LEXUS RX350 2011 Owners Manual

219
2-4. Using other driving systems
2

When driving
CAUTION
nConditions under which the vehicle-to-vehicle distance control may not function
correctly
Apply the brakes as necessary in the following conditions as the radar sensor may
not be able to correctly detect vehicles ahead, and an accident may result:
lWhen water or snow thrown up by the surrounding vehicles hinders the function-
ing of the radar sensor
lWhen your vehicle is pointing upwards (caused by a heavy load in the luggage
compartment etc.)
lWhen the road curves or when the lanes are narrow
lWhen steering wheel operation or your position in the lane is unstable
lWhen the vehicle ahead of you decelerates suddenly
nTo ensure the radar sensor functions correctly
Do not do the following to the sensor or grille as doing so may cause the sensor not
to function correctly and could result in an accident:
lSticking or attaching anything to them
lLeaving them dirty
lDisassembling or subjecting them to strong shocks
lModifying or painting them
lReplacing them with non-genuine parts
nHandling the radar sensor
Observe the following to ensure the cruise control system can function effectively:
lKeep the sensor and front grille clean at all times.
Clean the sensor and front grille with a soft cloth so you do not mark or damage
them.
lDo not subject the sensor or surrounding area to a strong impact.
If the sensor moves even slightly off position, the system may malfunction. If the
sensor or surrounding area is subject to a strong impact, always have the area
inspected and adjusted by your Lexus dealer.
lDo not disassemble the sensor.
lDo not attach accessories or stickers to the sensor, grille or surrounding area.
lDo not modify or paint the sensor and grille.

220
2-4. Using other driving systems
Intuitive parking assist∗
The distance to obstacles measured by the sensors is communicated via
the multi-information display and a buzzer when parallel parking or
maneuvering into a garage is conducted. Always check the surrounding
area when using this system.
nTypes of sensors
Front corner sensors
Rear corner sensors
Rear center sensors
nSetting the Intuitive parking assist mode
Press the menu switch.
The multi-information display
will change modes to elec-
tronic features control mode.
Press the “ENTER” switch
upwards or downwards until
the intuitive parking assist
mark appears in the multi-
information display.
STEP1
∗: If equipped

221
2-4. Using other driving systems
2

When driving
Display
When the sensors detect an obstacle, the graphic is shown on the multi-
information display depending on the position and distance to the obsta-
cle.
Front corner sensor operation
Rear corner sensor operation
Rear center sensor operation
Press the “ENTER” switch to
change to “ON”.
The intuitive parking assist indi-
cator will be displayed.
Each pressing of the switch
turns the intuitive parking assist
on and off.
When on, the buzzer sounds to
inform the driver that the system
is operational.
Press the menu switch to
change to the normal display.
STEP2

222
2-4. Using other driving systems
The distance display and buzzer
When a sensor detects an obstacle, the direction of and the approximate
distance to the obstacle are displayed and the buzzer sounds.
nFront corner sensors
nRear corner sensors
Detection
level
Multi-information
display
Approximate dis-
tance to obstacleBuzzer
22.0 to 1.6 ft.
(60 to 47.5 cm)Medium
31.6 to 1.2 ft.
(47.5 to 35 cm)Fast
41.2 ft. (35 cm) or
lessContinuous
Detection
level
Multi-information
display
Approximate dis-
tance to obstacleBuzzer
21.6 to 1.2 ft.
(50 to 37.5 cm)Medium
31.2 to 0.8 ft.
(37.5 to 25 cm)Fast
40.8 f t. (25 cm) or
lessContinuous

223
2-4. Using other driving systems
2

When driving
nRear center sensors
Detection
level
Multi-information
display
Approximate dis-
tance to obstacleBuzzer
1 4.9 to 2.0 ft.
(150 to 60 cm)Slow
22.0 to 1.5 ft.
(60 to 45 cm)Medium
31.5 to 1.2 ft.
(45 to 35 cm)Fast
41.2 ft. (35 cm) or
lessContinuous

224
2-4. Using other driving systems
Detection range of the sensors
Approximately 2.0 ft. (60 cm)
Approximately 1.6 ft. (50 cm)
Approximately 4.9 ft. (150 cm)
The diagram shows the detection
range of the sensors. Note that the
sensors cannot detect obstacles
that are extremely close to the
vehicle.
The range of the sensors may
change depending on the shape of
the object etc.
nThe intuitive parking assist can be operated when
lFront corner sensors:

225
2-4. Using other driving systems
2

When driving
nSensor detection information
lCertain vehicle conditions and the surrounding environment may affect the
ability of a sensor to correctly detect an obstacle. Particular instances where this
may occur are listed below.

226
2-4. Using other driving systems
nCustomization
Settings (e.g. buzzer volume) can be changed. (Customizable features →P. 6 2 1 )
CAUTION
nCaution when using the intuitive parking assist
Observe the following precautions.
Failing to do so may result in the vehicle being unable to be driven safely and possi-
bly cause an accident.
lDo not use the sensor at speeds in excess of 6 mph (10 km/h).
lDo not attach any accessories within the sensor range.
NOTICE
nNotes when washing the vehicle
Do not apply intensive bursts of water or steam to the sensor area.
Doing so may result in the sensor malfunctioning.
nConditions possibly indicating system malfunctions
If any of the following occurs, the system may be malfunctioning due to a sensor fail-
ure etc. Have the vehicle inspected by your Lexus dealer.
lThe buzzer does not sound when the intuitive parking assist mode is set.
lThe sensor operation display flashes and the buzzer sounds even when no obsta-
cle is detected.
lAn area of the sensors is hit or subjected to a strong impact.
lEither bumper is hit.
lThe sensor operation display remains on even though no buzzer sounds.

227
2-4. Using other driving systems
2

When driving Rear view monitor system (rea r view mirror-attached type)
∗
The rear view monitor system assists the driver by displaying an image of
the area behind the vehicle. The image is displayed in reverse on the
screen. This reversed image is a similar image to the one on the inside rear
view mirror.
The rear view image is displayed
when the shift lever is in the R
position.
If the shift lever is shifted out of
R, the screen is turned off.
∗: If equipped

228
2-4. Using other driving systems
nThe rear view monitor system can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode and the back door
is fully closed.
nSwitching the screen on/off
nDisplayed area
When the screen is displayed, press the
“AUTO” button on the inside rear view mirror
to switch the screen on/off
Screen on: Green indicator comes on.
Screen off: Orange indicator comes on.
The auto anti-glare inside rear view mirror
will revert to the screen on each time the
“ENGINE START STOP” switch to the
IGNITION ON mode.
The area covered by the camera is limited.
Objects that are close to either corner of
the bumper or under the bumper cannot
be seen on the screen.
The area displayed on the screen may vary
according to vehicle orientation or road
conditions.
Corners of bumper