sensor JAGUAR XF 2009 1.G Quick Start Guide

Exterior lamps\bTrip computer
Move the lever up or down to operate the direction
indicators, forward for high beam and backwards for
high beam flash. A brief push up or down will flash
the indicators three times.Rotate the collar to the first position to select
side lamps.
Second position is headlamps.
Next position is Autolamps. Sensor
controlled to switch side lamps and low
beam headlamps on or off as appropriate.
Autolamps combined with exit delay.
Headlamps can remain on to illuminate the
immediate vicinity for a set period after
leaving the vehicle. There are three time
setting positions. Press the button on the end of the lever to
cycle through the trip computer displays in
the message centre. 1. Front screen wash/wipe.
2. Rain sensor activated wipe.
\f. Slow speed.
4. Fast speed.
5. Controls sensitivity of the rain sensor. With
position 2selected, rotate the collar upwards to
reduce sensitivity and increase the wiper delay.
4
3
2
1
5
Wipers and washers
Autolamps
If AUTO mode is selected and the front screen
wipers are operated for more than 20 seconds, the
exterior lamps will be switched ON automatically.
8
Electric parking brake
• Apply manually when stationary in Park,Drive or
Reverse by pulling up the parking brake switch.
• Can be manually released when the engine is running and the foot brake is applied.
Press the parking brake switch down to release
and pull it up to apply.
• If manually applied whilst in Drive orReverse, the
parking brake will automatically release when the
accelerator is applied.
ASL
P
DSC
Operating note
The brake must be manually applied when parking.
Driving
Do NOT use the recess in the electric parking brake
as a storage area.

Parking aids
Care points
Sensors may activate when water, snow or ice are
detected on the surface of the sensors. Regular
cleaning will restore normal performance.
HomHommParking aid alert
Press theASL
button, then use
the cruise control
thumbwheel to set
the required
maximum speed
limit.
Automatic Speed Limiter (ASL)
DSC
ASL
Blind Spot Monitor
Blind Spot Monitor is activated when the vehicle is
travelling at greater than \f6 km/h (\f0 mph). It will
indicate to the driver when an overtaking vehicle is
within your vehicle’s blind spot areas.
If a vehicle is occupying a blind spot, a warning
graphic in the respective door mirror lens will
illuminate.
An amber dot in the mirror lens indicates that the
system is not functioning.
When Ris selected, the rear and front parking aids
and rear view camera will activate.
The touch\bscreen will display a vehicle graphic and
indicate the approximate distance to any object
detected. An audible alert will increase in frequency
as the object is approached.
Audible alert volume can be changed via the touch\b
screen. From the Homescreen, select Vehicle, then
Veh. settings, then Parking.
When moving forward into a space, activate the front
sensors with the parking aid switch. Alternatively, first
select Reverse then Drive.
Parking aid switch
The overhead console switch
can disable or enable the
front and rear parking aids.
An LED in the switch
illuminates when the system is on. Press the button
to turn the parking aids off or on.
The parking aids will disable when vehicle speed
exceeds \f5 km/h (9 mph) in D.
Rear view camera option
Is activated when Ris selected. A wide\bangle camera
image with guidance lines appears on the touch
screen to aid reversing.
The camera image is deactivated when Dis selected
and vehicle speed exceeds \f6 km/h (\f0 mph).
The set speed will display in the message centre.
The vehicle will not accelerate beyond the set speed
unless the accelerator pedal is fully depressed.
Cruise control cannot be operated while ASLis
engaged.
11
Cancelling the parking aid screen
Touch the screen within the pop\bup area to return to
the previous view.