flat tire JEEP LIBERTY 2002 KJ / 1.G Workshop Manual

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual LIBERTY 2002 KJ / 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7176/w960_7176-0.png JEEP LIBERTY 2002 KJ / 1.G Workshop Manual

Page 12 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual VEHICLE IDENTIFICATION NUMBER DECODING CHART
POSITION INTERPRETATION CODE = DESCRIPTION
1 Country of Origin 1 = United States
2 Make J = Jeep
3 Vehicle Type 4 = MPV W/O Side Airbags.
8 = MPV With Side

Page 30 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual (5) Install the hub/bearing. (Refer to 2 - SUSPEN-
SION/FRONT/HUB / BEARING - INSTALLATION).
(6) Install the axle shaft nut. Tighten the nut to
135 N´m (96 ft.lbs.).(if equipped with four wheel
drive

Page 52 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual (10) Start the engine and re-check for vibration. If
there is little or no change in vibration, move the
clamp to one of the other three positions. Repeat the
vibration test.
(11) If there is no diffe

Page 114 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual AXLE SHAFTS
REMOVAL
(1) Place transmission in neutral and raise and
support vehicle.
(2) Remove wheel and tire assembly.
(3) Remove brake drum.
(4) Remove axle retainer plate nuts from the rear
of the

Page 167 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual CAUTION: Never use gasoline, kerosene, alcohol,
motor oil, transmission fluid, or any fluid containing
mineral oil to clean the system components. These
fluids damage rubber cups and seals. Use only
f

Page 169 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual BRAKES DO NOT HOLD AFTER DRIVING THROUGH DEEP
WATER PUDDLES
This condition is generally caused by water soaked
lining. If the lining is only wet, it can be dried by
driving with the brakes very lightl

Page 193 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual INSPECTION
Inspect the cylinder bore. Light discoloration and
dark stains in the bore are normal and will not
impair cylinder operation.
The cylinder bore can be lightly polished but only
with crocus

Page 466 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual FRONT FOG LAMP UNIT
REMOVAL
(1) Turn the front wheels full lock in the direction
of the fog lamp bulb that is to be changed.
(2) Disconnect and isolate the battery negative
cable.
(3) Reach into the f

Page 483 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual enough to disengage the locator tab on the outboard
side of the unit (Fig. 41) or (Fig. 42) from the engage-
ment slot in the outboard edge of the reinforcement.
(5) Pull the headlamp unit away from t

Page 550 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual (5) From the front of the vehicle, pull the front fog
lamp unit out of the front bumper fascia far enough
to access and disconnect the wire harness connector
for the front fog lamp unit from the lamp
Page:   1-10 11-20 21-30 next >