roof JAGUAR XJ6 1994 2.G Owner's Guide

Security System - RESTRICTED /SSUE 84
-
Uo feature
A5.5 HOW TO OPERATE THE SYSTEM
Deadlock all doors, lock
trunk lid and fuel filler cap.
Arm the alarm system
(perimeter, inclination and
intrusion). Close open win
-
dows and sliding roof.
Once deadlocking is com
-
pleted, the sounder gives
one audible tone.
Note:
No deadlock feature in Ja- panese market.
Locking, unlocking and setting the vehicle alarm system is carried out by key or by radio frequency key-ring trans- mitter.
Unlock
all other doors and
trunk lid.
- Operation of the system by key or key-ring transmitter will be described separately in this sub-section.
Key-ring transmitter functions vary slightly between market variants. The action for each variant is described separate- ly where appropriate
m: Certain functions differ due to market variations. Differences will be detailed in the the following instruction
tables. The variants are defined as follows:
No feature
A
0 Variant 1 - European and UK markets
0 Variant 2 - North American markets
0 Variant 3 - Rest of the World.
,5. 1 Locking (key)
Instruction
rurn key to lock position
and release.
rurn key to lock position,
?old for 2 seconds and re-
ease.
rurn key to unlock position
and then to lock position
Nithin 3 seconds. Hold in
ock position for
2 seconds :o close windows and slid-
ng roof.
A5.5.2 Unlocking (key)
Instruction
Turn key to unlock position
and release.
rurn key to unlock position
and hold for
2 seconds.
Variant 1
Lock all doors, trunk lid,
fuel filler cap and arm the
alarm system (perimeter
only).
Lock
all doors, trunk lid,
fuel filler cap. Arm the
alarm system (perimeter
only). Close open windows
and sliding roof.
Deadlock
all doors, lock
trunk lid and fuel filler cap.
Arm the alarm system
(perimeter, inclination and
intrusion). Close open win
-
dows and sliding roof.
Once deadlocking is com
- pleted, the sounder gives
one audible tone.
Variant 1
Unlock all doors, trunk lid,
fuel filler cap.
On variant
1 unlocking
with the key does not dis
- arm the alarm system. An
audible ticking indicates
that the alarm will activate
after 30 seconds unless
the key is turned to posi-
tion II in the ignition or the
key-ring transmitter but-
ton (small) is pressed.
No feature
rlariant 2
-ock all doors, trunk lid,
'uel filler cap and arm the alarm system.
Variant 3
Lock all doors, trunk lid,
fuel filler cap and arm the
alarm system (perimeter
only) alarms.
-ock all doors, trunk lid,
'uel filler cap. Arm the
alarm system. Close open
Nindows and sliding roof. Lock
all doors,
trunk lid,
fuel filler cap. Arm the
alarm system (perimeter
only). Close open windows
and sliding roof.
Variant 2 I Variant 3
Unlock drivers door only,
trunk lid, fuel filler cap.
Disarm the alarm system.
Switch on the interior light
for
15 seconds. Unlock
all doors, trunk lid,
fuel filler cap. Disarm the
alarm system. Switch on
the interior light for
15 sec-
onds.
X300 VSM Issue 1 August 1994 12

0 Variant 3 -Rest of the World.
A5.7.1 Locking (key)
Turn key to unlock position
and hold for 2 seconds.
nstruction I Variant 1 I Variant 2 I Variant 3
with the key does not dis-
arm the alarm system. An
audible ticking indicates
that the alarm will activate
after
30 seconds unless
the key is turned to posi
- tion II in the ignition or the
key
-ring transmitter but- ton (small) is pressed.
No feature
I I I rurn key to lock position
and release. imeter
onlv).arms.
Check that all doors, trunk lid and fuel filler cap lock and that the alarm system (per-
rurn key to lock position,
Told for 2 seconds and re-
Check that all doors, trunk lid and fuel filler cap lock,.the alarm system (perimeter
only) arms and all open windows and sliding roof close within 1.5 seconds.
ease.
rurn key to unlock position
and then to lock position
tvithin 3 seconds. Hold in
ock position for
2 seconds
:o close windows and slid- ng roof. Check
all doors
are dead-
locked and trunk lid and
fuel filler cap are locked.
Check alarm system (per
-
imeter, inclination and in- trusion) arms and all open
windows and sliding roof
close within 1.5 seconds.
Ensure that once deadlock
- ing is completed, the
sounder gives one audible
tone.
A5.7 SYSTEM TESTING
The following information details the procedures for a complete system test to identify and locate possible fault condi-
tions. Where faulty operation is identified refer to Diagnostic Sub-Routines for possible causes and remedies.
Locking, unlocking and setting the vehicle alarm system is carried out by key
or by radio frequency key-ring trans- mitter.
W:
Key-ring transmitter functions vary slightly between market variants. The action for each variant is described separate- ly where appropriate
m: Certain functions differ due to market variations. Differences will be detailed in the the following instruction
tables. The variants are defined as follows:
o Variant 1 - European and UK markets.
0 Variant 2 - North American markets.
Ensure
all doors
are fully closed before initiating lock procedures.
A5.7.2 Unlocking (key)
e Instruction Variant 1
Turn key to unlock position Check all doors, trunk lid
and release. and fuel filler cap unlock.
No feature
Variant 2
Check drivers door and
fuel filler cap unlock.
Check that the alarm
sys- tem disarms and the in-
terior light illuminates for
15 seconds.
Check all passenger doors
and trunk lid lock. Check
all doors
are dead-
locked and trunk lid and
fuel filler cap are locked.
Check alarm system (per
-
imeter, inclination and in- trusion) arms and all open
windows and sliding roof
close within 1.5 seconds.
Ensure that once deadlock
-
ing is completed, the
sounder gives one audible
tone.
Note:
No deadlock feature in Ja- panese market.
variant 3
Check all doors, trunk lid
and fuel filler cap. Check
that the alarm system dis
- arms and the interior light
illuminates for 15 seconds.
No feature
_____ X300 VSM 17 Issue 1 August 1994

Security System - RESTRICTED ISSUE
A5.7.7 Central Locking
W
With the ignition switch in either position 'I' or 'll', press the central locking switch and check that all the doors and the
luggage compartment lock, if they are unlocked.
Hold down the switch for
3 seconds and check any open windows or the sliding roof close, if open.
Check that
a further press on the central locking switch after 3 seconds will unlock the doors and the luggage compart- ment.
If the switch is pressed when ignition switch is not in position I or II, tilt and intrusion sensing will be disabled until the
next arming action. The active indicator, mounted in the switch housing, will flash to confirm this action.
To disarm
a passively armed vehicle the ignition key or key-ring transmitter can be used as follows:
Ensure
all doors
are fully closed before commencing lock operations.
0 Ignition key - Switch to position '11'.
0 Key-ring transmitter - Refer to A5.3.5 Unlocking.
A5.7.8 Passive Arming
Passive arming is a dealer option on variants 1 and 3 only.
With the ignition switch in the OFF position, check that passive arming of the vehicle takes place
30 seconds after the last closure of the doors, trunk lid, hood or sliding roof.
Ensurethat when passive arming occurs, the direction indicators flash once and the security active indicator in the cen
- tral locking switch lights for 2 seconds then flashes once when vehicle arming is complete.
W There is no audible indication when passive arming occurs.
A5.7.9 Trunk Release
Check that the the trunk lid can be released in the following ways:
0 From the vehicle interior by pressing the trunk release switch mounted on the facia.
0 By using the ignition key in the trunk lid if the vehicle is disarmed. If not disarmed the the alarm system will be
activated and can be switched off by ignition key or key-ring transmitter.
0 Remotely (as part of the unlocking procedure) by the key-ring transmitter.
A5.7.10 Trunk Valet Isolate
Check that valet switch operation prevents unauthorized entry into the luggagecompartment by inhibiting the luggage
compartment remote release switch and the green headed valet key can be used to park and lock the vehicle but does
not unlock the luggage compartment.
A5.7.11 Flush Sill Buttons
Variants 1 and 3 (except Japanese market) are fitted with flush sill buttons mounted in the door trim panel. Check but- ton operation as follows:
To lock the door from the interior press the sill button down, flush with the door trim panel. To unlock the door pull the
door lever out.
X300 VSM Issue 1 August 1994 20

Security System - RiESTRICTED ISSUE
AS. 12 INTRUSION SENSOR - RENEW
SRO
86.52.20
. Carefully displace the intrusion sensor from the headlin- ing.
W: View 1 (Fig. 1) shows a vehicle fitted with a sliding
roof. View 2 (Fig. 1) shows a vehicle without a sliding
roof.
. Disconnect the multi-plug and remove the intrusion sen-
Reconnect multi-plug to a new intrusion sensor.
. Locate the intrusion sensor securing studs and carefully
push into the headlining. Make sure the intrusion sensor
is fully seated.
sor.
A5.13
HAND
TRANSMITTER BATTERY - RENEW
SRO 86.52.28
Remove batteries (2 Fig. 2) and discard.
Fit two new batteries making sure the polarity is as shown
Fit and fully seat the transmitter rear cover.
rn Remove the hand transmitter rear cover (1 Fig. 2).
in Fig 2.
AS. 14
SRO 86.52.08
VAL El S WITCI - RENM
J86-I550
Fig. 1
I
I Fig. 2
Open the centre console compartment and carefully dis-
. Disconnect the harness connector and remove the valet
Fitting a new valet switch is the reverse of the removal pro-
place the valet switch.
switch.
cedure. Make sure the switch is fully seated.
Fig.
3
X300 VSM 41 Issue 1 August 1994