warning JAGUAR XF 2009 1.G Quick Start Guide

Entering the vehicle
With keyless entry, operation of a locked door handle
or pressing the luggage compartment release button
will allow access if the Jaguar
Smart Key is within one
metre (39 inches) of
that entry point.
The Jaguar Smart Key
buttons do not need to be
pressed and it can be concealed in clothing or even
carried in a non metallic carrier.
The Jaguar Smart Key buttons can still be used to
unlock the vehicle.
Vehicle access\bEngine starting
Keyless entry
Leaving the vehicle
The vehicle WILL NOT automatically lock or arm
the alarm.
To lock and alarm the vehicle with a keyless
action the Jaguar Smart Key must be outside
the vehicle.
Press the door handle button once to single\b
lock. Press twice within three seconds to
double\block.
Alternatively, use the Jaguar Smart Key.
To check security, pull the door handle within
three seconds of locking.
Unlocking mode alternatives
Singlepoint entryallows only the driver’s door
to unlock with a single press. A second press
unlocks all other doors and luggage area.
Multipoint entry will unlock all of the doors
and luggage area with a single press.
To change between modes, with the vehicle
unlocked, press the lock and unlock buttons
simultaneously for three seconds. The hazard
warning lamps will flash twice to confirm the
change.
• Press once to lock the vehicle and arm the alarm.
• Press twice to double lock the vehicle.
• Press and hold to close any open windows and sunroof and lock all doors
(Global closing).
• Multi\bpoint entry \b Press once to disarm the alarm, unlock the doors and unlock
the luggage compartment.
• Press and hold to unlock all doors and open the windows and sunroof (Global
opening).
• Press once to switch the headlamps on for 25 seconds. Press again to
switch off.
• Press to disarm the alarm, unlock and open the luggage compartment.
• Press and hold for three seconds to activate/cancel the panic alarm.
1. Emergency key blade release button.
2. Emergency key blade.
Note: See the Owner’s Handbook for use.
2
Jaguar Smart Key

Driving position memory
Seat belts
Ensure that passengers do not fully extend the
restraints and inadvertently engage the ALR feature
during normal use.A warning indicator on the instrument
pack will illuminate if a front seat belt is
unbuckled.
Automatic Locking Reels (ALR)
All passenger seat belts have ALR fitted primarily for
use with child seats but also for securing large items.
Refer to Child safety in the Owner’s Handbook for
further details.
Glovebox and valet mode
To set your personal security code:
• On the touch\bscreen select HomethenVehicle
followed by Veh. settings.
• Now select Valet mode.
• Enter a four digit code and touch OK.Valet on is
displayed as a confirmation.
To deselect valet mode
Access the Valet mode screen and enter your
personal four digit code. Now press OK.Valet off is
displayed and the glovebox and luggage
compartment are now accessible.
Insert the emergency key blade back into the Jaguar
Smart Key.
Driver's seat
When you have found your ideal driving position, the
vehicle can memorise seat, steering column and
mirror settings for future use.
1. Press the SETbutton located in the driver’s
door storage area. The red LED will
illuminate for a five second period.
2. While the LED is illuminated, press button 1
or 2to memorise the current settings.
The LED will extinguish and a chime will sound to
confirm that the settings have been memorised. If the
ignition is on, the message centre will display a
confirmation message.
Operating note
A seat position will only be memorised during the
five second period that the LED is illuminated.
An existing memory setting can be over\bwritten with
a new memory position.
Recalling a seat position
Press and hold button 1or 2until
the seat has finished moving.
5
To open the glovebox, place a finger directly onto the
icon.
Valet mode
The glovebox and luggage compartment can be
security locked to deny access to a parking
attendant. Before handing over your Jaguar Smart
Key, remove the emergency key blade and keep it in
a safe place.

Facia
11.Luggage compartment release.
12. Forward alert.
1\f. Rear fog lamps.
14. Horn.
15. Column adjust switch.
16. Climate control system.
17. Engine start/stop button.
18. DSC (Dynamic Stability Control)
switch.
19. ASL (Automatic Speed Limiter)
switch.
20. EPB (Electric Parking Brake).
1.
Master locking switches.
2. Hazard warning switch.
\f. Touch screen.
4. Home screen
5. Touch screen on/off
6. Direction indicators and exterior
lighting.
7. Audio and telephone switches.
8. Instrument pack, message
centre and warning indicators.
9. Cruise control switches.
10. Windscreen wiper and washer. 21.
Dynamic mode switch.
22. Winter mode switch.
2\f. JaguarDrive selector.
24. Audio system.
25. Mirror adjuster.
26. Mirror selector switches.
27. Window switch isolator.
28. Window switches.
S ART
S OP S
D C
13678910
11
13
1415
18
17
1624
12
2
22
23
19
20
21
26
25
28
27
45
7
Warning lamps
Low tyre pressure
Airbag fault
Fog lamps on
DSC off, Trac DSC ON
or DSC fault. Flashing \b
DSC operating.Seat belt reminder
ASL active
Forward alert active
EPB on, braking system
fault or brake fluid low
ABS fault or EPB fault
Adaptive Cruise Control
active
Engine malfunction

JaguarDrive Selector
Gearshift interlockThe brake pedal must be
depressed before the
selector can be moved
from thePark position.
Maintain brake pressure
until a gear is selected.
Select Pbefore
switching off the engine.
However, if the engine is
switched off with
Reverse, Drive orSport
selected, the selector will
automatically return to P
while retracting.
Sport mode
To select Sfrom D, press down and rotate the
selector. Automatic gear changing continues but the
gearshift points are modified for full use of the
engine's power.
Manual gear changes
The steering wheel paddles allow manual gear
changing with either Dor Sselected.
• To shift down, briefly pull the paddle.
• To shift up, briefly pull the +paddle.
When the paddles are used in D, gear selection will
revert to automatic if use of the paddles is not
maintained. With Sselected, continuous manual
operation is initiated if the paddles are used.
P R N D S
STARTENGINESTOP
DSC
If the engine is switched off with Neutral selected,
automatic selection of Pis delayed for \f0 minutes.
DO NOT use this feature during vehicle recovery.
JaguarDrive Control
Allows the driver to fine tune the vehicle driving
characteristics. Select from the following driving
modes.
NOTE: Winter and Dynamic modes cannot be active
simultaneously.
Winter mode
Use in slippery conditions. When active, this
mode selects 2nd gear for driving away, it moderates
engine response and modifies the gear change
strategy. This ensures that maximum possible traction
is achieved. It remains active until deselected.
Dynamic mode
Optimises vehicle systems to deliver a more
involved driving experience. It remains selected for
six hours after the ignition is switched off.
Dynamic Stability Control (DSC)
DSC ON is the default condition at engine start.
TracDSC is an alternative setting of DSC with
reduced system interventions and is for use only on
dry tarmac surfaces. Press and release the button.
TracDSC will be displayed in the message centre.
Press again to reactivate DSC.
To switch DSC off, press and hold for ten seconds
until DSC OFF is displayed.
Message centre
The message centre displays the JaguarDrive
Selector position, P,R,N,DorS, the manual mode
gear selections 1to 6and the
JaguarDrive Control mode
selection.
When TracDSC is selected, the
DSC warning lamp will illuminate
and the message centre will briefly
display TracDSC.
When DSC OFF is selected, the DSC warning lamp
will illuminate and the message centre will display
DSC OFF until DSC is reinstated.
Driving mode settings
Refer to the Owner’s Handbook section, Driving
dynamics, for suggested mode settings.
Dynamic mode ,TracDSC andDSC OFF will
change the driving characteristics. Select these
only when suitable driving conditions exist.
9
In both Dand Smodes, automatic operation can be
reinstated by holding the +paddle for two seconds.

Cruise (speed) Control and ACC1. SET \b use to set the road speed to be
maintained or increase/decrease the speed
in 2 km/h (\f mph) steps when cruise
control is operating.
2. RESUME \b use to resume a set speed
retained in memory.
\f. CANCEL \b cancels cruise control but
retains the set speed in memory.
ACC only
ACC utilises a radar at the front of the vehicle to
maintain a pre\bdefined gap to the vehicle ahead.
When a slower vehicle ahead is encountered, or a
vehicle ahead enters the same lane, the previously
set cruise control road speed will be adjusted
automatically to maintain the set gap.
Cruise control will automatically disengage when
the foot brake is pressed or when vehicle speed
falls below 30 km/h (\f8 mph).
Depending on specification, your vehicle will be fitted
with either the standard cruise control system or the
Adaptive \fruise \fontrol system (A\f\f). Both systems
allow you to maintain a set speed until either cruise
control is cancelled or the brake pedal is used. A\f\f
also allows you to maintain a gap between yourself
and the vehicle ahead when the speed of that vehicle
is not greater than yours. Both systems are controlled
via switches on the steering wheel.
Driving
2
1
5
3
4
ACC
IS NOT a collision warning or avoidance
system. Additionally the system WILL NOTdetect:
• Stationary or slow moving vehicles below \f0 km/h (6 mph).
• Pedestrians or objects in the roadway.
• Oncoming vehicles in the same lane.
10
A warning lamp will illuminate to indicate
that the vehicle is in follow mode.
4. GAP SETTING \b use to increase/decrease the
time gap to the vehicle ahead. The gap can be set
to one of four pre\bdefined settings (\f to 4
chevrons).
The current setting will
be displayed in the
message centre.
Forward Alert
This is a feature of ACC and it provides limited
detection of objects in the road ahead. When
necessary it will give an audible warning and a visual
warning in the message centre. The driver must take
appropriate action.5. Press to activate the Forward Alert function.
The Forward Alert icon will illuminate in the
instrument panel.
Sensitivity of detection can be adjusted. With ACC
disengaged, usethe GAP SETTINGcontrol4to
adjust the setting.
Cruise (speed) control and Adaptive Cruise control

Parking aids
Care points
Sensors may activate when water, snow or ice are
detected on the surface of the sensors. Regular
cleaning will restore normal performance.
HomHommParking aid alert
Press theASL
button, then use
the cruise control
thumbwheel to set
the required
maximum speed
limit.
Automatic Speed Limiter (ASL)
DSC
ASL
Blind Spot Monitor
Blind Spot Monitor is activated when the vehicle is
travelling at greater than \f6 km/h (\f0 mph). It will
indicate to the driver when an overtaking vehicle is
within your vehicle’s blind spot areas.
If a vehicle is occupying a blind spot, a warning
graphic in the respective door mirror lens will
illuminate.
An amber dot in the mirror lens indicates that the
system is not functioning.
When Ris selected, the rear and front parking aids
and rear view camera will activate.
The touch\bscreen will display a vehicle graphic and
indicate the approximate distance to any object
detected. An audible alert will increase in frequency
as the object is approached.
Audible alert volume can be changed via the touch\b
screen. From the Homescreen, select Vehicle, then
Veh. settings, then Parking.
When moving forward into a space, activate the front
sensors with the parking aid switch. Alternatively, first
select Reverse then Drive.
Parking aid switch
The overhead console switch
can disable or enable the
front and rear parking aids.
An LED in the switch
illuminates when the system is on. Press the button
to turn the parking aids off or on.
The parking aids will disable when vehicle speed
exceeds \f5 km/h (9 mph) in D.
Rear view camera option
Is activated when Ris selected. A wide\bangle camera
image with guidance lines appears on the touch
screen to aid reversing.
The camera image is deactivated when Dis selected
and vehicle speed exceeds \f6 km/h (\f0 mph).
The set speed will display in the message centre.
The vehicle will not accelerate beyond the set speed
unless the accelerator pedal is fully depressed.
Cruise control cannot be operated while ASLis
engaged.
11
Cancelling the parking aid screen
Touch the screen within the pop\bup area to return to
the previous view.