KIA CADENZA 2016 Features and Functions Guide

9
Blind Spot Detection (BSD) System*
The BSD System uses radar sensors to help alert the driver before changing
lanes The BSD System is ON when the button A is pressed – the button light
will illuminate The outside rearview mirror warning lights will also illuminate for
3 seconds
The system will become active when the vehicle is traveling more than 9 mph
and will alert the driver if another vehicle is detected by the radar sensor
Blind Spot Detection / Lane Change Assist
1st-stage alert: When another vehicle is detected within the BSD System
boundary
B, a yellow indicator will illuminate on the outside rearview mirrors
2nd-stage alert: When 1st-stage alert is on and the driver activates a turn
signal, a flashing yellow indicator will illuminate on the outside rearview mirrors
and the system will sound an alert
RCTA (Rear Cross Traffic Alert)
If the RCTA system sensors detect approaching vehicles from the left or right
side
C, the system will sound an audible alert, the warning indicators on the
outside rearview mirror will illuminate and a message will appear on the LCD
screen, when these conditions are met:
• When the gear shift is in Reverse
• When the vehicles moves in reverse
• When the vehicle is moving less than 6 mph
REMINDERS:

• When the BSD System is ON and the ignition is cycled to OFF then ON again, the BSD System
returns to ON

•The RCTA feature can be turned OFF/ON in User Settings and will remain in OFF/ON as selected
For more information on the Blind Spot Detection System, please refer to the Owner’s Manual.


Blind Spot Detection
System w/RCTA Video

To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www. KuTechVideo s.c om/vg13/2016
A
B
C
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL

10


Lane Departure
Warning Video

To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www. KuTechVideo s.c om/vg13/2016
Lane Departure Warning System (LDWS)*
With the ENGINE START/STOP button in the ON position, press
the LDWS button C to turn system ON The instrument cluster
indicator
will illuminate green LDWS will stay on when the
ignition is cycled
If the LDWS detects that you are veering outside of your lane,
the system may issue a warning on the LCD screen and an alert
may sound, under these conditions:
• The vehicle exceeds approximately 43 mph

• The LDWS system recognizes the lane the vehicle is
traveling in
REMINDER: LDWS will not issue a warning if the turn signal is activated
The Lane Departure Warning System (LDWS) is not a substitute for safe and
proper driving. Always drive safely and use caution. LDWS may not always alert
the driver if the vehicle is driven outside of it’s lane.
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
ODO 123456 mi
LDWS
Instrument Panel Dimmer
With parking lights/headlights ON, press button D (+) or (-)
to adjust the brightness of the instrument panel illumination

REMINDER: The Instrument Panel Dimmer does not adjust brightness on the
Navigation System screen, use Navigation setup to adjust brightness on the
Navigation System
(Button panel located left of Steering Wheel)
D
C
When the LDWS sensor detects
the lane traveling inWhen the LDWS sensor does not
detect the lane traveling in
When the LDWS sensor detects the vehicle veering outside of the lane traveling
in, a yellow indicator will illuminate
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
DRIVER'S PANEL

11
Power Windows, Window Lock & Central Door Lock
A Pull/Press to operate Driver’s Window Auto Up/Down*
B Press to Unlock /Lock All Doors
C Press to disable Rear Passenger Windows
Power Folding Outside Mirrors*
Toggle middle switch D left or right to select mirror Then press arrows to
adjust Power Folding Outside Mirror position
Toggle button
E left /right to unfold/fold the outside rearview mirrors
Toggle button
E to center to automatically fold/unfold mirrors when:
• The Smart Key Lock /Unlock buttons are pressed
• The door outside handle button is pressed
REMINDERS:

• To automatically fold mirrors when exiting vehicle, press the LOCK button twice on the Smart Key

•To lock position of mirrors, toggle switch to the neutral (center) position
Heated Outside Mirrors
Mirror heaters are controlled with Rear Defroster
Automatic Door Lock/Unlock
Auto Door Lock /Unlock will engage when the gear shift is moved in to or
out of the P (Park) position Refer to the User Settings on how to turn Auto
Door Lock/Unlock ON/OFF
(Buttons panel located on Driver's Door )


The mirrors will automatically unfold when the Smart Key* is within close proximity
to the vehicle QUICK TIP
A
BC
D
E
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL

12
Fuel Door and Trunk Release Buttons
Press the C button to release the fuel door
Press the
D button to open the trunk
Reverse Parking Aid Function*
When the gear shift lever is moved into R (Reverse) and while the vehicle is
moving backwards, the outside rearview mirrors A will rotate downward to
aid in reverse parking
To turn ON the Reverse Parking Aid Function, the outside mirror switch
B
needs to be in the left or right position
To turn OFF, place outside mirror switch in the center position.
The outside rearview mirrors will automatically return to their original
positions when:
• The ENGINE START/STOP Button is in the OFF position
• The gear shift lever is moved to any position except R (Reverse)
• Outside rearview mirror switch is in the middle position
REMINDER: When the outside rearview mirror switch B is in the middle position, the Reverse
Parking Aid Function will not operate and the outside rearview mirrors will not rotate downward
(Buttons panel located on Driver's Door ) (Buttons located left of Steering Wheel)
A
B
CD
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
DRIVER'S PANEL

13
Engine Start/Stop Button
To start the engine:
1 Depress the brake pedal
2 Press the ENGINE START/STOP button while in Park or Neutral

To turn the engine OFF, press the ENGINE START/STOP button
To use the ENGINE START/STOP button, you must have the Smart Key fob on
your person
REMINDERS:

• In an emergency situation while the vehicle is in motion, you are able to turn the engine off and to
the ACC position by pressing the ENGINE START/STOP button for more than 2 seconds or 3 times
successively within 3 seconds

• If Smart Key fob battery is dead, with the lock button facing the ENGINE START/STOP button, hold
the fob up against the ENGINE START/STOP button and press


Engine Start/Stop Button
& Smart Key Video

To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www. KuTechVideo s.c om/vg13/2016
ENGINESTART
STOP


To use electrical accessories:
ACC position

•When in the OFF position and without depressing the brake pedal, press the ENGINE START/STOP button once (orange light A)
ON position

•When already in the ACC position (orange light A) and without depressing the brake pedal, press the ENGINE START/STOP button again
(red light B)
• When in the OFF position and without depressing the brake pedal, press the ENGINE START/STOP button twice (red light B)
Keeping the vehicle in ACC or the ON position for extended periods of time without turning engine on may discharge the
vehicle’s battery.
QUICK TIPS
A
B
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL

14
It may be helpful to pull/push bottom of Steering Wheel towards/away from you to
adjust desired distance
Manual Tilt/Telescoping Steering Wheel*
To adjust the Steering Wheel, press the Lock-Release Lever A down and
adjust to desired distance B and angle C
When finished, pull the Lock-Release Lever
A up to lock Steering Wheel
in place
Power Tilt/Telescoping Steering Wheel*
To adjust the Steering Wheel angle D, move the switch E up or down
To adjust the Steering Wheel distance
F, move the switch E forward
or backward
A
B
C
D
F
E
QUICK TIP
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
STEERING WHEEL CONTROLS

15
Headlights & High Beams
To o p e r a t e :
• Rotate switch to change the Headlight function
• Push lever to turn High Beams ON
• Pull lever to flash Headlights/High Beams
AUTO Light function — When the light switch is in the AUTO
Light position, the tail lights and headlights will turn ON/OFF
automatically depending on the amount of light outside
the vehicle
Adaptive Front Lighting System (AFLS)*
The Adaptive Front Lighting System helps improve visibility during
nighttime driving by aiming the low beam headlights in the direction
the vehicle is moving AFLS controls the aiming direction based on
steering angle and speed
When the light switch is in the AUTO Light position, the AFLS
will activate
REMINDER: When the AFLS indicator illuminates on the Instrument Cluster, the
AFLS is not working properly See authorized Kia dealer for service
Headlight position
Parking light position
AUTOAutomatic Headlights position
OFFOFF position
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
STEERING WHEEL CONTROLS

16
Turn Signals & Fog Lights*
To o p e r a t e :
• Turn Signals - Move lever Up/Down for Right /Left Turn Signal
• Fog Lights - Push toggle switch to turn Fog Lights ON/OFF
REMINDER: Headlights must be ON for Fog Light operation
One-Touch Lane Change Signal is activated by moving the Turn
Signal Lever slightly for less than 1 second and then releasing The
lane change signal will blink 3 times
To change how many times (3/5/7) the Lane Change Signal blinks,
go to User Settings Mode in the LCD Instrument Cluster modes
For more information on the User Settings Mode, please refer to your Owner’s Manual.
O ne -To u ch
Lane Change
Signal
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
STEERING WHEEL CONTROLS

17
M I S T: Single wipe
OFF: Wiper off
AUTO: Auto Control* wipe
LO: Slow wipe
HI: Fast wipe
Windshield Wipers & Washers
To o p e r a t e :
• Move lever Up/Down to change Wiper modes
• Pull lever to spray and wipe
Auto Control (Rain Sensing)*
The rain sensor located on the upper end of the windshield
glass senses the amount of rainfall and controls the wiping
cycle for the proper interval The more it rains, the faster the
wiper operates When the rain stops, the wiper stops
To adjust the Auto Rain Sensing speed setting, move the
speed control switch
A up/down


•With the ENGINE START/STOP button in the ON position and
the wiper switch is in AUTO mode, the wiper will operate once
to perform a self-check of the system

•Moving lever to HI increases Intermittent wipe frequency and
wipe speed Moving lever to LO decreases frequency of wipes

•Set the wiper to OFF position when the wiper is not in use
QUICK TIPS
A
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
STEERING WHEEL CONTROLS

18
Bluetooth® Wireless Technology
For more information on the audio systems, if equipped, refer to the Owner’s Manual or Car Multimedia System User's Manual. For Bluetooth® Wireless Technology FAQs, go to www.kia.com, Owners
section, or call Consumer Information for Bluetooth® Technology at (800) 333-4KIA. Refer to your Owner’s Manual for more specific Bluetooth® Wireless Technology phone pairing and operation instructions.
D Receive/Place Call button: Press to receive/place/transfer calls Press
to place a call using voice command prompts from the system, or to
answer an incoming call
E End Call button: Press to end a call or cancel a function
A Volume buttons: Press up/down to raise/lower speaker volume
B MUTE button: Press to mute the microphone during a call
C Talk button: Press to activate voice recognition/bring up menus/place
calls with minimal voice command prompts from the system
Your vehicle’s steering wheel buttons may differ from those in the illustrations. See your
Owner’s Manual for more details.
Driving while distracted is dangerous and should be avoided. Drivers should remain attentive
to driving and always exercise caution when using the steering-wheel-mounted controls
while driving
CANCEL CRUISE
RES
SET
VOL
VOL
MUTEMODE


When using the voice command feature, wait for the system BEEP before speaking
the command QUICK TIP


• Phonebook transfer upload time varies by phone model and with number of
phonebook entries

•Because of differences in phone quality, service providers and Bluetooth®
Wireless Technology chip programming, functionality may differ from one phone
to another

•Changing language setting may delete paired phones
QUICK TIPS
A
B
D
E
C
CADENZA FEATURES & FUNCTIONS GUIDE
*IF EQUIPPED
STEERING WHEEL CONTROLS