lock LEXUS RX270 2014 Workshop Manual

68
1-2. Opening, closing and locking the doors
RX350/270_EE
CAUTION
●Do not pull on the back door damper stay to close the back door, and do not
hang on the back door damper stay.
Doing so may cause hands to be caught or the back door damper stay to break,
causing an accident.
●If a bicycle carrier or similar heavy object is attached to the back door, it may sud-
denly shut again after being opened, causing someone’s hands, head or neck to
be caught and injured. When installing an accessory part to the back door, using
a genuine Lexus part is recommended.
■Back door closer
●Use caution when using the back door closer as it still operates when the power
back door system is cancelled.
●In the event that the back door is left slightly
open, the back door closer will automati-
cally close it to the fully closed position. It
takes several seconds before the back
door closer begins to operate. Be careful
not to catch fingers or anything else in the
back door, as this may cause bone frac-
tures or other serious injuries.
RX350_270_EE_48D77E.book 68 ページ ２０１４年１月２４日　金曜日　午前１０時４分

69
1-2. Opening, closing and locking the doors
1
Before driving
RX350/270_EE
CAUTION
■Power back door
Observe the following precautions when operating the power back door.
Failure to do so may cause death or serious injury.
●Check the safety of the surrounding area to make sure there are no obstacles or
anything that could cause any of your belongings to get caught.
●If anyone is in the vicinity, make sure they are safe and let them know that the back
door is about to open or close.
●If the power back door system is turned off with the main switch while the back
door is operating automatically, the automatic operation is stopped. The back
door then has to be operated manually. Take extra care when on an incline, as the
back door may open or close unexpectedly.
●If the operating conditions of the power back door are no longer met, a buzzer
may sound and the back door may stop opening or closing. The back door then
has to be operated manually. Take extra care when on an incline, as the back door
may open or close abruptly.
●On an incline, the back door may suddenly shut after it opens. Make sure the
back door is fully open and secure.
●In the following situations, the power back door may detect an abnormality and
automatic operation may be stopped. In this case, the back door has to be oper-
ated manually. Take extra care when on an incline, as the back door may open or
close abruptly.
• When the back door contacts an obstacle
• When the battery voltage suddenly drops, such as when the “ENGINE
START STOP” switch is turned to IGNITION ON mode or the engine is
started during automatic operation
●If a bicycle carrier or similar heavy object is attached to the back door, the power
back door may not operate, causing itself to malfunction, or the back door may
suddenly shut again after being opened, causing someone’s hands, head or neck
to be caught and injured. When installing an accessory part to the back door,
using a genuine Lexus part is recommended.
RX350_270_EE_48D77E.book 69 ページ ２０１４年１月２４日　金曜日　午前１０時４分

70
1-2. Opening, closing and locking the doors
RX350/270_EE
CAUTION
■Jam protection function
Observe the following precautions.
Failure to do so may cause death or serious injury.
●Be careful while the jam protection function is operating. Being hit by the back
door may result in an injury.
●Although the back door stops closing when the jam protection function detects
an object, take extra care as you may still be injured if part of your body is already
caught.
●If anything obstructs the power back door while it is closing, the jam protection
function will cause the back door to automatically operate in the opposite direc-
tion. However, be careful not to jam body parts in the doorframe, as an injury may
result.
●Never use any part of your body to intentionally activate the jam protection func-
tion.
●The jam protection function may not work if something gets caught just before
the back door fully closes. Be careful not to catch fingers or anything else.
●The jam protection function may not work depending on the shape of the object
that is caught. Be careful not to catch fingers or anything else.
●The sensors located on the right and left sides of the power back door detect
obstructions and prevent them from becoming jammed in the door. Some objects
may not be detected depending on their shape or how they are jammed. Be care-
ful not to get fingers or other body parts caught in the back door while it is oper-
ating as this may result in a serious injury.
RX350_270_EE_48D77E.book 70 ページ ２０１４年１月２４日　金曜日　午前１０時４分

71
1-2. Opening, closing and locking the doors
1
Before driving
RX350/270_EE
NOTICE
■Back door damper stays
The back door is equipped with damper stays that hold the back door in place.
Observe the following precautions.
Failure to do so may cause damage to the back door damper stay, resulting in mal-
function.
■To prevent back door closer malfunction
●Do not apply excessive force to the back door while the back door closer is oper-
ating.
●If the back door is opened and closed repeatedly in a short amount of time, the
back door closer may stop operating. In this case, manually open the back door
once and wait for a while before attempting to close it again.
●Do not attach any foreign objects, such as
stickers, plastic sheets, or adhesives to the
damper stay rod.
●Do not touch the damper stay rod with
gloves or other fabric items.
●Do not attach any accessories other than
genuine Lexus parts to the back door.
●Do not place your hand on the damper stay
or apply lateral forces to it.
RX350_270_EE_48D77E.book 71 ページ ２０１４年１月２４日　金曜日　午前１０時４分

72
1-2. Opening, closing and locking the doors
RX350/270_EE
NOTICE
■To prevent damage to the power back door
●Make sure that there is no ice between the back door and frame that would pre-
vent movement of the back door. Operating the power back door when exces-
sive load is present on the back door may cause a malfunction.
●Do not apply excessive force to the back door while the power back door is oper-
ating.
●Take care not to damage the sensors (installed on the right and left edges of the
power back door) with a knife or other sharp object. If the sensor is disconnected,
the power back door will not operate in automatic operation.
●When manually closing the back door immediately after the power back door
has been automatically opened fully, some resistance may be felt.
RX350_270_EE_48D77E.book 72 ページ ２０１４年１月２４日　金曜日　午前１０時４分

75
1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
RX350/270_EE
Active head restraints
When the occupant’s lower back
presses against the seatback dur-
ing a rear-end collision, the head
restraint moves slightly forward
and upward to help reduce the risk
of whiplash to the seat occupant.
■Active head restraints
Even small forces applied to the seatback may cause the head restraint to move.
Pushing up a locked head restraint forcibly may appear the head restraint inner
structure. These do not indicate problems.
Inner
structureDuring
rear-end
collision
RX350_270_EE_48D77E.book 75 ページ ２０１４年１月２４日　金曜日　午前１０時４分

78
1-3. Adjustable components (seats, mirrors, steering wheel)
RX350/270_EE■Folding down rear seatbacks
From inside
Pull the seatback angle adjustment
lever.
To return the rear seatbacks to
their original positions, lift them up
until they lock.
From outside
Pull the levers.
Left side lever: Folds down the
left side rear seat
Right side lever: Folds down the
right side and
center rear seats
To return the rear seatbacks to
their original positions, lift them up
until they lock.
RX350_270_EE_48D77E.book 78 ページ ２０１４年１月２４日　金曜日　午前１０時４分

79
1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
RX350/270_EE■Folding down the rear center seatback
Pull the center seatback angle
lever behind the seatback and fold
the seatback down.
To return the rear center seatback
to its original position, lift it up until
it locks.
CAUTION
■When folding the rear seatbacks down
Observe the following precautions.
Failure to do so may result in death or serious injury.
●Do not fold the seatbacks down while driving.
●Do not fold seatbacks down while passengers are seated or luggage is placed on
the seats.
●Stop the vehicle on level ground, set the parking brake and shift the shift lever to
P.
●After folding the seatback, lightly move the seat back and forth to lock it in place.
●Do not allow anyone to sit on a folded seatback or in the luggage compartment
while driving.
●Do not allow children to enter the luggage compartment.
■Seat adjustment
●To reduce the risk of sliding under the lap belt during a collision, do not recline the
seat more than necessary.
If the seat is too reclined, the lap belt may slide past the hips and apply restraint
forces directly to the abdomen, or your neck may contact the shoulder belt,
increasing the risk of death or serious injury in the event of an accident.
●Adjustments should not be made while driving as the seat may unexpectedly
move and cause the driver to lose control of the vehicle.
RX350_270_EE_48D77E.book 79 ページ ２０１４年１月２４日　金曜日　午前１０時４分

80
1-3. Adjustable components (seats, mirrors, steering wheel)
RX350/270_EE
CAUTION
■After returning the rear seatback to the upright position
Observe the following precautions.
Failure to do so may result in death or serious injury.
●Make sure the seatback is securely locked by pushing it forward and rearward on
the top.
●Check that the seat belts are not twisted or caught in the seatback.
NOTICE
■Stowing the center seat belt buckle
Before folding down the rear seatbacks, stow the center seat belt buckle to prevent
it from becoming caught in the seatbacks.
RX350_270_EE_48D77E.book 80 ページ ２０１４年１月２４日　金曜日　午前１０時４分

81
1
1-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
RX350/270_EE
Driving position memory∗
Your preferred driving position (the position of the driver's seat, steering
wheel and outside rear view mirrors) can be memorized and recalled with
the touch of a button. It is also possible to set this function to activate auto-
matically when the doors are unlocked.
Three different driving positions can be entered into memory.
On some models, the same buttons are found on the front passenger’s side,
allowing the position of the front passenger’s seat to be memorized.
■Entering a position to memory
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Adjust the driver’s seat, steering wheel and outside rear view
mirrors to the desired positions.
Press the “SET” button, then
within 3 seconds press button
“1”, “2” or “3” until the signal
beeps.
If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
STEP1
STEP2
STEP3
∗: If equipped
RX350_270_EE_48D77E.book 81 ページ ２０１４年１月２４日　金曜日　午前１０時４分