language Lancia Delta 2015 Owner handbook (in English)

36KNOWING YOUR CAR
Language (Lang uage selection)
Dis play messages can be shown in different languages : Ital-
ian, German, Englis h, Spanis h, French, Portugues e and
Dutch.
To set the des ired language, proceed a s follows :
– briefly press the button S ET: the previously s et language
s tarts flashing on the di splay ;
– pre ss
Õor Ôto make y our choice;
– briefly press the S ET button to go back to the menu
s creen or hold the button down to go back to the standard
s creen without s aving.
Warning s volume (Adjustin g the failure/warnin g
acoustic sig nal volume)
With this function the volume of the acous tic signal which
accompanies the display of failure/warning can be ad-
jus ted according to 8 level s.
To set the des ired volume, proceed a s follows :
– press the S ET button briefly , making the display flash
the previous ly s et volume level;
– press
Õor Ôto adjus t the value;
– briefly press SET to go back to the menu screen or hold
the button down to go back to the standard screen with-
out saving. Button volume (Adjustin
g the button volume)
This function enables y ou to adjus t the volume of the
acous tic signal (8 s ettings) accompany ing the activation
of buttons SET,
Õand Ô.
To set the des ired volume, proceed a s follows :
– press the S ET button briefly , making the display flash
the previous ly s et volume level;
– press
Õor Ôto adjus t the value;
– briefly press the S ET button to go back to the menu
s creen or hold the button down to go back to the standard
s creen without s aving.
Belt reminder
(Buzzer/reactivation for SBR indication)
This function is only display ed after a Lancia Dealer ship
has deactivated the S BR (see SBR paragraph, chapter
“2”).
S ervice (S cheduled servicin g)
This function allow s y ou to dis play the information about
km/mileage intervals or, for versions/markets , where
provided, time interval s for car s ervicing.
001-154 Delta GB 1ed 03/03/14 10.00 Pagina 36

Never remove or cover the label. Never apply
a hub cap on a space-saver wheel. The la-
bel bears the following instructions in four
languages: WARNING! FOR TEMPORARY USE
ONLY! 80 KM/H MAX.! REPLACE WITH STAN-
DARD WHEEL AS SOON AS POSSIBLE. DO NOT
COVER THIS LABEL.
If you change the type of wheel (alloy rims instead
of steel rims) you will have to change the entire set
of fastening bolts with another set of suitably sized
bolts.
Alert other drivers that the car is stationary
in compliance with local regulations: hazard
warning lights, warning triangle, etc. Any
passengers on board should leave the car, especial-
ly if it is heavily laden. Passengers should stay
away from on-coming traffic while the wheel is be-
ing changed. If parked on a slope or rough surface,
chock the wheels with wedges or other suitable de-
vices.
204IN AN EMERGENCY
The jack can only be used for changing
wheels on the car with which it is provided
or on cars of the same model. Never use the
jack for other purposes, such as lifting other car
models. Never use it for repair operations under the
car. Incorrect positioning of the jack may cause the
car to fall. Do not use the jack for loads higher than
those shown on the label. Snow chains cannot be fit-
ted to the space-saver wheel. Therefore, if a front
(drive) wheel is punctured and chains are required,
a rear wheel should be fitted at the front of the car
and the space-saver wheel should be fitted to the
rear. This way, with two normal front driving
wheels, you can install the snow chains on them,
thus resolving the emergency.
If the hub cap is not installed properly, it may
detach when the vehicle is running. Never
tamper with the inflation valve. Never intro-
duce tools of any kind between rim and tyre. Reg-
ularly check tyre and space-saver wheel pressure,
complying with the data in the chapter “6”.
195-232 Delta GB 1ed 03/03/14 09.14 Pagina 204