key LEXUS LX470 2006 Workshop Manual

INTERIOR EQUIPMENT
76
GLOVE BOX
14X007a
 1Unlock 2Open 3Lock
To open the glove box door, pull the lever. To lock the
glove box door, insert the master key and turn it
clockwise.
With the tail lights on, the glove box light will come on when the
glove box door is open.
CAUTION
To reduce the chance of injury in case of an accident or
a sudden stop, always keep the glove box door closed
while driving.
GARAGE DOOR OPENER
The garage door opener ( Universal
Transceiver) is manufactured under license from
HomeLink
 and can be programmed to operate garage
doors, gates, entry doors, door locks, home lighting
systems, and security systems, etc.
(a) Programming the HomeLink
14X517
 1 Buttons 2Indicator light
The HomeLink
 in your vehicle has 3 buttons and you can
store one program for each button.
To ensure correct programming into the HomeLink
, install a
new battery in the hand −held transmitter prior to programming.

EXTERIOR EQUIPMENT
95
MOON ROOF
15X016e
 1Open 2Close
To slide open the moon roof, push the “SLIDE” switch on
the rear side. The moon roof will open and stop partway
30 mm (1.2 in.) from the fully opened position. When you
push the switch again, the moon roof will open fully. To
stop partway, push the same switch or push the “TILT”
switch while the moon roof is moving.
As driving with the moon roof opened fully will cause wind
throbs, we recommend you to drive with the moon roof partway
30 mm (1.2 in.) from the fully opened position.
To operate the moon roof, the ignition key must be in the “ON”
position.
The sun shade can be opened or closed manually. However,
if you open the moon roof, the sun shade will be opened with
the moon roof. To close the moon roof, push the switch on the front side.
The moon roof will fully close. To stop partway, push the
same switch or “TILT” switch.
15X017e
 1
Tilt up 2Lower
To tilt up the rear end of the moon roof, push the “TILT”
switch on the “UP” side. The rear end of the moon roof will
tilt up fully. To stop partway, push the same switch or
“SLIDE” switch.
To lower it, push the switch on the opposite side of the
“UP” side. The rear end of the moon roof will fully close.
To stop partway, push the same switch or “SLIDE” switch.
Retained accessory power: Even if the ignition key is turned
to the “ACC” or “LOCK” position with all the doors closed, t\
he
moon roof can be operated until either of the front doors is
opened (or for about 45 seconds).

EXTERIOR EQUIPMENT
96
Operating the moon roof from outside the
vehicle
The moon roof can be closed or opened using a key.*
Insert the ignition key into the key hole on the driver’s
door.
To close the moon roof: Turn the key in the locking direction
and hold it.
After the door is locked, the moon roof begins to close. To stop
in the middle, return the key.
To open the moon roof: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the moon roof begins to open. To
stop in the middle, return the key.
NOTE: *This feature can be deactivated, or sliding
open/close or tilting up/down can be selected. Ask your
Lexus dealer for details.
Jam protection function
If something gets caught into the roof opening during closing
operation, the moon roof stops and is open.
If the moon roof receives a strong impact, this function may
work even if nothing is caught.
If the battery terminal is disconnected or the
battery is run down
The moon roof may not operate automatically and the jam
protection function will not operate correctly after you
reconnect, replace or recharge the battery with the moon roof
slide −opened or tilted up. In any of these cases, you should
return the moon roof to normal. To normalize the moon roof,
push and hold the “SLIDE” switch or “TILT” switch on the front
side until the moon roof is closed completely.
Make sure the moon roof opens and closes automatically. If
the moon roof cannot be operated properly, have it checked by
your Lexus dealer.

EXTERIOR EQUIPMENT
97
CAUTION
To avoid serious personal injury, you must do the
following.
While the vehicle is moving, always keep the heads,
hands and other parts of the bodies of all occupants
away from the roof opening. Otherwise, they could
be seriously injured if the vehicle stops suddenly or
if the vehicle is involved in an accident.
 Before you close the moon roof, always make sure
there is nobody around the moon roof. You must also
make sure nobody places his or her head, hands and
other parts of the body in the roof opening. If
someone’s neck, head or hands get caught in the
closing roof, it could result in death or serious injury.
When anyone closes the moon roof, first make sure
it is safe to do so.
 Be sure to remove the ignition key when you leave
your vehicle.
 Never leave anyone (particularly a small child) alone
in your vehicle, especially with the ignition key still
inserted. Otherwise, he/she could use the moon roof
switches and get trapped in a moon roof. Unattended
person (particularly a small child) can be involved in
a serious accident.
 Never sit on top of the vehicle around the roof
opening.
 Never try jamming any part of your body to activate
the jam protection function intentionally, as it could
result in a serious injury.
 The jam protection function may not work if
something gets caught just before the moon roof
fully closed.

EXTERIOR EQUIPMENT
98
REAR STEP BUMPER
15X600b
The rear step bumper is for rear end protection and easier
stepup loading.
CAUTION
Do not allow more than one person to get on the rear
step bumper at a time. It is designed for only one
person.
 Never drive the vehicle with anyone on the rear step
bumper.
RUNNING BOARD LIGHTS
15x019b
Lighting the running board and the ground helps you
easily to get in and out of the vehicle in the night.
When you unlock any door with a key or wireless remote
control, the lights come on and go out after about 15 seconds
automatically.
Opening any door lights up the lights and closing it goes out
them after 15 seconds. However, if the door remains open, the
lights automatically go out after about 30 minutes.

OCCUPANT RESTRAINT SYSTEMS
133
16x502a
This indicator comes on when the ignition key is turned to
the “ON” position. It goes off after about 6 seconds. This
means the seat belt pretensioners are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front passenger occupant classification system and indicator
light, front passenger’s seat belt buckle switch, seat belt
pretensioner assemblies, inflators, roll sensing of curtain
shield airbags off indicator light, interconnecting wiring and
power sources. (For details, see “Service reminder indicators
and warning buzzers” on page 52.) If any of the following conditions occurs, this indicates a
malfunction of the
seat belt pretensioners. Contact your Lexus
dealer as soon as possible.
 The light does not come on when the ignition key is turned
to the “ON” position or remains on for more than 6 seconds
or flashes.
 The light comes on or starts flashing while driving.
 If any seat belt does not retract or cannot be pulled out due
to a malfunction or activation of the relevant seat belt
pretensioner.
 The seat belt pretensioner assembly or surrounding area
has been damaged.
The SRS warning light will come on and front passenger
occupant classification indicator light will indicate “OFF” if
there is a malfunction in the front passenger occupant
classification system.

OCCUPANT RESTRAINT SYSTEMS
142
NOTICE
Do not perform any of the following changes without
consulting your Lexus dealer. Such changes can
interfere with proper operation of the SRS front airbag
system in some cases.
Installation of electronic devices such as a mobile
twoway radio, cassette tape player or CD player.
 Modification of the front end structure.
 Attachment of a grille guard (bull bar, kangaroo bar,
etc.), snowplow, winches or any other equipment to
the front end.
 Repairs made on or near the front fenders, front end
structure, console, steering column, steering wheel,
dashboard near the front passenger airbag or front
seats.
16x502a
This indicator comes on when the ignition key is turned to
the “ON” position. It goes off after about 6 seconds. This
means the SRS front airbags are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front passenger occupant classification system and indicator
light, front passenger’s seat belt buckle switch, seat belt
pretensioner assemblies, inflators, roll sensing of curtain
shield airbags off indicator light, interconnecting wiring and
power sources. (For details, see “Service reminder indicators
and warning buzzers” on page 52.)

OCCUPANT RESTRAINT SYSTEMS
143
If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.

The light does not come on when the ignition key is turned
to the “ON” position or remains on for more than 6 seconds
or flashes.
 The light comes on or starts flashing while driving.
The SRS warning light will come on and front passenger
occupant classification indicator light will indicate “OFF” if
there is a malfunction in the front passenger occupant
classification system.
16x605b
In the following cases, contact your Lexus dealer as soon as
possible:
 The SRS front airbags have been inflated.
 The front of the vehicle (shaded in the illustration) was
involved in an accident that was not severe enough to cause
the SRS front airbags to inflate.

OCCUPANT RESTRAINT SYSTEMS
156If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.

The light does not come on when the ignition key is turned
to the “ON” position or remains on for more than 6 seconds
or flashes.
 The light comes on or starts flashing while driving.
The SRS warning light will come on and front passenger
occupant classification indicator light will indicate “OFF” if
there is a malfunction in the front passenger occupant
classification system.
16x608a

OCCUPANT RESTRAINT SYSTEMS
158
The front passenger occupant classification indicator
light indicates the actuation of the front passenger airbag,
side airbag on the front passenger seat and front
passenger’s seat belt pretensioner.
The indicator light will indicate “OFF” when the ignition switch
is in the “ON” position with the condition 2 in the table shown
below.
If the front passenger occupant classification system
determines that a person of adult size sits in the front
passenger seat but the “OFF” indicator is illuminated, one of
the following is likely to have occurred:
 A rear passenger lifts the front passenger seat cushion with
their legs.
 Objects are placed under the front passenger seat.
 The front passenger seatback is in contact with the rear
seat. To ensure the system correctly detects an adult sitting in the
front passenger seat, make sure the above do not occur.
Make sure that the “ON” indicator is illuminated when an adult
is seated in the front passenger seat. If the “OFF” indicator is
illuminated, ask the passenger to sit up straight, well back in
the seat, and with the seat belt worn correctly. If the “OFF”
indicator still
remains illuminated, either ask the passenger to
move to the rear seat, or if that is not possible, move the front
passenger seat fully rearward.
The front passenger occupant classification indicator
light will indicate “ON” and “OFF” when the ignition key
is turned to the “ON” position. After about 4 seconds, it
will go off. After about 2 seconds, the front passenger
occupant classification system operates and judges
whether to indicate “ON” or “OFF”.