Accumulator JEEP LIBERTY 2002 KJ / 1.G Workshop Manual

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual LIBERTY 2002 KJ / 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7176/w960_7176-0.png JEEP LIBERTY 2002 KJ / 1.G Workshop Manual

Page 197 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual the rear brake circuit is pulsed. This allows fluid to
enter the low pressure accumulator (LPA) in the
HCU resulting in a drop in fluid pressure to the rear
brakes. In order to increase the rear brake

Page 199 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual REAR WHEEL SPEED SENSOR
REMOVAL
(1) Raise vehicle on hoist.
(2) Disconnect the sensor wire harness.
(3) Remove mounting stud from the sensor (Fig. 2).
(4) Remove sensor.
INSTALLATION
(1) Connect harne

Page 1654 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual DESCRIPTION - REFRIGERANT SYSTEM
SERVICE PORT
The two refrigerant system service ports are used
to charge, recover/recycle, evacuate, and test the air
conditioning refrigerant system. Unique service p

Page 1655 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual (1) Connect a tachometer a manifold gauge set or
A/C recycling/charging station.
(2) Set the A/C Heater mode control switch knob in
the Recirculation Mode position, the temperature
control knob in the

Page 1656 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual Pressure Diagnosis
Condition Possible Causes Correction
Rapid compressor clutch
cycling (ten or more cycles
per minute).1. Low refrigerant system
charge.1. See Plumbing/Diagnosis and Testing -
Refrige

Page 1661 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual (5) Connect the test set hose or probe to the open
end of the leaking circuit. The test set gauge should
return to the 27 kPa (8 in. Hg.) setting shortly after
each connection is made. If OK, replace

Page 1662 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual SPECIFICATIONS
TORQUE SPECIFICATIONS
DESCRIPTION N´m Ft. Lbs. In. Lbs.
A/C COMPRESSOR CLUTCH PLATE NUT 14.4 10.5 127.4
A/C COMPRESOR LINE MANIFOLD FASTENER 28 ( 6) 21 ( 4) 250 ( 50)
A/C COMPRESSOR

Page 1670 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual electric cooling fan operations. The switch is located
on the discharge line near the compressor. The
switch is screwed onto a fitting that contains a
Schrader-type valve, which allows the switch to b

Page 1671 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual on the evaporator fins from freezing and obstructing
air conditioning system air flow.
The a/c low pressure switch contacts are open
when the suction pressure is approximately 141 kPa
(20.5 psi) or lo

Page 1672 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual (2) Install and tighten the a/c low pressure switch
on the accumulator fitting. The switch should be
hand-tightened onto the accumulator fitting.
(3) Plug the wire harness connector into the a/c
low p
Page:   1-10 11-20 21-30 next >