low beam Lancia Delta 2008 Owner handbook (in English)

20GETTING TO KNOW YOUR CAR
Daylight lights/dipped beam headlights
(green)
This warning light comes on when the daytime
lights or dipped beam headlights are turned on.
Follow me home
This warning light comes on when this device is activat-
ed (see “Follow me home” in chapter “1”).
The display will show a dedicated message.
3
Main beam headlights (blue)
This warning light comes on when the main
beam headlights are turned on.
1
Cruise control system
(where provided) (green)
This warning light comes on when the ignition
key is turned to MAR, but it should go off after
a few seconds. The warning light is lit up on the display
by rotating the Cruise Control selector wheel to ON.
The display will show a dedicated message.
Ü
DISPLAY
The car can be equipped with a multifunctional/ recon-
figurable multifunctional display which, according to the
settings carried out, will show useful information when
driving.
MULTIFUNCTIONAL DISPLAY “STANDARD”
SCREEN fig. 4
The standard screen shows the following information:
A. Date
B. Possible activation of Dualdrive electric power steering
C. Sport driving mode indication (where provided)
D. Time
E. Odometer (distance travelled in kilometres/miles)
F. Possible presence of ice on road
G. Outside temperature
H. Scheduled servicing deadline
I. Headlight alignment position (with dipped beam head-
lights on only).

GETTING TO KNOW YOUR CAR21
1
On some versions the display shows the turbine pressure
fig. 5 when the “engine info ” menu item is selected and
the key is turned to MAR.
fig. 4L0E1000g
fig. 5L0E0004mfig. 6L0E1001g
RECONFIGURABLE MULTIFUNCTIONAL
DISPLAY “STANDARD” SCREEN fig. 6
The standard screen shows the following information:
A. Time
B. Date
C. Sport driving mode indication (where provided)
D. Odometer (distance travelled in kilometres/miles)
E. Car status (e.g. doors open, ice on road, etc.)
F. Headlight alignment position (with dipped beam head-
lights on only).
G. Outside temperature

GETTING TO KNOW YOUR CAR61
1
Deactivation
When the lights are switched off by the sensor, the dipped
beam headlights and side lights are switched off and the
daylight lights are switched on (if activated).
The sensor cannot detect the presence of fog: switch the
lights on manually in this case.
FRONT FOG LIGHTS WITH CORNERING LIGHTS
FUNCTION
When travelling at a speed of less than 40 km/h with the
dipped beam headlights on, when the steering wheel is
turned at a wide angle or the direction indicators are lit
up, a light (built into the front fog lights) will be activat-
ed on the side of the turn to increase night time visibility.
This function can be switched on/off using the display
menus (see “Display” section in this chapter). AUTOMATIC HEADLIGHT SENSOR
(dusk sensor) fig. 27 (where provided)
This sensor detects changes in external light levels ac-
cording to the sensitivity of the setting: the higher the sen-
sitivity, the lower the amount of external light needed to
switch the lights on. The sensitivity of the dusk sensor may
be adjusted, using the “Set-up menu” on the instrument
panel.
Activation
Turn the selector wheel to AUTO: in this way the external
lighting will switch on automatically according to the out-
side light level.
The headlights can only be flashed with the sensor on.The daytime lights are an alternative to the
dipped beam headlights for driving during
the daytime. They are compliant in countries
where is it obligatory to have lights on during the
day and permitted in those where it is not obliga-
tory Daytime lights cannot replace dipped beam
headlights when driving at night or through tunnels.
The use of daytime lights is governed by the High-
way Code of the country you are in. Keep to the
rules.

GETTING TO KNOW YOUR CAR69
1
Environmental lights are provided as part of the cour-
tesy light; these illuminate the vehicle when the dipped
beam headlights or side lights are switched on.
IMPORTANT Before getting out of the car, make sure that
both switches are in the central position: lights off with
doors closed in order to avoid draining the battery. In any
case, if the switch is left inadvertently in the On position,
the lights will turn off automatically 15 minutes after turn-
ing the engine off.
Courtesy light timing
To facilitate getting in/out of the car at night or with poor
lighting, 2 different timed switching on modes have been
provided.
Light timing when getting into the car
The courtesy lights will turn on as follows:
for about 10 seconds when the front doors are un-
locked;
for about 3 minutes when one of the side doors is
opened;
for about 10 seconds when the doors are closed.
Timing is interrupted when the ignition key is turned to
MAR.Light timing when getting out of the car
After removing the key from the ignition switch, the cour-
tesy lights will turn on as follows:
within 2 minutes of turning the engine off, for about
10 seconds;
for about 3 minutes when one of the side doors is
opened;
for about 10 seconds when one of the doors is closed.
in the event of the fuel cut-off system cutting in, the
lights remain on for approximately 15 minutes, after
which they go out automatically.
The lights go out immediately when the doors are locked
(unless the fuel cut-off system has cut in.).
fig. 33L0E0025m

178IN AN EMERGENCY
REPLACING EXTERIOR BULBS
FRONT LIGHT CLUSTERS fig. 15
These contain the bulbs for the dipped beams, main beams
and direction indicators. The bulbs are arranged as fol-
lows:
A. Main beam headlights;
B. Dipped beam headlights;
C. Direction indicators.DIPPED BEAM HEADLIGHTS
With incandescent bulbs
To change the bulb, proceed as follows:
remove the protective cover B-fig. 15;
release the bulb holder clip A-fig. 16;
disconnect the electrical connector B;
remove the bulb C and replace it;
fit the new bulb, ensuring that the outline of the met-
al part coincides with the grooves on the curve of the
headlight. Then reconnect the electrical connector B
and reattach the bulb holding clip A;
refit the protective cover A-fig. 15.
fig. 15L0E0154mfig. 16L0E0155m

IN AN EMERGENCY179
4
With gas discharge bulbs (Xenon)
(where provided)
MAIN BEAM HEADLIGHTS
With incandescent bulbs
To change the bulb, proceed as follows:
remove the protective cover A-fig. 15;
release the bulb holder clip A-fig. 17;
disconnect the electrical connector B;
remove the bulb C and replace it;
fit the new bulb, ensuring that the outline of the met-
al part coincides with the grooves on the curve of the
headlight. Then reconnect the electrical connector B
and reattach the bulb holding clip A;
refit the protective cover B-fig. 15.
fig. 17L0E0156m
Due to the high power supply voltage, gas
discharge bulbs (Xenon) should only be re-
placed by specialised personnel: risk of death!
Contact a Lancia Dealership.
With gas discharge bulbs (Xenon)
(where provided)
Due to the high power supply voltage, gas
discharge bulbs (Xenon) should only be re-
placed by specialised personnel: risk of death!
Contact a Lancia Dealership.

IN AN EMERGENCY191
4
FUSE SUMMARY TABLE - Dashboard control unit
F12
F12
F13
F13
F31
F32
F33
F34
F35
F36
F37
F38
F39
F40
F417.5
15
7.5
15
5
–
20
20
5
20
7.5
10
10
30
7.538
38
38
38
38
–
38
38
38
38
38
38
38
38
38
CONSUMERS FUSE AMPERE DIAGRAM
Right dipped beam headlight
Right dipped beam headlight (Xenon gas discharge bulb)
Left dipped beam headlight, headlight alignment corrector
Left dipped beam headlight (Xenon gas discharge bulb)
Climate control system fan relay coil, body computer
Spare
Left rear electric window
Right rear electric window
Reversing lights, engine compartment control unit relay coils,
brake light pedal control (normally closed contact),
water in the diesel fuel sensor, air flow meter
Central locking system control unit, fuel
butterfly, dead lock, tailgate release
Third brake light, instrument panel, Adaptive Headlights Node,
control unit on left-hand gas discharge headlight
Rear and front courtesy ligths (where fitted), sun visor lights,
glove compartment ligtht and luggage compartment light
Radio, radio-navigator, Blue&Me Node, alarm siren,
alarm system on courtesy light, climate control unit, tyre
pressure detection control unit, diagnostic connector,
rear courtesy light
Heated rear window
Electric door mirror demisters, demisters
on windscreen jets

226TECHNICAL DATA
IDENTIFICATION DATA
The vehicle identification details are fig. 1:
A Identification plate (located in the engine compartment,
next to the upper attachment for the right-hand shock
absorber);
B Bodywork label (located on the passenger compartment
floor panel, next to the front passenger seat);
C Body paintwork identification label (located on the in-
side the tailgate);
D Engine label (located in the rear left-hand part, gear-
box-side).IDENTIFICATION PLATE fig. 2
This plate is applied to the engine compartment front
beam and shows the following identification data:
B Homologation number.
C Vehicle type code.
D Chassis manufacturing serial number.
E Maximum vehicle weight fully loaded.
F Maximum vehicle weight fully loaded with trailer.
G Maximum vehicle weight on front axle.
H Maximum vehicle weight on rear axle.
I Engine type.
L Body version code.
M Spare part code.
N Smoke opacity index (for diesel engines).
fig. 1L0E0116mfig. 2L0E0117m