lights LEXUS NX300h 2015 Manual PDF

570 8-2. Steps to take in an emergency
NX300h_U_OM78007U WA R N I N G ■
If both the ABS and the brake system warning lights remain on
Stop your vehicle in a safe place immediat ely and contact your Lexus dealer. The vehi-
cle will become extremely unstable during braking, and the ABS system may fail, which
could cause an accident resulting in death or serious injury. ■
When the electric power steering system warning light comes on
When the light comes on yellow, the assist to the power steering is restricted. When the
light comes on red, the assist to the power steering is lost and handling operations of
the steering wheel become extremely heavy. When steering wheel operations are
heavier than usual, grip the steering wheel firmly and operate it using more force than
usual. ■
If the tire pressure warning light comes on
Be sure to observe the following precautions. Failure to do so could cause a loss of
vehicle control and result in death or serious injury. ●
Stop your vehicle in a safe place as soon as possible. Adjust the tire inflation pressure
immediately. ●
If the tire pressure warning light comes on even after tire inflation pressure adjust-
ment, it is probable that you have a flat tire. Check the tires. If a tire is flat, change it
with the spare tire and have the flat tire repaired by the nearest Lexus dealer. ●
Avoid abrupt maneuvering and braking. If the vehicle tires deteriorate, you could lose
control of the steering wheel or the brakes. ■
If a blowout or sudden air leakage should occur
The tire pressure warning system may not activate immediately.

572 8-2. Steps to take in an emergency
NX300h_U_OM78007UIf a warning message is displayed Master warning light The master warning light also comes on
or flashes in order to indicate that a mes-
sage is currently being displayed on the
multi-information display.
Multi-information display
Handling Method Follow the instructio ns of the message
on the multi-information display.
If any of the warning messages are show n again after the following actions have
been performed, contact your Lexus dealer.
The warning lights and warning buzzers operate as follows depending on the
content of the message. If a message in dicates the need for inspection by a
dealer, have the vehicle inspected by your Lexus dealer immediately.The multi-information display shows warnings of system malfunctions, incor-
rectly performed operations, and messages that indicate a need for mainte-
nance. When a message is shown, perform the correction procedure
appropriate to the message. 1
2
3
Messages and warnings System
warning
light Wa r n i n g b u z z e r
* Wa r n i n g
Comes
on  Sounds Indicates an important situation, such
as when a system related to driving is
malfunctioning or that danger may
result if the correction procedure is not
performed
 Comes on
or flashes Sounds Indicates an important situation, such
as when the systems shown on the
multi-information display may be mal-
functioning
Flashes  Sounds Indicates a situation, such as when
damage to the vehicle or danger may
result

5738-2. Steps to take in an emergency
8
When trouble arises
NX300h_U_OM78007U * : A buzzer sounds the first time a message is shown on the multi-information display. ■
System warning lights
The master warning light does not come on or flash in the following cases. Instead, a sep-
arate system warning light will come on al ong with a message shown on the multi-infor-
mation display. ●
Malfunction of the ABS
The ABS warning light comes on. (  P. 566)●
Malfunction of th e charging system
The charging system warning light comes on. (  P. 565)■
If “Hybrid System Overheated Reduced Output Power” is shown
This message may be displayed when driv ing under severe operating conditions.
(For example, when drivin g up a long steep hill.)
Handling method:  P. 6 0 0■
If “Cooling Performance of The Hybrid Battery Is Low” is shown
The filter may be clogged, or the air intake vents or ducts may be blocked. Have the vehi-
cle inspected by your Lexus dealer. ■
If “Hybrid Battery Low Shift Out of N to Recharge” is shown
Message is displayed when the remaining charge for the hybrid battery (traction battery)
is low.
As the hybrid battery (traction battery) can not be charged when the shift lever is in N,
when stopped for long periods of time shift the shift lever to P.■
If “Hybrid Battery Low Hybrid System St opped Shift to P and Restart” is shown
Message is displayed when the remaining charge for the hybrid battery (traction battery)
is low, because vehicle has been sh ifted N for a long period of time.
When operating the vehicle, restart the hybrid system. ■
If “Shift to P Before Exiting Vehicle” is shown
Message is displayed when the driver’s door is opened without turning the power switch
to OFF with the shift lever in any position other than P.
Shift the shift lever to P. ■
If “Shift Is in N Release Accele rator Before Shifting” is shown
Message is displayed when the accelerator pe dal has been depressed and the shift lever
is in N. Release the accelerator peda l and shift the shift lever to D or R.Comes
on  Does not sound Indicates a condition, such as malfunc-
tion of electrical components, their
condition, or indicates the need for
maintenance
Flashes  Does not sound Indicates a situation, such as when an
operation has been performed incor-
rectly, or indicates how to perform an
operation correctlySystem
warning
light Wa r n i n g b u z z e r
* Wa r n i n g

589
8
When trouble arises 8-2. Steps to take in an emergency
NX300h_U_OM78007UIf the hybrid system will not start One of the following may be the cause of the problem: ●
The electronic key may not be functioning properly.
(  P. 5 9 2 )●
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. (  P. 8 3 )●
There may be a malfunction in the immobilizer system. (  P. 8 6 )●
There may be a malfunction in the steering lock system. ●
The hybrid system may be malfunctioni ng due to an electrical problem such
as electronic key battery depletion or a blown fuse. However, depending on
the type of malfunction, an interim meas ure is available to start the hybrid sys-
tem. (  P. 5 9 0 )
One of the following may be the cause of the problem: ●
The 12-volt battery may be discharged. (  P. 5 9 5 )●
The 12-volt battery terminal connections may be loose or corroded.
(  P. 5 1 2 )Reasons for the hybrid system not starting vary depending on the situation.
Check the following and perform the appropriate procedure:
The hybrid system will not start ev en though the correct starting proce-
dure is being followed. (  P. 201)
The interior lights and headlights are dim, or the horn does not sound or
sounds at a low volume.

590 8-2. Steps to take in an emergency
NX300h_U_OM78007U One of the following may be the cause of the problem: ●
The 12-volt battery may be discharged. (  P. 5 9 5 )●
One or both of the 12-volt battery terminals may be disconnected. (  P. 5 1 2 )Contact your Lexus dealer if the problem cannot be repaired, or if repair procedures
are unknown.
When the hybrid system does not start, the following steps can be used as an
interim measure to start the hybrid system if the power switch is functioning nor-
mally:
Do not use this starting procedur e except in cases of emergency.
Set the parking brake.
Shift the shift lever to P.
Turn the power switch to ACCESSORY mode.
Press and hold the power switch for ab out 15 seconds while depressing the
brake pedal firmly.
Even if the hybrid system can be starte d using the above steps, the system may
be malfunctioning. Have the vehicle inspected by your Lexus dealer.The interior lights and headlights do not turn on, or the horn does not
sound.
Emergency start function 1
2
3
4

5978-2. Steps to take in an emergency
8
When trouble arises
NX300h_U_OM78007U Start the engine of the second vehicle. Increase the engine speed slightly and
maintain at that level for approximately 5 minutes to recharge the 12-volt bat-
tery of your vehicle.
Open and close any of the doors of your vehicle with the power switch off.
Maintain the engine speed of the second vehicle and start the hybrid system
of your vehicle by turning the power switch to ON mode.
Make sure the “READY” indicator comes on. If the indicator light does not
come on, contact your Lexus dealer.
Once the hybrid system has started, remove the jumper cables in the exact
reverse order from which they were connected.
Close the exclusive jump starting terminal cover, and reinstall the fuse box
cover to its original position.
Once the hybrid system starts, have th e vehicle inspected at your Lexus dealer
as soon as possible. ■
Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting. ■
To prevent 12-volt battery discharge ●
Turn off the headlights and the audio system while the hybrid system is off. ●
Turn off any unnecessary electrical components when the vehicle is running at a low
speed for an extended period, such as in heavy traffic. ■
Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when the vehicle
is not in use, due to natural discharge and the draining effects of certain electrical appli-
ances. If the vehicle is left for a long time, the 12-volt battery may discharge, and the
hybrid system may be unable to start. (The 12-volt battery recharges automatically while
the hybrid system is operating.) ■
When the 12-volt battery is removed or discharged ●
In some cases, it may not be possible to unlock the doors using the smart access system
with push-button start when the 12-volt battery is discharged. Use the wireless remote
control or the mechanical key to lock or unlock the doors. ●
The hybrid system may not start on the first attempt after the 12-volt battery has
recharged but will start normally after the second attempt. This is not a malfunction.●
The power switch mode is memorized by the vehicle. When the 12-volt battery is
reconnected, the system will return to the mode it was in before the 12-volt battery was
discharged. Before disconnecting the 12-volt battery, turn the power switch off.
If you are unsure what mode the power switch was in before the 12-volt battery dis-
charged, be especially careful when reconnecting the 12-volt battery. ●
The power back door must be initialized. (  P. 1 3 4 )●
Make sure that the key is not inside the vehicle when recharging or replacing the
12-volt battery. The key may be locked in the vehicle if the alarm is activated. (  P. 88)5
6
7
8
9
10

6139-1. Specifications
9
Vehicle specifications
NX300h_U_OM78007U * : The coolant capacity is the quantity of reference.
If replacement is necessary, contact your Lexus dealer.Cooling system Capacity
* Gasoline
engine 
Vehicles without towing package
7.7 qt. (7.3 L, 6.4 Imp.qt.) 
Vehicles with towing package
7.1 qt. (6.7 L, 5.9 Imp.qt.)
Po w e r
control unit 3.3 qt. (3.1 L, 2.7 Imp.qt.)
Coolant type Use either of the following:
• “Toyota Super Long Life Coolant”
• Similar high-quality ethylene glycol-based
non-silicate, non-amine, non-nitrite, and non-
borate coolant with long-life hybrid organic
acid technology
Do not use plain water alone.
Ignition system (spark plug) Make DENSO FK16HR-A8
Gap 0.03 in. (0.8 mm)
NOTICE ■
Iridium-tipped spark plugs
Use only iridium-tipped spark plugs. Do not adjust the spark plug gap.
Electrical system 12-volt battery
Open voltage at 68  F (20  C): 12.6 V or higher: Fully charged
12.2 — 12.4 V: Half charged
12.0 V or lower: Discharged
(Voltage is checked 20 minutes after the hybrid
system and all lights are turned off.)
Charging rates 5 A max.

6179-1. Specifications
9
Vehicle specifications
NX300h_U_OM78007U Light bulbs Light bulbs Bulb No. W Ty p e
Exterior Headlights
High beam (halogen bulbs)
* 9005 60 A
Front side marker lights
* W5W 5 C
Front turn signal lights (bulb
type)
* 585
(WY21W) 21 B
Rear turn signal lights 585
(WY21W) 21 B
Back-up lights 921
(W16W) 16 C
Interior Vanity lights  8 C
Luggage compartment light  5 D
A: HB3 halogen bulbs
B: Wedge base bulbs (amber) C: Wedge base bulbs (clear)
D: Double end bulbs
* : If equipped

636 9-2. Customization
NX300h_U_OM78007U ■
Wireless remote control (  P. 1 2 4 )
■
Automatic light control system (  P. 2 1 9 )
■
Lights ( 
P. 2 1 9 ) Function Default
setting Customized
setting
Wireless remote control On Off – – O –
Unlocking operation Driver’s door
unlocked in first
step, all doors
unlocked in
second step All doors
unlocked in first
step O–O–
Panic function On Off – – O –
The function that validates the
switch of the wireless
remote control when locking
the door (  P. 1 2 9 ) When locking
the door When unlock-
ing the door ––O– 1 2 3 4
Function Default
setting Customized
setting
Light sensor sensitivity Standard -2 to 2 O – O –
Adjust the time elapsed
before the headlights auto-
matically turn off 30 seconds Off
O–O–
60 seconds
90 seconds 1 2 3 4
Function Default
setting Customized
setting
Daytime Running Lights
(Daytime running lights can
be disabled) On Off O – O – 1 2 3 4

6379-2. Customization
9
Vehicle specifications
NX300h_U_OM78007U ■
Illumination (  P. 443)Function Default
setting Customized
setting
Time elapsed before the inte-
rior lights turn off 15 seconds Off
O–O–7. 5 s e c o n d s
30 seconds
Time elapsed before the exte-
rior lights turn off 15 seconds Off
O – O –7. 5 s e c o n d s
30 seconds
Operation after the power
switch is turned off On Off – – O –
Operation when the doors
are unlocked On Off – – O –
Operation when you
approach the vehicle with the
electronic key on your person On Off – – O –
Footwell lighting On Off – – O –
Fading out of the outer foot
lights when they turn off Long Short – – O – 1 2 3 4