open bonnet Lancia Musa 2010 Owner handbook (in English)

82
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
BONNET
OPENING
Proceed as follows:
❒pull lever A-fig. 106in the direc-
tion of the arrow;
❒move lever B-fig. 108 in the di-
rection of the arrow;
❒lift the bonnet and at the same
time release the rod C-fig. 107
from the catch, then fit end Dof
the rod into the bonnet recess E.
IMPORTANT Before opening the
bonnet, check that windscreen wiper
arms are not lifted from the wind-
screen.
fig. 106L0D0113m
fig. 107L0C0115m
fig. 108L0D0392m
The bonnet must always
be perfectly closed while
travelling for reasons of safety.
Make sure that the bonnet is per-
fectly closed and that the lock is
engaged. If you discover that the
bonnet is not perfectly closed while
travelling, stop immediately and
close the bonnet in the correct
manner.
WARNING

83
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
CLOSING fig. 107
Proceed as follows:
❒hold the bonnet up with one hand
and with the other remove rod
Cfrom recess and fit it back into
its catchD;
❒lower the bonnet to approximately
20 centimetres from the engine
compartment and let it come down.
Make sure that the bonnet is com-
pletely closed and not only fastened
by the safety catch by trying to
open it. If it is not perfectly closed,
open the bonnet and repeat the
procedure. No not simply press it.
IMPORTANT Always check that the
bonnet is closed properly to avoid its
opening while the car is travelling.ROOF BARS
(for versions/markets, where provided)
IMPORTANT Use of Lineaccessori
Lancia roof bars is recommended.
Follow the instructions contained in
the assembly kit to the letter. Assem-
bly must be performed by qualified
personnel.
The bonnet may drop sud-
denly if the supporting rod
is not in correct position.
WARNING
Perform these operations
when the car is stationary
only.
WARNING
fig. 109L0D0248m
IMPORTANT Never exceed the per-
mitted weight (see section “Technical
specifications”).
Check that the attachment fastening
screws are correctly positioned after a
few kilometres.

184
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICA-
TIONS
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
IN
EMERGENZA
MAINTENANCE
AND CARE
To correctly wash the car:
❒remove the aerial from the roof to
prevent damage to it if the car is
washed in an automatic system;
❒wash the body using a low pres-
sure jet of water;
❒wipe a sponge with a slightly soapy
solution over the bodywork, fre-
quently rinsing with the sponge;
❒rinse well with water and dry with
a jet of air or a chamois leather.
Dry the parts less in sight particularly
carefully, such as the door frames and
the headlight frames, where water
may stagnate more easily. It is a good
idea to leave the car in the open for a
while after washing it to give time for
the water to evaporate.
Do not wash the car after it has been
parked in the sun or when the engine
is bonnet is hot: this could take the
shine off the paint.Exterior plastic parts must be cleaned
in the same way as the rest of the car.
Where possible, do not park under
trees; the resinous substance many
species release give the paint a dull
appearance and increase the possibil-
ity of triggering rust processes.
IMPORTANT Bird droppings must be
washed off immediately and thor-
oughly as the acid they contain is par-
ticularly aggressive.Windows
Use specific window cleaner products.
Also use clean cloths to avoid scratch-
ing the glass or damaging the trans-
parency.
IMPORTANT Wipe the rear window
inside gently with a cloth in the di-
rection of the filaments to avoid dam-
aging the heating device.
Front headlights
IMPORTANT Never use aromatic
substances (e.g.: petrol) or ketenes
(e.g.: acetone) for cleaning front
headlight plastic lens.Detergents pollute the envi-
ronment. The vehicle
should be washed in areas
equipped for collecting and
purifying the liquid used in the
washing process.