lights Lancia Delta 2008 Owner handbook (in English)

IN AN EMERGENCY177
4
LED
LED
D1S(*) / H7
H1(*) / H7
PY 24W
LED
WY5W
LED
LED
W5W
H11
W16W
W16W
5L/5K
12V 5W
12V 5W
W5W–
–
D
D
B
–
A
–
–
C
E
B
B
–
C
C
A–
–
55W
55W
24W
–
5W
–
–
5W
55W
16W
16W
–
5W
5W
5W
(*) Xenon gas discharge bulb
Bulb Type Power Ref. figure
Front side lights/Daylight lights
Rear side lights
Dipped beams
Main beams
Front direction indicators
Rear direction indicators
Side direction indicators
Brake light
3rd brake light
Number plate light
Fog lights
Rear fog lights
Reversing light
Front courtesy light (white LED’s)
Rear courtesy light
Glove compartment/luggage compartment
courtesy light
Door lights

178IN AN EMERGENCY
REPLACING EXTERIOR BULBS
FRONT LIGHT CLUSTERS fig. 15
These contain the bulbs for the dipped beams, main beams
and direction indicators. The bulbs are arranged as fol-
lows:
A. Main beam headlights;
B. Dipped beam headlights;
C. Direction indicators.DIPPED BEAM HEADLIGHTS
With incandescent bulbs
To change the bulb, proceed as follows:
remove the protective cover B-fig. 15;
release the bulb holder clip A-fig. 16;
disconnect the electrical connector B;
remove the bulb C and replace it;
fit the new bulb, ensuring that the outline of the met-
al part coincides with the grooves on the curve of the
headlight. Then reconnect the electrical connector B
and reattach the bulb holding clip A;
refit the protective cover A-fig. 15.
fig. 15L0E0154mfig. 16L0E0155m

IN AN EMERGENCY179
4
With gas discharge bulbs (Xenon)
(where provided)
MAIN BEAM HEADLIGHTS
With incandescent bulbs
To change the bulb, proceed as follows:
remove the protective cover A-fig. 15;
release the bulb holder clip A-fig. 17;
disconnect the electrical connector B;
remove the bulb C and replace it;
fit the new bulb, ensuring that the outline of the met-
al part coincides with the grooves on the curve of the
headlight. Then reconnect the electrical connector B
and reattach the bulb holding clip A;
refit the protective cover B-fig. 15.
fig. 17L0E0156m
Due to the high power supply voltage, gas
discharge bulbs (Xenon) should only be re-
placed by specialised personnel: risk of death!
Contact a Lancia Dealership.
With gas discharge bulbs (Xenon)
(where provided)
Due to the high power supply voltage, gas
discharge bulbs (Xenon) should only be re-
placed by specialised personnel: risk of death!
Contact a Lancia Dealership.

180IN AN EMERGENCY
SIDELIGHTS/DAYTIME LIGHTS
The direction indicators/daylight lights are LED-based.
Contact a Lancia dealership to have there lights replaced.
DIRECTION INDICATORS
Front indicators
To change the bulb, proceed as follows:
remove the protective cover C-fig. 15;
press down near the bulb holder locking tabs (shown
in fig. 18 by the arrows) and simultaneously pull the
unit;
remove the bulb A and replace it;
refit the protective cover C.Side indicators
To change the bulb, proceed as follows:
work on lens A-fig. 19 to compress catch B, then pull
the unit outwards;
turn the bulb holder C, anticlockwise, extract the press-
fitted bulb D and replace it;
refit the bulb holder C in the lens and turn it clock-
wise;
refit the unit making sure that internal catch B clips
into position.
fig. 18L0E0157mfig. 19L0E0158m

IN AN EMERGENCY181
4
FRONT FOG LIGHTS fig. 20 (where provided)
To replace the bulbs in the front fog lights you must con-
tact a Lancia Dealership.
REAR LIGHT CLUSTERS
Contact a Lancia Dealership to replace the LED lights in
the rear light clusters.
REVERSING LIGHTS fig. 21
To replace the bulbs in the reversing lights you must con-
tact a Lancia Dealership.REAR FOG LIGHTS fig. 22
To replace the bulbs in the rear fog lights you must con-
tact a Lancia Dealership.
fig. 20L0E0159mfig. 22L0E0161m
fig. 21L0E0160m

182IN AN EMERGENCY
THIRD BRAKE LIGHT fig. 23
Contact a Lancia Dealership to replace the LED lights in
the third brake light.
NUMBER PLATE LIGHTS
To change the bulb proceed as follows:
operate in the area shown by the arrows and remove
the lens cover unit A-fig. 24;
fig. 23L0E0162mfig. 25L0E0164m
fig. 24L0E0163m
turn the bulb holder B-fig. 25 anti-clockwise;
remove the bulb C and replace it.

IN AN EMERGENCY191
4
FUSE SUMMARY TABLE - Dashboard control unit
F12
F12
F13
F13
F31
F32
F33
F34
F35
F36
F37
F38
F39
F40
F417.5
15
7.5
15
5
–
20
20
5
20
7.5
10
10
30
7.538
38
38
38
38
–
38
38
38
38
38
38
38
38
38
CONSUMERS FUSE AMPERE DIAGRAM
Right dipped beam headlight
Right dipped beam headlight (Xenon gas discharge bulb)
Left dipped beam headlight, headlight alignment corrector
Left dipped beam headlight (Xenon gas discharge bulb)
Climate control system fan relay coil, body computer
Spare
Left rear electric window
Right rear electric window
Reversing lights, engine compartment control unit relay coils,
brake light pedal control (normally closed contact),
water in the diesel fuel sensor, air flow meter
Central locking system control unit, fuel
butterfly, dead lock, tailgate release
Third brake light, instrument panel, Adaptive Headlights Node,
control unit on left-hand gas discharge headlight
Rear and front courtesy ligths (where fitted), sun visor lights,
glove compartment ligtht and luggage compartment light
Radio, radio-navigator, Blue&Me Node, alarm siren,
alarm system on courtesy light, climate control unit, tyre
pressure detection control unit, diagnostic connector,
rear courtesy light
Heated rear window
Electric door mirror demisters, demisters
on windscreen jets

IN AN EMERGENCY193
4
–
40
40
40
40
40
40
40
40
40
40
40
40
40
40
40F08
F09
F10
F11
F14
F15
F16
F17
F18
F19
F22
F22
F23
F24
F30
F85–
20
10
10
15
30
7.5
10
7.5
7.5
15
20
20
5
15
15
FUSE SUMMARY TABLE - Engine compartment control unit
CONSUMERS FUSE AMPERE DIAGRAM
Spare
Headlight washer pump
Horn
Electronic injection secondary loads
Main beam headlights
PTC1 additional heater
Engine Management Node
Electronic injection primary loads
Engine Management Node
Air conditioning compressor
Electronic injection primary loads (1.4 engine)
Electronic injection primary loads (1.8 and diesel engine)
Brake Node (valves)
Electric Steering Node
Fog/cornering lights
Fuel pump

CARE AND MAINTENANCE199
5
SCHEDULED SERVICING PLAN
Petrol versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication;
Check and top up, if required, fluid levels (engine coolant, brake/hydraulic
clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
visually inspect the condition of the accessory drive belt
Visually inspect the condition of the toothed timing drive belt30 60 90 120 150 180
    
    
    
    
    
    
    
    
    
    



CARE AND MAINTENANCE201
5
Diesel versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad seal condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication
Check and top up, if required, fluid levels
(engine coolant, brake/hydraulic clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
Check and if necessary adjust the auxiliary
drive belts (excluding engines equipped with automatic tensioners)
Check exhaust fumes/emissions
Visually inspect the condition of the auxiliary drive belt35 70 105 140 175