service MAZDA 6 2002 Workshop Manual Suplement

OUTLINE
U–7
U
SUPPLEMENTAL SERVICE INFORMATIONA6E850201038204•The following additions have been made for the MZR-CD (RF Turbo) since the publication of the Mazda6
Workshop Manual (1730-1*-02C).
A/C unit
•Removal/installation procedure has been modified.
A/C compressor
•Removal/installation procedure has been modified.
Condenser
•Removal/installation procedure has been modified.
Refrigerant lines
•Removal/installation procedure has been modified.
Water heater unit
•Removal/installation procedure has been added.
Fuel pump (water heater system)
•Inspection procedure has been added.
Climate control unit
•Inspection procedure has been modified.
Water heater system
•On-board diagnostic system has been added.
End Of Sie
OUTLINE

TD–4
TECHNICAL DATA
ENGINE ELECTRICAL SYSTEMA6E931001001205
*1: Back-up current is the constant flow of current present (for the audio unit, clock, PCM, etc.) when the engine
switch is off and with the key removed.
*
2: Must not be 0 A.
*3: Cold area
End Of Sie
CLUTCHA6E931001024201
End Of Sie
MANUAL TRANSAXLEA6E931001024202
ItemSpecification
Diesel engine
MZR-CD (RF Turbo)
BatteryElectrolyte gravity 1.27—1.29
Back-up current*
1(mA) Max.20
Type
95D31L, 115D31L
*3
Test load chart (A) Battery type95D31L (64) 250
115D31L (70) *3320
Slow-charge (A)Battery type
(5-hour rate)95D31L (64) 6.5—8.0
115D31L (70)
*37.0—8.5
Quick-charge
Battery type
(5-hour rate)95D31L (64) 40
(A/30 min)
115D31L (70)
*345
GeneratorStandard voltage (V)Ignition switch ON TerminalBB+
L Approx. 1
SB+
Idle [20°C {68°F}] TerminalB
14.1—14.7 L
S
Generated current*
2
(reference) (A) Engine speed (rpm)1,000 0—80
2,000 0—90
Starter No load testVoltage (V) 11
Current (A) Below 130
Item Specification
Clutch coverDiaphragm
spring fingersDepth mm {in} 0.6 {0.024}
Misalignment mm {in} 0.6 {0.024}
Maximum clearance of flatness of the
pressure platemm {in} 0.3 {0.012}
Flywheel Run out limit mm {in} 0.3 {0.012}
Item Specification
Manual transaxle typeA65M-R
Transaxle controlFloor-shift
Operation systemCable
Shift assistSynchromesh
Gear ratio1st 3.416
2nd 1.944
3rd 1.258
4th 0.902
5th 0.659
Reverse 3.252
Final gear ratio3.588
Transaxle oilGrade API service GL-4 or GL-5
Viscosity (All-season) SAE 75W-90
Capacity (approximate quantity)
2.30 {2.40, 2.00}
(L {US qt, Imp qt})

TECHNICAL DATA
TD–5
TD
End Of SieAUTOMATIC TRANSAXLEA6E931001024203
End Of Sie
PROPELLER SHAFTA6E931001024204
End Of Sie
Item Specification
Transaxle typeJA5AX-EL
Line pressure
(kPa {kgf/cm
2, psi})D range, M range (2GR)Idle 290—490 {3.0—5.0, 42—71}
Stall 1,550—1,750 {15.8—17.8, 225—254}
M range (1GR), R positionIdle 550—750 {5.6—7.6, 80—109}
Stall 1,550—1,750 {15.8—17.8, 225—254}
Engine stall speed
D, M (1GR, 2GR), R 2,200—2,600
(rpm)
Time lag (second)N-D Approx. 0.5—1.0
N-R Approx. 0.6—1.0
Transaxle fluid
temperature (TFT)
sensor-20 °C {−4 °F} 15.87—17.54
0 °C {32 °F} 5.73—6.33
20 °C {68 °F} 2.38—2.63
40 °C {104 °F} 1.10—1.22
60 °C {140 °F} 0.56—0.62
80 °C {176 °F} 0.31—0.34
(kilohm) 100 °C {212 °F} 0.18—0.20
120 °C {248 °F} 0.11—0.12
130 °C {266 °F} 0.09—0.10
Input/turbine
speed sensor(ohm) ATF temperature: 20 °C {68 °F} 513—627
Intermediate
sensor(ohm) ATF temperature: 20 °C {68 °F} 513—627
Vehicle
speedometer
sensor(ohm) ATF temperature: 20 °C {68 °F} 513—627
Solenoid valves (ohm)Shift solenoid A 14—18
Shift solenoid B 14—18
Shift solenoid C 14—18
Neutral shift solenoid valve 14—18
Reduction timing solenoid valve 14—18
TCC solenoid valve 12.0—13.2
2-4 brake solenoid valve 2.6—3.2
High clutch solenoid valve 2.6—3.2
Pressure control solenoid 2.6—3.2
Automatic transaxle fluid
(ATF)Type
M-
III or equivalent (e.g. Dexron ® III )
Capacity (Approximate quantity) (L {US qt, Imp qt}) 8.3 {8.8, 7.3}
Transfer oilGrade API service GL-5
Viscosity SAE 80W-90
Capacity (Approximate quantity) (L {US qt, Imp qt}) 0.62 {0.65, 0.54}
Item Specification
Runout limit mm {in} 0.3 {0.01}
Starting torqueN·m
{kgf·cm}0.29—0.78 {3.0—7.9}

TD–6
TECHNICAL DATA
FRONT AND REAR AXLEA6E931001018201
End Of Sie
STEERING SYSTEMA6E931001034201
End Of Sie
Item Specification
FRONT DRIVE SHAFT
Shaft length
(Air in boot at atmospheric
pressure)(mm {in})Left sideMZR-CD (RF Turbo): 666.1—676.1 {26.23—26.61}
4WD: 667—677 {26.26—26.65}
Right sideMZR-CD (RF Turbo): 615.9—625.9 {24.25—24.64}
4WD: 631—641 {24.85—25.23}
REAR DRIVE SHAFT (4WD)
Shaft length
(Air in boot at atmospheric
pressure)(mm {in})Left side 805.4—815.4 {31.71—32.10}
Right side 852.4—862.4 {33.56—33.95}
REAR DIFFERENTIAL (4WD)
Pinion height (mm {in})–0.025—0.025 {–0.001—0.001}
Backlash of side gear and differential pinion (mm {in}) 0.1 {0.004} or less
Drive pinion preload (N·m kgf·cm, in·lbf) 1.3—1.8 {13.3—18.3, 11.5—15.9}
Backlash of drive pinion and
ring gear(mm {in})Standard 0.09—0.11 {0.0036—0.0043}
Minimum 0.05 {0.002}
Differential oilGrade API service GL-5
ViscosityAbove –18°C {0°F}: SAE 90
Below –18°C {0°F}: SAE 80
Capacity
(Approximate quantity)(L {US qt, lmp qt}) 1.00 {1.06, 0.88}
ELECTRONIC 4WD CONTROL SYSTEM
Differential oil temperature
sensor(kilohm)0°C {32°F} 91—100
10°C {50°F} 56—61
20°C {68°F} 35—39
30°C {86°F} 23—25
40°C {104°F} 14—17
50°C {122°F} 10—11
60°C {140°F} 7.1—7.9
70°C {158°F} 5.0—5.6
80°C {176°F} 3.6—4.0
4WD solenoid
(Rear differential oil temperature
at 20°C {68°F})(ohm) 1.5—2.0
Item Specification
ENGINE SPEED SENSING POWER STEERING
Power
steering oil
pumpOil pump fluid pressure 2WD (Except MZR-CD (RF Turbo)):
10.80—11.29 {110.2—115.1, 1,567—1,637}
MZR-CD (RF Turbo):
11.31—11.80 {115.4—120.3, 1,641—1,711}
4WD: 10.30—10.79 {105.1—110.0, 1,490—1,564} (MPa {kgf·cm
2, psi})
Gear housing fluid pressure 2WD (Except MZR-CD (RF Turbo)):
10.80—11.29 {110.2—115.1, 1,567—1,637}
MZR-CD (RF Turbo):
11.31—11.80 {115.4—120.3, 1,641—1,711}
4WD: 10.30—10.79 {105.1—110.0, 1,490—1,564} (MPa {kgf·cm
2, psi})
Power
steering
systemFluid type
ATF M-
III or equivalent (e.g. Dexron®II)
Capacity (Approximate quantity) MTX (Except MZR-CD (RF Turbo)): 0.80 {0.85, 0.70}
ATX (Except 4WD): 0.87 {0.92, 0.77}
MZR-CD (RF Turbo): 0.86 {0.91, 0.76}
4WD: 0.89 {0.94, 0.78} (L {US qt, Imp qt})