ignition KIA Rio 2005 2.G Owner's Guide

4-11
Transaxle Ranges
O/D (OVERDRIVE) SYSTEM
Pressing the O/D system button cancels and engages
the overdrive system. When the O/D system is can-
celled (button is depressed), the O/D OFF indicator
illuminates and the transaxle gear range is limited to
1st through 3rd. The transaxle will not shift to 4th gear
until the O/D system button is again depressed.
When the ignition is switched OFF, the O/D OFF mode
is automatically cancelled.
WARNING - Automatic
Transaxle
 Before leaving the driver’s seat, always
make sure the shift lever is in the P (PARK)
position; then set the parking brake fully
and shut the engine off. Unexpected and
sudden vehicle movement can occur if these
precautions are not followed in the order
identified.
O/D OFF indicator
This indicator light illuminates in the instrument panel
when the O/D mode is cancelled.
NORMAL OPERATION
P (Park)
This position locks the transaxle and prevents the front
wheels from rotating. Always come to a complete stop
before shifting into this position.
✽
NOTICE
If the O/D OFF indicator flashes, it indicates an
electrical problem with the transaxle. Should this
occur, have the vehicle checked by an Authorized
Kia Dealer as soon as possible.
WARNING
Shifting into P (Park) while the vehicle is in
motion will cause the front wheels to lock and
you will lose driving control of the vehicle.
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 11

Driving Your Vehicle4-12
R (Reverse)
Use this position to drive the vehicle backward.
N (Neutral)
In this position, the wheels and transaxle are not
locked. The vehicle will roll freely even on the slight-
est incline unless the parking brake or service brakes
are applied.
D (Drive)
This is the normal forward driving position. The
transaxle will automatically shift through a four-gear
sequence, providing the best fuel economy and power.
For extra power when passing another vehicle or
climbing steep grades, depress the accelerator fully, at
which time the transaxle will automatically downshift
into the next lower gear.
CAUTION
Always come to a complete stop before shifting
into or out of R (Reverse). You may damage the
transaxle if you shift into R while the vehicle is in
motion, except as explained in “Rocking the
Ve h i c l e .’’
✽
NOTICE
The transaxle may be damaged if you shift into
P (Park) while the vehicle is in motion.
WARNING
 Do not use the P (Park) position in place of
the parking brake when leaving the vehicle.
Always make sure the shift lever is latched
in the P (Park) position so that it cannot be
moved unless the lock release button is
pushed in AND the parking brake is fully
set.
 Turn the ignition switch OFF whenever you
leave the vehicle unattended. Never leave the
vehicle unattended while the engine is run-
ning. Unexpected and sudden vehicle move-
ment may occur if these precautions are not
taken.
 Never leave a child unattended in a vehicle.
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 12

4-13
For improved engine performance, the transaxle will
not shift into 4th gear until the engine coolant reaches
normal operation temperature.
2 (2nd)
Move shift lever to this position for driving in heavy,
slow-moving traffic or when climbing hills. This posi-
tion also provides engine braking when going down
hills and helps reduce wheel spin on slippery surfaces.
1 (1st)
Move the shift lever to this position in hard pulling sit-
uations and for climbing or descending steep grades.
Moving Up a Steep Grade from a Standing
Start
To move up a steep grade from a standing start,
depress the brake pedal, shift the shift lever to
D (Drive), 2 (2nd), or 1 (1st). Select the appropriate
gear depending on load weight and steepness of the
grade, and release the parking brake. Depress the
accelerator gradually while releasing the service
brakes.Shift Lock System
For your safety, the Automatic Transaxle has a shift
lock system which prevents shifting the transaxle out
of P (Park) unless the brake pedal is depressed.
To shift the transaxle out of P (Park):
1. Depress and hold the brake pedal.
2. Start the engine or turn the ignition key to the ON
position.
3. Depress the lock release button and move the shift
lever.
When the ignition switch is in the ACC or LOCK posi-
tion, the transaxle cannot be shifted from P (Park).
If the brake pedal is repeatedly depressed and released
with the shift lever in the P (Park) position, a chatter-
ing noise near the shift lever may be heard.
This is a normal condition.
Also, the ignition key cannot be removed unless the
shift lever is in the P (Park) position. If the ignition
switch is in any other position, the key cannot be
removed.
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 13

4-25
GaugesSpeedometerThe speedometer indicates the forward speed of the
vehicle.Odometer/TripmeterYou can choose the odometer, Tripmeter A and
Tripmeter B by pressing the mode selection button.OdometerThe odometer indicates the total distance the vehicle has
been driven.Tripmeter (If equipped)TRIP A : Tripmeter A
TRIP B : Tripmeter B
The tripmeter indicates the distance on individual trips
selected by the driver. Tripmeter A and B can be reset to
zero by pressing the mode selection button for one
second or more, then releasing.
Tachometer (If Equipped)The tachometer indicates the approximate number of
engine revolutions per minute (rpm).
Use the tachometer to select the correct shift points
and prevent lugging the engine and/or over-revving it.
The tachometer pointer may move slightly when the
ignition switch is in the ACC or ON position with the
engine OFF. This movement is normal and will not
affect the accuracy of the tachometer once the engine
is running.
0 1234567
8
1000rpm
✽
NOTICE
Do not operate the engine within the tachometer’s
RED ZONE.
This may cause severe engine damage.
1B3105004A
redzone
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 25

Driving Your Vehicle4-26 Fuel GaugeThe fuel gauge indicates the approximate amount of
fuel remaining in the fuel tank.
Fuel tank capacity: 45 L (11.7 US gal.)
The fuel gauge is supplemented by a low fuel warning
light located in the instrument panel.
This gauge is designed to continue indicating the
amount of fuel remaining in the fuel tank even after the
ignition switch has been turned to OFF.
Engine Temperature GaugeThis gauge shows the temperature of the engine
coolant when the ignition switch is ON.
If the gauge pointer moves beyond the normal range
area toward the H position, it indicates overheating that
may damage the engine.
Do not continue driving with an overheated engine.
If your vehicle overheats, refer to “Overheating’’ in the
Index.
1B3105005
1B3105006
With Tachometer
Without Tachometer
With Tachometer
Without Tachometer
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 26

4-27 Instrument Panel Illumination (If equipped)
When the vehicle’s parking lights or headlights are
ON, rotate the illumination control knob to adjust the
instrument panel illumination intensity.
Warnings and IndicatorsWarning Lights/Audible IndicatorsChecking Operation
All the warning lights are checked by turning the igni-
tion switch ON (you do not need to start the engine).
Any light that does not come ON should be checked
by an Authorized Kia Dealer.
After starting the engine, check to make sure that all
warning lights are OFF. If any are still ON, this indi-
cates a situation that needs attention. When releasing
the parking brake, the brake system warning light
should go OFF.Parking Brake and Brake Fluid
Warning Parking Brake Warning
This light comes ON when the parking brake is applied
with the ignition switch in the START or ON position.
The warning light should go OFF when the parking
brake is released.
2FDA407
BRAKE
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 27

Driving Your Vehicle4-28Low Brake Fluid Level Warning
If the warning light remains ON when the parking
brake is released, it may indicate that the brake fluid
level in the reservoir is low.
If the warning light remains ON:
1. Drive to the nearest safe location and carefully stop
your vehicle.
2. With the engine stopped, check the brake fluid level
immediately and add fluid as required. All brake
components should also be checked immediately
for fluid leaks.
3. If leaks are found, if the warning light remains ON,
or if the brakes do not operate properly, do not
drive the vehicle. Have it towed to an Authorized
Kia Dealer for a brake system inspection and nec-
essary repairs.To check bulb operation, the warning light illuminates
when the ignition switch is in the ON position.
Safety Belt Warning As a reminder to the driver and passenger, safety belt
warning light will illuminate for approximately 6 sec-
onds each time you turn the ignition switch ON.
If the driver’s lap/shoulder belt is not fastened when
the key is turned ON, a chime sounds for approximate-
ly six seconds and the safety belt warning light illumi-
nates for approximately six seconds. If the system does
not operate as described, see an Authorized Kia Dealer
for assistance.Air Bag Warning This warning light will remain ON for approximately
6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the
light comes on while the vehicle is being driven, see an
Authorized Kia Dealer for immediate assistance.Charging System Warning This warning light indicates a malfunction of either the
generator or electrical charging system.
–
+
WARNING - Brake Warning
Lights
Driving the vehicle with a warning light ON is
dangerous. If the brake warning light remains
ON, have the brakes checked and repaired
immediately.
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 28

Driving Your Vehicle4-32Key Reminder Warning Chime
If the driver’s door is opened and the ignition key is
left in the ignition switch, the key reminder warning
chime will sound. This is to remind you to remove
your keys from the ignition before you lock the vehi-
cle.Lights-On Warning ChimeThe lights-on warning chime will sound if the head-
light switch is left in the 1st or 2nd position and the
door is opened.Headlight High Beam Indicator This indicator illuminates when the headlights are on
and in the high beam position or when the turn signal
lever is pulled into the Flash-to-Pass position.O/D OFF Indicator
(automatic transaxle)This indicator comes on when the O/D system is
deactivated.
✽
NOTICE
A loose fuel filler cap may cause the On Board
DiagnosticSystem Malfunction Indicator Light
( ) in the instrument panel to illuminate
unnecessarily. Always make sure that the fuel
filler cap is tight.
CHECK
CHECK
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 32

4-33 Door Ajar Warning
This warning light comes on when a door is not closed
securely with the ignition switch in any position.Anti-Lock Brake System (ABS)
Warning Light (if equipped)This light illuminates when you start the engine. The
light will go off if the ABS system is operating nor-
mally. Also, this light comes on if the key is turned to
ON, and then goes off in 2-3 seconds if the system is
operating normally.
If this warning light illuminates while the vehicle is
being driven, have the vehicle checked by an autho-
rized Kia Dealer as soon as possible.Rear Window Defroster Indicator This light comes on when the rear defroster is ON.Rear Hatch Warning Light
(5 door-if equipped)This warning light comes on when a rear hatch is not
closed securely with the ignition switch in any posi-
tion.
AS2B04020
LightingLighting ControlTo turn the lights on, twist the knob on the end of the
control lever which is located on the steering column
to the left of the steering wheel.
First position
Tail, parking, license and sidemarker lights and instru-
ment panel lights ON.
Second position
Head, tail, parking, license and sidemarker lights and
instrument panel lights ON.
ABS
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 33

4-35 Turn Signals
The same lever that controls the headlights also con-
trols the turn signals.
The ignition switch must be ON for the turn signals
to function. Move the lever up or down to activate the
turn signals. The turn signals will self-cancel after a
turn is completed. If the indicator continues to flash
after a turn, manually return the lever to the OFF (mid-
dle) position.
Lane Change Signals
To signal a lane change, move the turn signal lever
slightly and hold it in position. The lever will return to
the OFF (middle) position when released.
Green arrow indicators on the instrument panel indi-
cate which turn signal is operating. If an indicator
stays ON and does not flash or if it flashes abnormally,
one or more of the turn signal bulbs may be burned out
and will require replacement.Daytime Running Lights (DRL)Daytime Running Lights (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving condi-
tions, but they can be especially helpful in the short
periods after dawn and before sunset. The DRL system
will make your low-beam headlights turn OFF when:
 The headlight switch is ON.
 The parking brake is engaged.
 The engine stops.
AS2B04023
RIO ENG CNA 4.qxd 7/29/05 5:06 PM Page 35