
I120D02P-GAT To Check the
To Check the To Check the
To Check the
To Check the T ransmission
Fluid Level
Fluid Level Fluid Level
Fluid Level
Fluid Level
D060A01P-GAG
Button
Park the vehicle on level ground with the park-
ing brake engaged. When the transmission fluid level is checked, the transmission fluidshould be at normal operating temperature andthe engine idling.
While the engine is idling, apply the brakes and
move the gear selector lever from "P" to eachof its other positions-"R", "N", "D", "2", "L"-andthen return to "N" or "P" with the engine stillidling:
I120D02P-GAG
Full mark Good
1. Open the hood, being careful to keep hands, long hair and clothing clear of any moving parts.
2. Remove the transmission dipstick, wipe it clean, reinsert the dipstick as far as it will go, then remove it again. Now check thefluid level on the dipstick. It should be in the"HOT" range on the dipstick.
3. If the transmission fluid level is low, use a funnel to add transmission fluid through thedipstick tube until the level reaches the"HOT" range. Do not overfill, otherwise thetransmission could be damaged.
WARNING:
WARNING: WARNING:
WARNING:
WARNING:
The radiator fan is controlled by engine
The radiator fan is controlled by engine The radiator fan is controlled by engine
The radiator fan is controlled by engine
The radiator fan is controlled by engine
coolant temperature and may sometimes
coolant temperature and may sometimes coolant temperature and may sometimes
coolant temperature and may sometimes
coolant temperature and may sometimes
operate even after the ignition key has even
operate even after the ignition key has even operate even after the ignition key has even
operate even after the ignition key has even
operate even after the ignition key has even
turned off. Use extreme caution when work-
turned off. Use extreme caution when work- turned off. Use extreme caution when work-
turned off. Use extreme caution when work-
turned off. Use extreme caution when work-
ing near the blades of the cooling fan, so
ing near the blades of the cooling fan, so ing near the blades of the cooling fan, so
ing near the blades of the cooling fan, so
ing near the blades of the cooling fan, so
that you are not injured by a rotating fan
that you are not injured by a rotating fan that you are not injured by a rotating fan
that you are not injured by a rotating fan
that you are not injured by a rotating fan
blade. As the coolant temperature decreases,
blade. As the coolant temperature decreases, blade. As the coolant temperature decreases,
blade. As the coolant temperature decreases,
blade. As the coolant temperature decreases,
I120A01P-GAT
CHECKING THE AUTOMATIC
CHECKING THE AUTOMATIC CHECKING THE AUTOMATIC
CHECKING THE AUTOMATIC
CHECKING THE AUTOMATIC
TRANSMISSION FLUID (If installed)
TRANSMISSION FLUID (If installed) TRANSMISSION FLUID (If installed)
TRANSMISSION FLUID (If installed)
TRANSMISSION FLUID (If installed)
Transmission fluid in the automatic transmis-
sion should be changed at those intervals speci-fied in the vehicle maintenance schedule inSection 6.
I120B01P-GATRecommended Fluid
Recommended Fluid Recommended Fluid
Recommended Fluid
Recommended Fluid
Your Hyundai automatic transmission is specially
designed to operate with " DIAMOND ATF
DEXRON II" or "DIAMOND ATF SP I" type
fluid.
I120C02P-GATAA
AA
A
utomatic
utomatic utomatic
utomatic
utomatic transmission
fluid capacity
fluid capacity fluid capacity
fluid capacity
fluid capacity
The fluid capacity of the automatic transmis-
sion will be found on page 9-4.
WARNING:
WARNING: WARNING:
WARNING:
WARNING:
The transmission fluid level should be
The transmission fluid level should be The transmission fluid level should be
The transmission fluid level should be
The transmission fluid level should be checked when the engine is at normal oper-
checked when the engine is at normal oper- checked when the engine is at normal oper-
checked when the engine is at normal oper-
checked when the engine is at normal oper-
ating temperature. This means that the en-
ating temperature. This means that the en- ating temperature. This means that the en-
ating temperature. This means that the en-
ating temperature. This means that the en-
gine, radiator, exhaust system etc., are very
gine, radiator, exhaust system etc., are very gine, radiator, exhaust system etc., are very
gine, radiator, exhaust system etc., are very
gine, radiator, exhaust system etc., are very
hot. Exercise great care not to burn yourself
hot. Exercise great care not to burn yourself hot. Exercise great care not to burn yourself
hot. Exercise great care not to burn yourself
hot. Exercise great care not to burn yourself
during this procedure.
during this procedure. during this procedure.
during this procedure.
during this procedure.