Sun roof JEEP RENEGADE 2018 Owner handbook (in English)

GETTING TO KNOW YOUR CAR
In-depth knowledge of your new vehicle
starts here.
The booklet that you are reading simply
and directly explains how it is made and
how it works.
That’s why we advise you to read it
seated comfortably on board, so that you
can see immediately what is described
here for yourself.THE KEYS.................16
IGNITION DEVICE.............17
SENTRY KEY®...............19
ALARM...................20
DOORS...................21
SEATS....................24
HEAD RESTRAINTS............27
STEERING WHEEL............28
REAR VIEW MIRRORS..........29
EXTERIOR LIGHTS............31
INTERIOR LIGHTS............35
WINDSCREEN/REAR WINDOW
WIPER...................35
CLIMATE CONTROL SYSTEM......38
ELECTRIC WINDOWS...........45
ELECTRIC SUN ROOF..........46
MySky SUN ROOF.............48
BONNET..................52
LUGGAGE COMPARTMENT.......54
VERSION WITH LPG SYSTEM.....56
15

manual electric operation during window
closing.
Window opening
Push the buttons to open the desired
window.
When any of the opening buttons on front
or rear doors is pressed briefly, the
window moves in stages; if the button is
held down, "continuous automatic"
operation is activated.
If the button is pressed again, the
window will stop in the desired position.
Window closing
Lift the buttons to close the desired
window.
The window closing stage occurs
following the same logic described for
the opening stage, for the front door
windows only.
The rear door windows can only be closed
"in stages".
Front window anti-pinch safety device
(where provided)
This safety system can recognise the
presence of any obstacle during the
window closing movement. If this occurs,
the system stops the window's movement
and reverts it by a few centimetres,
depending on its position.
The anti-crush safety function isactivated both during the manual and the
automatic operation of the window.
Electric window system initialisation
If power supply is interrupted, the
electric window automatic operation
must be reinitialised.
The initialisation procedure described
below must be carried out with the doors
closed and for each door:
fully close the window to be
initialised, with manual operation;
after the window has reached the
upper end of travel, hold the up button
down for at least 3 seconds.
WARNING
22)Incorrect use of the electric windows
may be dangerous. Before and during their
operation, ensure that any passengers are
not at risk from the moving glass either by
personal objects getting caught in the
mechanism or by being hit by it directly.
When leaving the vehicle (equipped with
mechanical key with remote control),
always remove the key from the ignition
device to prevent accidental operation of
the electric windows from being a hazard
for those still on board.
ELECTRIC SUN ROOF
23)11)
The electric sun roof comprises two glass
panels (the front one is mobile and the
rear one fixed) and is fitted with an
electrically operated sun blind.
On some versions, the front panel might
be electrically operated.
The sun roof and the blind can be
operated only with the ignition device
turned to MAR.
CONTROL BUTTONS
Button Afig. 40: press the button on the
front glass panel to open it fully. Pull the
button: the front panel will close fully.
Press button A again during automatic
opening and closing to stop the blind
movement.
46
GETTING TO KNOW YOUR CAR

Button Bfig. 40: Briefly press button B
will open the sunshade blind in “steps”.
Pressing the button for longer, instead,
will activate “continuous automatic”
opening. Briefly pulling the button will
give a “snap” closing of the sunshade
blind. Keeping the button pulled,instead, will activate “continuous
automatic” closing.
Button Cfig. 40: press and release the
button to move the roof to the “spoiler”
position (swivel opening). This type of
swivel opening can be activated
irrespective of the position of the
sunroof. During “spoiler” opening, any
pressure on button C stops the roof
closing. Press button C with the roof fully
closed to open the roof to the “swivel”
position. If the roof is positioned between
the fully open position and the “swivel”
position, press button C to close it
manually.
ANTI-PINCH DEVICE
The sun roof and the electric blind are
equipped with an anti-pinch safety
system capable of detecting the presence
of an obstacle whilst the roof is closing:
if this happens, the system intervenes
and the movement of the glass is
immediately reversed.
EMERGENCY OPERATION
If the control buttons fail to operate, the
sun blind and the sun roof can be moved
manually, proceeding as described
below:
Sun blind movement: remove protective
cap A fig. 41 on the internal trim;
Sun roof movement: remove protective
cap B on the internal trim;
take the supplied spanner C from the
luggage compartment;
insert key C in housing A (for blind
movement) or B (for sun roof movement)
and turn it clockwise to open the roof (or
the blind) or anticlockwise to close the
roof (or the blind).
INITIALISATION PROCEDURE
Following an automatic movement
malfunction while opening/closing or
after an emergency manoeuvre (see
description in the previous paragraph),
the automatic operation of the sun roof
must be initialised again.
40J0A0224C
41J0A00390C
47

Proceed as follows:move the roof to fully closed position;move the ignition device to STOP and
keep it there for 10 seconds;
move the ignition device to MAR;press button A: fig. 40 in "closing"
position;
press the button for at least
10 seconds, then you should hear the
mechanical stop of the roof motor;
press the button A in the "closing"
position again within 5 seconds;
hold down button A: in this position,
the roof will perform an automatic
opening and closing cycle. Otherwise,
repeat the operations starting from the
beginning;
hold down button A until the roof is
completely closed: the initialisation
procedure has ended.
WARNING
23)When leaving the vehicle (equipped
with mechanical key with a remote
control), always remove the key from the
ignition device to avoid the risk of injury
to those still inside the vehicle due to
accidental operation of the sun roof.
Improper use of the roof can be
dangerous. Before and during operation,
always check that no-one is exposed to the
risk of being injured by the moving
sunroof or by objects getting caught or hit
by it.
IMPORTANT
11)Do not open the sun roof if a
transverse roof rack is fitted. Do not open
the sun roof if there is snow or ice on it:
you may damage it.
MySky SUN ROOF
12)
The roof has two panels, a front and a
rear one, that can be individually or
simultaneously removed, as wished.
Front and rear panels are distinguished
by a dedicated symbol on the bottom of
the panels themselves.
IMPORTANT The panels can withstand
any snow that may deposit on them. In
any case, it is advisable to remove
excessive snow.
FRONT PANEL ELECTRIC
MOVEMENT
On some versions, the front panel might
be electrically operated.
This operates only with the ignition
device at MAR. The panel can be
adjusted forward/backward and opened
in “swivel” position.
The buttons to operate the front panel
are located on the trim close to the front
ceiling light fig. 42:
Button A: open/close the front panel to
the end of its travel. Press button A to
fully open the front glass panel. Pull the
button: the front panel will close fully.
48
GETTING TO KNOW YOUR CAR

position the panels inside, making
sure that the two handles are reciprocally
opposed (see fig. 48 ), then reposition
the baffle properly in its housing;
close the bag again, position it
correctly inside the luggage compartment
and then secure the bag firmly to the
retaining hooks on the luggage
compartment crossmember (see fig. 49 ).
IMPORTANT Do not lay evenly
distributed loads on the bag if they
exceed 10 kg in weight.EMERGENCY OPERATION
If the control buttons fail to operate, the
sun roof can be moved manually,
proceeding as described below:
remove protective cap A fig. 50 on
the internal trim;
introduce the supplied key B into
housing A and turn it clockwise to open
the roof or anticlockwise to close it.
INITIALISATION PROCEDURE
Following an automatic movement
malfunction while opening/closing or
after an emergency manoeuvre (see
description in the previous paragraph),
the automatic operation of the sunroof
must be initialised again.
47J0A0630C
48J0A0490C
49J0A0417C
50J0A0080C
51

Proceed as follows:move the roof to fully closed position;move the ignition device to STOP and
keep it there for 10 seconds;
bring the ignition device to MAR;press button A fig. 42 in the “close”
position;
press the button for at least
10 seconds, then you should hear the
mechanical stop of the roof motor;
within 5 seconds, press the button A
again in the "close" position;
hold down button A in this position:
the roof will perform an automatic
opening and closing cycle. Otherwise,
repeat the operations starting from the
beginning;
hold down button A until the roof is
completely closed: the initialisation
procedure has ended.
IMPORTANT
12)Do not open the sun roof if a
transverse roof rack is fitted. Do not open
the sun roof if there is snow or ice on it:
you may damage it.
BONNET
OPENING
Proceed as follows:pull lever A fig. 51 in the direction
indicated by the arrow;
operate lever B fig. 52, in the
direction indicated by the arrow, and
raise the bonnet;
release bonnet stay C fig. 53 from its
locking device D, then insert its end in
housing E on the bonnet.
51J0A0364C
52J0A0069C
52
GETTING TO KNOW YOUR CAR

Light bulbsType Power
Front ceiling lightC5W 5 W
Front ceiling light (shade flaps) C5W 5 W
Rear ceiling light (versions without sun roof) C5W 5 W
Rear ceiling lights (versions with openable roof) C5W 5 W
Luggage compartment light W5W 5 W
Glove compartment lightW5W 4 W
195

LUGGAGE COMPARTMENT FUSE BOXfig. 167
COMMENT The luggage compartment control unit varies according to the car's equipment.
Fuse holder control unit no. 1
USERSFUSE AMPERE
Hi-Fi system F2 20
Electric sunroof F3 20
Electric front seat lumbar regulation (driver's side) F4 7.5
Electric front seat movement (driver's side) F5 30
Electric front seat movement (driver's and passenger's sides) F6 7.5
Electric front seat lumbar support (driver's and passenger's
sides)F7 30
Front seat electric heating F8 20
In addition, the control unit has a 20A fuse to protect the sunroof panel.
Fuse holder control unit no. 2
USERSFUSE AMPERE
Control unit for external light control on trailer F1 10
Control unit for external lights (left side) F5 15
Control unit for external lights (right side) F6 15
208
IN AN EMERGENCY

remove the spare tire jack's attaching
device;
remove the wheel block wedge;remove the jack and the spanner to
dismount the spare tire bolt. Turn the
jack's screws to loosen the spanner and
separate it from the jack mechanism;
remove the tire from the boot.
Tool kit bag (where there is one)
On the versions with a spare tire, inside
the boot (on the right side) there is a tool
kit latched to the boot's covering carpet
with its own attachments.
Inside the tool kit there are fig. 171:
A: the jack;B: the screwdriver;C: the refuelling adaptor in case of
emergency;
D: the pin to centre to wheel (where
there is one, use it when mounting the
spare tire);
E: a special anti-theft bolt (where
present, use when mounting/dismounting
the tire bolt);
F: a wedge to block the wheel;G: the towing ring;H: the spanner for mounting/locking
the tire bolt and to work the jack;
I: the emergency allen key to activate
the sunroof (where there is one).Important information about the jack
Please note that:
the whole jack weighs 2.8kg;the jack requires no adjustment;
the jack cannot be repaired: if it
breaks, it must be replaced with another
original;
no tool, except the crank wheel, can
be attached to the jack.
Proceed as follows:
in case where you have to place the
car on an inclined roadway, if it is very
steep, or if the ground is unstable, lift
out the blocking wedge A and open it like
a book, as shown in the illustration
fig. 172;
warn anyone present that the car is
going to be lifted up: they need to leave
the immediate vicinity and even more
important, warn them not to touch the
car until it has been brought back down.
171J0A0226C172J0A0157C
211

IMPORTANT Do not operate the rear
window wiper with the blade lifted
from the rear window.
Windscreen washer
The windscreen jets, located on the
bonnet, are fixed.
If there is no jet of fluid, firstly check
that there is fluid in the reservoir (see
paragraph “Engine compartment” in this
chapter). Then check that the nozzle
holes are not clogged; use a needle to
unblock them if necessary.
IMPORTANT In versions with a sun
roof, make sure that the sun roof is
closed before operating the window
washer jets.
Rear window washer
The rear window washer jets are fixed.
The nozzle holder is located above the
rear window.
WARNING
189)The air intake system (air cleaner,
rubber hoses, etc.) can be a protection in
the case of blowbacks from the engine.
DO NOT REMOVE this system unless you
need to carry out repair or servicing
operations. Before starting the engine,
ensure that the system has not been
removed: failure to observe this precaution
may result in serious injury.
190)Exhaust emissions are very
dangerous, and may be lethal. They
contain carbon monoxide, a colourless,
odourless gas which can cause fainting
and poisoning if inhaled.
191)The exhaust system may reach high
temperatures and may cause a fire if the
vehicle is parked on flammable material.
Dry grass or leaves can also catch fire if
they come into contact with the exhaust
system. Do not park or use the vehicle in a
place in which the exhaust system might
come into contact with flammable
material.
IMPORTANT
89)Incorrect servicing of the vehicle or
failure to carry out operations or repairs
(when necessary) may lead to more
expensive repairs, damage to other
components or have a negative impact on
the vehicle performance. Have any
malfunction inspected immediately by a
Jeep Dealership.
90)The vehicle is equipped with fluids
which are optimised or protecting its
performance and life and extending
service intervals. Do not use chemicals for
washing these components since they may
damage the engine, the gearbox or the
climate control system. This damage is not
covered by the vehicle’s warranty. If any
component needs to be washed due to
malfunctioning, use only the specific
liquid for that procedure.
91)An excessive or insufficient amount of
oil inside the base is extremely damaging
to the engine. Make sure it is always at an
adequate level.
205J0A0346C
253