WW-40
< SERVICE INFORMATION >
REAR WIPER AND WASHER SYSTEM
Only Rear Wiper ON Does Not Operate
INFOID:0000000001328585
Refer to LT-104, "Combination Switch Inspection".
Only Rear Wiper IN T Does Not OperateINFOID:0000000001328586
Refer to LT-104, "Combination Switch Inspection".
Wiper Does Not Wipe When Rear Washer OperatesINFOID:0000000001328587
Refer to LT-104, "Combination Switch Inspection".
Rear Wipers Do Not StopINFOID:0000000001328588
1.CHECK CIRCUIT BETWEEN COMB INATION SWITCH AND BCM
With CONSULT-III
1. Select “RR WIPER INT”, “RR WIPER ON”, and “RR WASHER SW” of BCM data monitor item.
2. With operating the wiper switch, check the monitor status.
Without CONSULT-III
Refer to LT-104, "
Combination Switch Inspection".
OK or NG
OK >> Replace BCM. Refer to BCS-13, "Removal and Installation of BCM".
NG >> Check combination switch (wiper switch). Refer to LT-104, "
Combination Switch Inspection".
Removal and Installation of Rear Wiper Arm, Adjustment of Wiper Arms Stop Location
INFOID:0000000001328589
REMOVAL
1. Turn rear wiper switch ON to operate wiper moto r, then turn rear wiper switch OFF (auto stop).
2. Remove rear wiper arm cap, and remove rear wiper arm nut.
3. Remove rear wiper arm from the vehicle.
INSTALLATION
1. Clean up the pivot area as shown in the figure. This will reduce possibility of rear wiper arm nuts looseness.
2. Prior to rear wiper arms installation, turn rear wiper switch ON to operate wiper motor, and then turn rear wiper switch OFF (auto
stop).
SKIA0082J
3AA93ABC3ACD3AC03ACA3AC03AC63AC53A913A773A893A873A873A8E3A773A983AC73AC93AC03AC3
3A893A873A873A8F3A773A9D3AAF3A8A3A8C3A863A9D3AAF3A8B3A8C
