lock KIA OPTIMA PLUG-IN HYBRID 2017 Owners Manual

4. Lock the cover with the reverse or‐der.
Replace the filter according to the
Maintenance Schedule.
If the vehicle is operated in extremely dusty or sandy areas, replace the ele‐
ment more often than the usual rec‐
ommended intervals. (Refer to L

CLIMATE CONTROL AIR FILTER
Filter inspection
The climate control air filter should bereplaced according to the maintenance
schedule. If the vehicle is operated in
severely air-polluted cities or on dusty rough roads for a long period, it should
be inspected more frequently and re‐
placed earlier. When you replace the cli‐ mate control air filter, replace it per‐
forming the following procedure, and
be careful to avoid damaging other components.
0+'
1. Open the glove box and remove the stoppers on both sides.
0+'
2. With the glove box open, pull thesupport strap (1).
0+'
3. Remove the climate control air fil‐ter cover while pressing the lock on
the right side of the cover.
0+'
4. Replace the climate control air fil‐ ter.
5. Reassemble in the reverse order of disassembly.
NOTICE
When replacing the climate control
air filter install it properly. Other‐
wise, the system may produce noise
and the effectiveness of the filter
may be reduced.

9-35
9
Maintenance

Front windshield wiper blade
0+'
For your convenience, move the wind‐
shield wiper blades to the service posi‐ tion as follows;
After turning off the engine, move the
wiper switch to the single wiping (MIST)
position within 20 seconds and hold the switch more than 2 seconds until the
wiper blade is in the fully up position.
CAUTION
Do not allow the wiper arm to fallagainst the windshield, since it maychip or crack the windshield.
Type A
0).
0).
1. Raise the wiper arm. 2. Lift up the wiper blade clip. Then
pull down the blade assembly and
remove it.
3. Install the new blade assembly.
4. Return the wiper arm on the wind‐ shield.
5. Turn ignition to the ON position and wiper arms will return to the nor‐
mal operating position.
Type B
-%"
1. Raise the wiper arm and turn the wiper blade assembly to expose
the plastic locking clip.

9-37
9
Maintenance

NOTICE
We recommend that when replacing
tires, use the same originally sup‐
plied with the vehicles.
If not, that affects driving perform‐
ance.
CAUTION
When replacing the tires, recheckand tighten the wheel nuts afterdriving about 50 km (31 miles) andrecheck after driving about 1,000 km(620 miles).If the steering wheel shakes or thevehicle vibrates while driving, thetire is out of balance. Align the tirebalance. If the problem is not solved,we recommend that you contact anauthorized Kia dealer.
WARNING
nReplacing tires
(Continued)
(Continued)
To reduce the chance of serious orfatal injuries from an accidentcaused by tire failure or loss of vehi‐cle control:•Replace tires that are worn, showuneven wear, or are damaged.Worn tires can cause loss of brak‐ing effectiveness, steering control,and traction.
•Do not drive your vehicle with toolittle or too much pressure in yourtires. This can lead to uneven wearand tire failure.
•When replacing tires, never mix ra‐dial and bias-ply tires on the samecar. You must replace all tires (in‐cluding the spare) if moving fromradial to bias-ply tires.
•Using tires and wheels other thanthe recommended sizes couldcause unusual handling character‐istics and poor vehicle control, re‐sulting in a serious accident.
(Continued)
(Continued)
•Wheels that do not meet Kia’sspecifications may fit poorly andresult in damage to the vehicle orunusual handling and poor vehiclecontrol.
•The ABS works by comparing thespeed of the wheels. The tire sizeaffects wheel speed. When replac‐ing tires, all 4 tires must use thesame size originally supplied withthe vehicle. Using tires of a differ‐ent size can cause the ABS (Anti-lock Brake System) and ESC (Elec‐tronic Stability Control) to work ir‐regularly.
Wheel replacement
When replacing the metal wheels for
any reason, make sure the new wheels are equivalent to the original factory
units in diameter, rim width and offset.
WARNING
A wheel that is not the correct sizemay adversely affect wheel and
(Continued)

9-47
9
Maintenance

If it fits loosely, we recommend that
you consult an authorized Kia dealer.
If you do not have a spare, use a fuse of the same rating from a circuit you
may not need for operating the vehicle,
such as the cigarette lighter fuse.
If the headlights or taillights, stop lights, courtesy lamp, day time running
lights (D.R.L) do not work and the fuses
are OK, check the fuse panel in the en‐ gine compartment. If a fuse is blown, it
must be replaced.
Fuse switch
0+'
Always, put the fuse switch at the ON
position. If you move the switch to the OFF posi‐
tion, some items such as audio and dig‐
ital clock must be reset and transmitter
(or smart key) may not work properly.
If the fuse switch is in OFF, a warning sign will illuminate on the dashboard.
CAUTION
•Put all switches in ON when driv‐ing.
•If the vehicle remains idle for over1 month, put all switches in OFF toprevent the batteries from beingdischarged.
•Excluding long-term parking forover 1 month, the contact pointsof switches may wear out uponextensive use. Please refrain fromexcessive use of switches.
Engine compartment fuse
replacement
1. Turn the ignition switch and all oth‐ er switches off.
2. Remove the fuse panel cover by pressing the tab and pulling the
cover up. When the blade type fuse
is disconnected, remove it by using
the clip designed for changing fuses
located in the engine room fuse
box. Upon removal, securely insert
reserve fuse of equal quantity.
3. Check the removed fuse; replace it if it is blown. To remove or insert
the fuse, use the fuse puller in the
engine compartment fuse panel.
Maintenance
9-54

Instrument panel (Driver’s side fuse
panel)
Fuse NameSymbolFuse rat‐ingCircuit Protected
MODULE 7
10A Around View Monitor Unit, Front Air Ventilation Seat Control Module, Front
Seat Warmer Control Module, Rear Seat Warmer Control Module
MODULE 5
10A A/C Control Module, Electro Chromic Mirror, Driver IMS Module, Head Lamp
LH/RH, Auto Head Lamp Leveling Device Module, Fuel Lid & Trunk Open Switch,
Shift Lever Indicator, Front Air Ventilation Seat Control Module, Front Seat
Warmer Control Module, Rear Seat Warmer Control Module
MODULE 6
10A BCM, Smart Key Control Module
A/CON
10A A/C Control Module, E/R Junction Block (RLY. 4 - Blower Relay), Ionizer, Active
Incar Sensor, Electronic A/C Compressor
START
10A Transaxle Range Switch, Smart Key Control Module
A/BAG
15A SRS Control Module, Passenger Occupant Detection Sensor
MODULE 3
10A BCM, Stop Lamp Switch, AFLS Unit, Keyboard, VESS Unit, A/V & Navigation Head Unit, Sport Mode Switch
MODULE 4
10A Console Switch, Blind Spot Detection Radar LH/RH, Smart Parking Assist Con‐
trol Module, Smart Cruise Control Unit, Lane Keeping Assist Module, Active Air
Flap Unit, Electric Parking Brake Module, BMS Control Module
INTERIOR LAMP
10A Trunk Room Lamp, Driver/Passenger Door Lamp, Glove Box Lamp, Driver/
Passenger Smart Key Outside Handle, Front Vanity Lamp Switch LH/RH, Over‐
head Console Lamp, Rear Personal Lamp LH/RH, Driver/Passenger Foot Lamp,Room Lamp, Center Personal Lamp
MDPS
10A MDPS Unit (Column/Rack)
Maintenance
9-58

Fuse NameSymbolFuse rat‐ingCircuit Protected
IG1
25A PCB Block (Fuse - OPCU2/ELECTRICAL WATER PUMP/TCU2/ACTIVE HYDRAULIC
BOOTER 3/HEV ECU2/ECU3)
MODULE 9
10A Smart Key Control Module
WASHER
15A Multifunction Switch (Wiper Low & Washer Switch)
MODULE 8
10A Driver/Passenger Door Module
CLUSTER
10A Instrument Cluster
MULTI MEDIA
15A Audio, A/V & Navigation Head Unit, Keyboard
HTD STRG
15A BCM (Steering Wheel Heated)
MODULE 1
10A Console Switch, Active Air Flap Unit, Gateway, Driver/Passenger Door Module
DR LOCK
20A Door Lock Relay, Door Unlock Relay, ICM Relay Box (Dead Lock Relay)
MEMORY 2
10A Siren Control Module, Ultrasonic Intrusion Protection Sensor
SMART KEY
15A Smart Key Control Module
A/BAG IND
10A Instrument Cluster (Air Bag IND. Power)
TRUNK
10A Trunk Lid Relay, Fuel Filler & Trunk Open Switch, ICM Relay Box (Fuel Filler Open Relay)
SUNROOF 2
20A Sunroof Control Unit (Roller)
BATTERY MANAGE‐ MENT
BATTERY
MANAGEMENT20A BMS Control Module
MEMORY 1
10A Instrument Cluster, A/C Control Module, Data Link Connector, BCM, Wireless
Charger, Driver IMS Module, Rain Sensor, ICM Relay Box (Outside Mirror Fold‐
ing/Unfolding Mirror Relay), Security Indicator, Auto Light & Photo Sensor,
Driver/Passenger Door Module


9-59
9
Maintenance

Fuse NameSymbolFuse rat‐ingCircuit Protected
FOG LAMP REAR
10A ICM Relay Box (Rear Fog Lamp Relay)
GATEWAY
10A Gateway
S/HEATER REAR
25A Rear Seat Warmer Control Module
SUNROOF 1
20A Sunroof Control Unit (Glass)
S/HEATER FRONT
25A Front Air Ventilation Seat Control Module, Front Seat Warmer Control Module
ECS
15A Not Used
MODULE 2
10A Audio, A/V & Navigation Head Unit, Keyboard, Wireless Charger, Around View
Monitor Unit, AMP, Power Outside Mirror Switch, Smart Key Control Module,
BCM, Rear USB Charger, VESS Unit, E/R Junction Block (RLY. 7 - Power OutletRelay)
P/WDW RH
25A Power Window RH Relay, Rear Safety Power Window Module LH, Rear Power
Window Switch LH, Power Window Main Switch,
[LHD] Passenger Safety Power Window Module
[RHD] Driver Safety Power Window Module
P/SEAT PASS
30A Passenger Seat Manual Switch, Walk In Relay Module, Passenger Reclining Lim‐ it Switch
AMP
25A AMP
BRAKE SWITCH
10A Stop Lamp Switch, Smart Key Control Module, Start/Stop Button Switch
P/WDW LH
25A Power Window LH Relay, Rear Safety Power Window Module RH, Rear Power
Window Switch RH, Power Window Main Switch,
[LHD] Driver Safety Power Window Module
[RHD] Passenger Safety Power Window Module
P/SEAT DRV
30A Driver Seat Manual Switch, Driver IMS Module
Maintenance
9-60

Engine room compartment fuse panel
Fuse NameSymbolFuse ratingCircuit Protected
MULTI FUSE MDPS 1
80A MDPS Unit (Column)
COOLING FAN
60A RLY. 2 (Cooling Fan Relay)
B+5
50A PCB Block (Engine Control Relay, Fuse -FUEL
PUMP/ECU2/TCU1/HORN/WIPER1/BATTERY C/FAN)
B+3
50A Smart Junction Block (IPS 2 (IPS 5), IPS 3 (IPS 6), IPS 7, IPS 8)
REAR HEATED
50A RLY. 11 (Rear Heated Relay)
ACTIVE HYDRAULIC BOOSTER 2
2ACTIVE
HYDRAULIC BOOSTER40A Integrated Brake Actuation Unit
BLOWER
40A RLY. 4 (Blower Relay)
POWER OUTLET1
40A RLY. 7 (Power Outlet Relay)
IG2
30A PCB Block (IG2 Relay)
B+1
60A Smart Junction Block (Fuse - TRUNK, SUNROOF2, S/HEATER
REAR, SUNROOF1, P/WDW RH, P/SEAT PASS, P/WDW LH, P/SEAT
DRV)
EEWP
EEWP60A Engine Electric Water Pump
B+2
60A Smart Junction Block (IPS 1, IPS 4, Fuse - FOG LAMP REAR, S/
HEATER FRONT, AMP)
ACTIVE HYDRAULIC BOOSTER 1
ACTIVE
HYDRAULIC
BOOSTER140A Integrated Brake Actuation Unit
IG1
40A PCB Block (IG1/ACC Relay)

9-65
9
Maintenance

Fuse NameSymbolFuse ratingCircuit Protected
FUSE EPB1
130A Electric Parking Brake Module
H/Lamp Washer
30A RLY. 9 (H/Lamp Washer Relay)
B+4
40A Smart Junction Block (Leak Current Autocut Device Fuse - INTERI‐
OR LAMP, MULTI MEDIA, MEMORY2, MEMORY1, Fuse - MODULE1,
DR LOCK, SMART KEY, BRAKE SWITCH)
EPB 2
230A Electric Parking Brake Module
OPCU 1
OPCU120A Electric Oil Pump Unit
DEICER
20A RLY. 10 (Deicer Relay)
AMS
10A Battery Sensor
HEATED MIRROR
10A A/C Control Module, Driver/Passenger Power Outside Mirror
WIPER 2
210A BCM, PCM
H/LAMP HI
20A Not used
HEV ECU 1
HEV
ECU110A HPCU
OPCU2
OPCU110A Electric Oil Pump Unit
ELECTRICAL WATER PUMP
ELECTRICALWATERPUMP10A Electric Water Pump (HEV)
FUEL PUMP
20A Fuel Pump Relay
Maintenance
9-66