open hood JEEP WRANGLER 2009 Owners Manual

▫To Raise The Rear Seat ................. 92
 To Open And Close The Hood ............. 93
 Lights .............................. 94
▫ Multifunction Lever ................... 94
▫ Parking Lights, Instrument Panel Lights And
Headlights .......................... 95
▫ Lights-On Reminder ................... 95
▫ Headlight Dimmer Switch ............... 96
▫ Flash-To-Pass ........................ 96
▫ Front Fog Lights — If Equipped ........... 96
▫ Turn Signals ......................... 96
▫ Lane Change Assist .................... 96
▫ Daytime Running Lights — If Equipped ..... 97▫
Interior Lights ....................... 97
 Windshield Wipers And Washers ........... 98
▫ Windshield Wiper Operation ............. 98
▫ Intermittent Wiper System .............. 100
▫ Windshield Washers .................. 101
▫ Mist Feature ........................ 101
 Tilt Steering Column ................... 101
 Electronic Speed Control — If Equipped ..... 102
▫ To Activate ......................... 103
▫ To Set a Desired Speed ................ 104
▫ To Deactivate ....................... 104
▫ To Resume Speed .................... 104
▫ To Vary The Speed Setting .............. 104
78 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Headlamp
1. Open hood and support using prop rod.
2. Remove the front grille. Turn the retainers along the
top 1/4 turn counterclockwise and remove.
3. Pull the bottom of the grille away starting at one side
and working toward the other.
4. Turn both park and turn signal socket assemblies 1/4
turn counterclockwise and remove.
5. Remove the four screws holding the metal retaining
ring. 6. Remove the lamp from the collar.
7. Grasp the bulb and turn 1/4 turn counterclockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and push the
connector locking tab to the lock position.

Inflation Pressures..................... 343
Jacking ........................... 389,392
Load Capacity ..................... 338,339
Pressure Monitor System (TPMS) ........... 351
Pressure Warning Light .................. 206
Quality Grading ....................... 479
Radial .............................. 346
Replacement ......................... 348
Rotation ............................ 350
Safety .............................. 333
Sizes ............................... 335
Spare Tire ........................... 390
Spinning ............................ 346
Tread Wear Indicators ................... 347
To Open Hood .......................... 93
Tongue Weight/Trailer Weight .............. 375
Torque Converter Clutch .................. 291
Tow Hooks, Emergency ................... 396
Towing ............................ 365,397Disabled Vehicle
....................... 397
Guide .............................. 369
Recreational .......................... 382
Weight .............................. 369
Trac-Lok Rear Axle ...................... 295
Traction Control ......................... 319
Traction Control Light .................... 211
Trailer Sway Control (TSC) ................. 332
Trailer Towing .......................... 365
Cooling System Tips .................... 382
Hitches .......................... 356,368
Minimum Requirements ................. 376
Trailer and Tongue Weight ............... 375
Wiring .............................. 380
Trailer Towing Guide ..................... 369
Trailer Weight .......................... 369
Transfer Case ........................... 426
Four-Wheel-Drive Operation .............. 291
Maintenance ......................... 426
496 INDEX