recommended oil KIA Sorento 2006 1.G Owner's Manual

ENGINE OIL AND OIL
FILTERChecking the Engine Oil Level
1. Be sure the vehicle is on level
ground.
2. Start the engine and allow it to
reach normal operating tempera-
ture.
3. Turn the engine off and wait a few
minutes for the oil to return to the
oil pan.
4. Pull the dipstick out, wipe it clean,
and re-insert it fully.
5. Pull the dipstick out again and
check the level. The level should be
between F and L.
If the level is near or at L, add enough
oil to bring the level to F.Do not over-
fill.Use only the specified engine oil.
(Refer to “Recommended Lubricants’’
later in this section.)Changing the Engine Oil and
Filter
Change engine oil and filter accord-
ing to the Scheduled Maintenance at
the beginning of this section.
MAINTENANCE
7-9
OK
FL
S2BLC705A
WARNING
- Engine Oil
Continuous contact with USED
engine oil has caused skin can-
cer in laboratory mice. Protect
your skin by washing with soap
and water. Keep all engine oil
out of reach of children.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 9

Oil capacity
Without filter change : 4.0 liters
With filter change : 4.3 liters
Use only the specified Service Grade
engine oil. (Refer to “Recommended
Lubricants” later in this section.) MAINTENANCE7-10
✽ ✽
NOTICEAlthough oil filters may have the
same external appearance, their
internal designs differ significantly.
These filters are not interchange-
able. To avoid potential engine
damage, use only the specified filter.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 10

LUBRICANT
SPECIFICATIONSRecommended Lubricants
To help achieve proper engine and
powertrain performance and durabili-
ty, use only lubricants of the proper
quality. The correct lubricants also
help promote engine efficiency that
results in improved fuel economy.
Engine oils labeled Energy
Conserving Oil are now available.
Along with other additional benefits,
they contribute to fuel economy by
reducing the amount of fuel neces-
sary to overcome engine friction.
Often, these improvements are diffi-
cult to measure in everyday driving,
but in a year’s time, they can offer sig-
nificant cost and energy savings.
MAINTENANCE
7-41
*¹ Refer to the recommended SAE viscosity numbers on the next page.These lubricants and fluids are recommended for use in your vehicle.
Lubricant Classification
Engine oil *¹
API Service SJ, SL or above
ILSAC GF-3 or above
Manual transmission fluid API Service GL-4 (SAE 75W-85)
Automatic 30-40LEi MOBIL D-II
transmission fluid A5SR1 APOLLOIL ATF RED-1
4WD transfer case fluid DEXRON III
Front differential fluid API Service GL-5 (SAE 90)
Rear differential fluid
without LSD
API Service GL-5 (SAE 90)
with LSD
API Service GL-5 (SAE 85W-90, INFILREX 33)
Power steering fluid PSF-III
Brake / clutch fluid FMVSS116 DOT-3 or DOT-4
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 41

Recommended SAE Viscosity
Number
Engine oil viscosity (thickness) has
an effect on fuel economy and cold
weather operating (starting and oil
flow). Lower viscosity engine oils can
provide better fuel economy and cold
weather performance, however, high-
er viscosity engine oils are required
for satisfactory lubrication in hot
weather. Using oils of any viscosity
other than those recommended could
result in engine damage.MAINTENANCE7-42✽ ✽
NOTICEAlways be sure to clean the area
around any filler plug, drain plug,
or dipstick before checking or
draining any lubricant. This is
especially important in dusty or
sandy areas and when the vehicle is
used on unpaved roads. Cleaning
the plug and dipstick areas will pre-
vent dirt and grit from entering the
engine and other mechanisms that
could be damaged.
When choosing an oil, consider the range of temperature your vehicle will be
operated in before the next oil change. Proceed to select the recommended
oil viscosity from the chart.
Temperature Range for SAE Viscosity Numbers
Temperature
Gasoline
Engine Oil °C
(°F)
-30 -20 -10 0 10 20 30 40 50
-10 0 20 40 60 80 100 120
10W-30
5W-20, 5W-30
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 42

INTERIOR CAREInterior General Precautions
Prevent caustic solutions such as
perfume and cosmetic oil from con-
tacting the dashboard because they
may cause damage or discoloration.
If they do contact the dashboard,
wipe them off immediately. See the
instructions that follow for the proper
way to clean vinyl.
Cleaning the Upholstery and
Interior Trim
Vinyl
Remove dust and loose dirt from
vinyl with a whisk broom or vacuum
cleaner. Clean vinyl surfaces with a
vinyl cleaner.Fabric
Remove dust and loose dirt from fab-
ric with a whisk broom or vacuum
cleaner. Clean with a mild soap solu-
tion recommended for upholstery or
carpets. Remove fresh spots immedi-
ately with a fabric spot cleaner. If
fresh spots do not receive immediate
attention, the fabric can be stained
and its color can be affected. Also, its
fire-resistant properties can be
reduced if the material is not properly
maintained.Cleaning the Lap/Shoulder Belt
Webbing
Clean the belt webbing with any mild
soap solution recommended for
cleaning upholstery or carpet. Follow
the instructions provided with the
soap. Do not bleach or re-dye the
webbing because this may weaken it.
Cleaning the Interior Window
Glass
If the interior glass surfaces of the
vehicle become fogged (that is, cov-
ered with an oily, greasy or waxy
film), they should be cleaned with
glass cleaner. Follow the directions
on the glass cleaner container.
MAINTENANCE
7-47
CAUTION
Using anything but recom-
mended cleaners and proce-
dures may affect the fabric’s
appearance and fire-resistant
properties.
✽ ✽
NOTICEDo not scrape or scratch the inside
of the rear window. This may result
in damage to the rear window
defroster grid.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 47