clock setting JAGUAR XF 2009 1.G Lighting In Detail Manual

ItemDescription Headlamp leveling rotary thumbwheel (halogen headlamps only)
Instrument panel illumination dimmer thumbwheel
Luggage compartment lid release switch
Forward alert switch (if fitted)
Rear fog lamp switch
The auxiliary lighting switch is located in the instrument panel, adjacent to the steering column. The switch has a rear fog lamp switch and a rotary thumbwheel to adjust headlamp
leveling on vehicles with halogen headlamps. The auxiliary lighting switch also has a forward alert switch (if fitted) and a rotary thumbwheel for instrument panel illumination dimming.
The rear fog lamp switch is a non-latching switch which provides a momentary signal to the instrument cluster. The fog lamps can only be activated if the ignition is in power mode 6 and
the headlamp or auto headlamps are selected on. If the fog lamp switch is pressed when the fog lamps are operating, they will be switched off. If the lighting control switch is moved to
the side lamp or off position or if the auto headlamps turns off the headlamps the rear fog lamps will be extinguished. If the headlamps are subsequently turned on the rear fog lamp
operation will not be active and the rear fog lamp switch must be pressed to activate the lamps.
HEADLAMP ASSEMBLY
Two types of headlamp are available; xenon or halogen. The headlamp is secured in the front of the vehicle with three bolts; one outboard bolt is screwed into the front upper cross
member, one inboard bolt in the front upper body gusset and one bolt located at the rear of the headlamp assembly which locates in the front fender reinforcing panel. Bulb replacement
requires the removal of the 3 bolts and the headlamp assembly.
The rear of the headlamp has removable panels which allow access to the bulbs for replacement. A large cover can be rotated counter-clockwise for removal allows access the headlamp
low beam halogen or xenon D1S bulb. Another large removable cover can be rotated for removal to provide access to the high beam bulb, side lamp bulb and cornering/static bending
lamp bulb (if fitted).
The headlamps have 2 adjustment screws on the rear which allow for the manual setting of the vertical and horizontal alignment.
On NAS vehicles, the headlamp is regarded as 'Visual Optically Left' aiming. The adjustment screws must be turned equal amounts to maintain the correlation in the vertical axis only.
There is no horizontal adjustment. Refer to the Service Repair Procedures manual for headlamp alignment data and procedures.
Each headlamp has an integral 16 pin connector which provides inputs and outputs for the various functions of the headlamp assembly.
1
2
3
4
5
Page 7 of 12
6/25/2011 https://connect.jlrext.com/topix/service/procedure/144261/ODYSSEY/G970541/,DanaI...