change time KIA OPTIMA PLUG-IN HYBRID 2017 User Guide

Turn signals and lane change
signals
The ignition switch must be on for the
turn signals to function. To turn on the turn signals, move the lever up or down
(A). The green arrow indicators on the
instrument panel indicate which turn signal is operating. They will self-cancel
after a turn is completed. If the indica‐
tor continues to flash after a turn, manually return the lever to the OFF
position.
To signal a lane change, move the turn
signal lever slightly and hold it in posi‐ tion (B). The lever will return to the OFF
position when released. If an indicator stays on and does not
flash or if it flashes abnormally, one of the turn signal bulbs may be burned
out and will require replacement.
One-touch lane change function (if
equipped)
To activate an one-touch lane change
function, move the turn signal lever slightly for less than 0.7 second and
then release it. The lane change signals
will blink 3 times.
NOTICE
If an indicator flash is abnormally
quick or slow, a bulb may be burned
out or have a poor electrical connec‐
tion in the circuit.
Rear fog light (if equipped)
To turn the rear fog lights on, turn the
headlight switch to the headlight on position and turn the rear fog light
switch (1) to the ON position.
The rear fog lights turn on when the
rear fog light switch is turned on after the headlight switch is in the parklight
position.
To turn the rear fog lights off, turn the
rear fog light switch to the on position again or turn the headlight switch off.

5-119
5
Features of your vehicle

Seat warmer (if equipped)
'SPOU
TFBU
0+'
3FBS
TFBU
0+'
The seat warmer is provided to warm
the front seats during cold weather. With the ignition switch in the ON posi‐
tion, push either of the switches to
warm the driver's seat or the front passenger's seat.
During mild weather or under condi‐
tions where the operation of the seat
warmer is not needed, keep the switches in the "OFF" position. • Each time you press the switch, the temperature setting of the seat will
change as follows: - Front seat
OFF HIGH( ) MIDDLE( ) LOW( )

- Rear seat
• The seat warmer defaults to the OFF
position whenever the ignition switch
is turned on.
NOTICE
With the seat warmer switch in the
ON position, the heating system in
the seat turns off or on automati‐
cally depending on the seat temper‐
ature.
CAUTION
•When cleaning the seats, do notuse an organic solvent such aspaint thinner, benzene, alcohol andgasoline. Doing so may damagethe surface of the heater or seats.
•To prevent overheating the seatwarmer, do not place anything onthe seats that insulates againstheat, such as blankets, cushions orseat covers while the seat warmeris in operation.
•Do not place heavy or sharp ob‐jects on seats equipped with seatwarmers. Damage to the seatwarming components could occur.
•Do not change the seat cover. Itmay damage the seat warmer orairventilation system.

5-155
5
Features of your vehicle

WARNING
nSeat warmer burns
Passengers should use extreme cau‐tion when using seat warmers dueto the possibility of excess heatingor burns. The seat warmer maycause burns even at low tempera‐tures, especially if used for long pe‐riods of time. In particular, the drivermust exercise extreme care for thefollowing types of passengers:1.Infants, children, elderly orhandicapped persons, or hospitaloutpatients
2.Persons with sensitive skin orthose that burn easily
3.Fatigued individuals
4.Intoxicated individuals
5.Individuals taking medicationthat can cause drowsiness orsleepiness (sleeping pills, coldtablets, etc.)
Air ventilation seat (if equipped)
0+'
The temperature setting of the seat
changes according to the switch posi‐ tion. • If you want to warm your seat cush‐ ion, press the switch (red color).
• If you want to ventilate your seat cushion, press the switch (blue color).
• Each time you press the button, the airflow will change as follows:
OFF HIGH( ) MIDDLE( ) LOW( )

• The seat warmer (with air ventila‐
tion) defaults to the OFF position
whenever the ignition switch is turned on.
CAUTION
When cleaning the seats, do not usean organic solvent such as paintthinner, benzene, alcohol and gaso‐line. Doing so may damage the sur‐face of the heater or seats.
Features of your vehicle
5-156

• Moves focus in all selection me‐nus and selects menus.
*if equipped 14.
FM (Type A-2)
• Changes to FM mode.
• Each time the button is pressed, the mode changed in order of FM1
FM2 FMA.
15.
AM (Type A-2)
• Changes to AM AMA mode.

6-09
6
Audio system

Feature of your audio
1.• Ejects the disc.
2.
RADIO (Type A-3)
• Changes to FM/AM mode.
• Each time the button is pressed, the mode is changed in order of FM1
FM2 AM.
3.
MEDIA
• Changes to CD, UêB (içod ®
), AUX,
My Music *
, BT Audio *
mode.
• Each time the button is pressed, the mode is changed in order of
CD, UêB (içod ®
), AUX, My Music *
,
BT Audio *
.
4.
PHONE (Type A-3) • Operates çhone êcreen.
• When a phone is not connected,
the connection screen is dis‐ played.
5.
SEEK
TRACK
• éadio mode: Automatically
searches for broadcast frequen‐ cies.
• CD, UêB, içod ®
, My Music *
mode
- êhortly press the button: Moves to next or previoussong (file).
- çress and hold the button: ée‐ winds or fast-forwards thecurrent song.
6.
çOWEé/VOL knob • çower knob: Turns power On/Off
by pressing the knob.
• Volume knob: êets volume by turning the knob left/right.
7.1

- çress the button: çreviewseach broadcast for 5 secondseach.
• CD, UêB, My Music *
mode
- çress the button: çreviews each song (file) for 10 secondseach.
- çress the button again to con‐ tinue listening to the currentsong (file).
10.
• êhortly press the button: Moves to the Display, êound, Clock, çhone, êystem setting modes.
• çress and hold the button: Move to the Time setting screen.
11.
MENU
• Displays menus for the current mode.
• içod ®
List: Move to parent cate‐
gory.
12.
FOLDER
• Mç3 CD / UêB mode: Folder êearch.
13.
TUNE knob
• éadio mode: Changes frequency by turning the knob left/right.
* if equipped •
CD, UêB, içod ®
, My Music *
mode:
êearches songs (files) by turning the knob left/right.
When the desired song is dis‐
played, press the knob to playthe song.
• Moves focus in all selection me‐ nus and selects menus.
14.FM (Type A-4)
• Changes to FM mode.
• Each time the button is pressed, the mode changed in order of FM1
FM2.
15.
AM (Type A-4)
• Changes to AM mode.
* if equipped
Before using the audio system
NOTICE
nUsing the Discs
•If the temperature inside the car is
too high, open the car windows to
ventilate before using the system.
•It is illegal to copy and use
Mç3/WMA files without permis‐
sion. Use CDs that are created only
by lawful means.
•Do not apply volatile agents, such
as benzene and thinner, normal
cleaners and magnetic sprays
made for analogue disc onto CDs.
•To prevent the disc surface from
getting damaged, hold CDs by the
edges or the center hole only.
•Clean the disc surface with a piece
of soft cloth before playback (wipe
it from the center to the outside
edge).
(Continued)
Audio system
6-12

(Continued)
•If you want to change the positionof device installation, please in‐quire with your place of purchaseor service maintenance center.Technical expertise is required toinstall or disassemble the device.
•Turn on the car ignition before us‐ing this device. Do not operate theaudio system for long periods oftime with the ignition turned offas such operations may lead tobattery discharge.
•Do not subject the device to severeshock or impact. Direct pressureonto the front side of the monitormay cause damage to the LCD ortouch screen.
•When cleaning the device, makesure to turn off the device and usea dry and smooth cloth. Never usetough materials, chemical cloths,or solvents (alcohol, benzene, thin‐ners, etc.) as such materials maydamage the device panel or causecolor/quality deterioration.
(Continued)
(Continued)
•Do not place beverages close tothe audio system. Spilling beverag‐es may lead to system malfunc‐tion.
•In case of product malfunction,please contact your place of pur‐chase or After Service center.
•Placing the audio system within anelectromagnetic environment mayresult in noise interference.
NOTICE
nUsing the UêB device
•To use an external UêB device,
make sure the device is not con‐
nected when starting up the vehi‐
cle. Connect the device after start‐
ing up.
•If you start the engine when the
UêB device is connected, it may
damage the UêB device. (UêB
flashdrives are very sensitive to
electric shock.)
(Continued)
(Continued)
•If the engine is started up or
turned off while the external UêB
device is connected, the external
UêB device may not work.
•The êystem may not play inau‐
thentic Mç3 or WMA files.
1.It can only play Mç3 files with
the compression rate between
8Kbps ~ 320Kbps.
2.It can only play WMA music files
with the compression rate be‐
tween 8Kbps ~ 320Kbps.
•Take precautions for static elec‐
tricity when connecting or discon‐
necting the external UêB device.
•An encrypted Mç3 çLAYEé is not
recognizable.
•Depending on the condition of the
external UêB device, the connec‐
ted external UêB device can be un‐
recognizable.
(Continued)

6-15
6
Audio system

(Continued)
•If your içhone® is connected to
both the Bluetooth® Wireless
Technology and UêB, the sound
may not be properly played. In
your içhone®, select the Dock con‐
nector or Bluetooth® Wireless
Technology to change the sound
output (source).
•When connecting içod® with the
içod® çower Cable, insert the con‐
nector to the multimedia socket
completely. If not inserted com‐
pletely, communications between
içod® and audio may be interrup‐
ted.
•When adjusting the sound effects
of the içod® and the audio sys‐
tem, the sound effects of both de‐
vices will overlap and might reduce
or distort the quality of the sound.
(Continued)
(Continued)
•Deactivate (turn off) the equalizer
function of an içod® when adjust‐
ing the audio systemL

Commands available during Bluetooth®
Wireless Technology
audio streaming from mobile phone operation Command Op‐
eration.
CommandFunction
çlay çlays the currently paused song.
CommandFunction
çause çauses the current song.
Setup mode (Type A-1, Type
A-2)
With the Display Button
çress the button êelect [Dis‐
play]
Mode çop up
[Mode çop up]
Changes [On] selec‐
tion mode • During On state, press the
RADIO orMEDIA button to display the mode
change pop up screen.
êcroll text
[êcroll text]
êet [On/Off]
• [On]: Maintains scroll
• [Off]: êcrolls only one (1) time.
êong Info
When playing an Mç3 file, select the
desired display info from [Folder/File] or [Album/Artist/êong].
With the sound button
çress the button êelect [êound]

6-37
6
Audio system

The currently used memory is dis‐
played on the left side while the total system memory is displayed on the
right side. ❈ May differ depending on the selec‐
ted audio.
Véê Mode (if equipped)
This feature is used to change voice
command feedback between Normal and Expert modes. êelect [Véê Mode] • Normal : This mode is for beginner users and provides detailed instruc‐
tions during voice command opera‐
tion.
• Expert : This mode is for expert users and omits some information during
voice command operation. (When us‐
ing Expert mode, guidance instruc‐
tions can be heard through the [Help]
or [Menu] commands.
Language
This menu is used to set the display
and voice recognition language. êelect [Language]
The system will reboot after the lan‐ guage is changed. • Language support by region. Dansk, Deutsch, English(UK), Español,
FranG1ais, Italiano, Nederlands, çyc‐
cG4G2G3, çolski, êvenska, TürkG1e
Setup Mode (Type A-3, Type
A-4)
With the Display Button
çress the button êelect [Dis‐
play]
Mode çop up
[Mode çop up]
Changes [On] selec‐
tion mode • During On state, press the
RADIO orMEDIA button to display the mode
change pop up screen.
Text êcroll
[Text êcroll]
êet [On/Off]
• [On]: Maintains scroll
• [Off]: êcrolls only one (1) time.
Media Display
When playing an Mç3 file, select the
desired display info from L