off MAZDA CX90 2024 Owners Manual

Do not start the engine or shake
the vehicle while it is jacked up.
Starting the engine or shaking the
vehicle while it is jacked up is
dangerous as it could cause the
vehicle to fall off the jack resulting
in an accident.
Never go under the vehicle while it
is jacked up.
Going under the vehicle while it is
jacked up is dangerous as it could
result in death or serious injury if
the vehicle were to fall off the jack.
8. Remove the lug nuts by turning them counterclockwise; then
remove the wheel and center cap.
Locking Lug Nuts
If your Mazda is equipped with the
optional antitheft wheel lug nuts, a
special key must be used to unlock the
locking lug nut for each wheel. The key
is stored in the glove compartment,
center console storage, storage box, or
trunk. Register the key and lug nuts
with the lock manufacturer by filling
out the registration card and mailing it
in using the accompanying envelope. If
the key is lost, consult an Authorized
Mazda Dealer or use the lock
manufacturer’s order form to order a
new key.
Antitheft wheel lug nuts cannot be
installed on a steel wheel spare tire.
When installing a temporary spare tire,
use one of the original lug nuts in place
of the locking lug nut. The original lug
nuts are stored inside your Mazda.
1. Antitheft lug nut
2. Special key
To remove an antitheft lug nut
1. Obtain the special key for the antitheft lug nut.
2. Place the special key on top of the antitheft lug nut, and be sure to
hold the key square to it. If you
hold the key at an angle, you may
damage both key and nut. Do not
use a power impact wrench.
3. Place the lug wrench on top of the key and apply pressure. Turn the
wrench counterclockwise.
To install the antitheft lug nut
1. Place the special key on top of the nut, and be sure to hold the key
square to it. If you hold the key at
an angle, you may damage both key
and nut. Do not use a power
impact wrench.
2. Place the lug wrench on top of the special key, apply pressure, and
turn it clockwise.
Nut tightening torque
N·m (kgf·m, ft·lbf) 108―
147 (12 ―14,
80― 108)
What to Do in Case of Emergency
Tire is Punctured or Bursts
8-25
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Mounting the Spare Tire
1. Remove dirt and grime from themounting surfaces of the wheel and
hub, including the hub bolts, with a
cloth.

WARNING
Make sure the mounting surfaces
of the wheel, hub and lug nuts are
clean before changing or replacing
tires.
When changing or replacing a tire,
not removing dirt and grime from
the mounting surfaces of the wheel,
hub and hub bolts is dangerous.
The lug nuts could loosen while
driving and cause the tire to come
off, resulting in an accident.
2. Mount the spare tire.
3. Install the lug nuts with the beveled edge inward; tighten them by hand.

WARNING
Do not apply oil or grease to lug
nuts and bolts and do not tighten
the lug nuts beyond the
recommended tightening torque.
Applying oil or grease to lug nuts
and bolts is dangerous. The lug nuts
could loosen while driving and
cause the tire to come off, resulting
in an accident. In addition, lug nuts
and bolts could be damaged if
tightened more than necessary.
4. Turn the lug wrench
counterclockwise and lower the
vehicle.
5. Use the lug wrench to tighten the nuts in the order shown.

If you are unsure of how tight the
nuts should be, have them
inspected at an Authorized Mazda
Dealer.
Nut tightening torque
N·m (kgf·m, ft·lbf) 108
―147 (12 ―14,
80 ―108)
What to Do in Case of Emergency
Tire is Punctured or Bursts
8-26
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

WARNING
Always securely and correctly
tighten the lug nuts.
Improperly or loosely tightened lug
nuts are dangerous. The wheel
could wobble or come off. This
could result in loss of vehicle
control and cause a serious
accident.
Be sure to reinstall the same nuts
you removed or replace them with
metric nuts of the same
configuration.
Because the wheel studs and lug
nuts on your Mazda have metric
threads, using a non-metric nut is
dangerous. On a metric stud, it
would not secure the wheel and
would damage the stud, which
could cause the wheel to slip off
and cause an accident.
6.
NOTE
The number and shape of the flat
tire belt differ depending on the
vehicle specification.

1. Belt Clips
The flat tire belts with the clips
are for securing a flat tire.
The flat tire belts without the clips
are for securing the sub-woofer.
(Vehicles with sub-woofer)
Secure the sub-woofer to the flat
tire using the flat tire belt.
1. Pass the flat tire belt through the
wheel of the flat tire.
2. Install the sub-woofer to the flat
tire.
What to Do in Case of Emergency
Tire is Punctured or Bursts
8-27
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Active Driving DisplayDoes Not Operate
If the active driving display does not
operate, switch the vehicle power off
and then restart the hybrid system. If
the active driving display does not
operate even with the hybrid system
restarted, have the vehicle inspected
at an Authorized Mazda Dealer.
What to Do in Case of Emergency
Active Driving Display Does Not Operate
8-36
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Warning Lights
If any warning/indicator light turns
on/flashes, take appropriate action for
each light. If the warning/indicator
light does not turn off, or it turns on or
flashes again, consult an Authorized
Mazda Dealer.
WARNING
If the warning light/indicator light
turns on or flashes, park the vehicle in
a safe place immediately and take
appropriate measures.
Continuing to drive the vehicle while
ignoring the illumination/flashing of
the warning light/indicator light is
dangerous because a problem may
occur to a vehicle system, the engine
may be damaged, or it could lead to
an accident.
The details for some warnings can be
viewed on the center display or
instrument cluster.
Checking Using the Center Display
1. Select “Information” on the home screen.
2. Select “Vehicle Status Monitor”.
3. Select the applicable warning to view the warning details.
Checking Using the Instrument
Cluster
Press the INFO switch on the steering
switch to display the warning
indication screen.
Refer to How to Use the Instrument
Cluster on page 5-28.
Brake System Warning Light
This warning has the following
functions:
Warning light inspection
For an operation check, make sure that
the light turns on when the vehicle
power is switched on, and turns off a
few seconds later or when the hybrid
system is started.
When the light turns on
The light turns on continuously if any
one of the following occurs:
Insufficient brake fluidBrake system (electronic brake force
distribution system) has a problem
Park the vehicle in a safe place
immediately and contact an
Authorized Mazda Dealer.
WARNING
Do not drive with the brake system
warning light illuminated. Contact an
Authorized Mazda Dealer to have the
brakes inspected as soon as possible.
Driving with the brake system warning
light illuminated is dangerous. It
indicates that your brakes may not
work at all or that they could
completely fail at any time. If this light
remains illuminated, after checking
that the parking brake is fully released,
have the brakes inspected
immediately.
What to Do in Case of Emergency
Warning/Indicator Light Turns On
8-37
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Charging System WarningLight
The light turns on if the charging
system has a problem.
Have your vehicle inspected by an
Authorized Mazda Dealer as soon as
possible. Otherwise, the charging
system may not charge the battery.
Output RestrictionWarning Light
The light turns on/flashes under the
following conditions. The vehicle
speed may not increase even if the
accelerator pedal is depressed
High voltage battery level is low
If necessary, park the vehicle in a safe
place until the output restriction
warning light turns off.
WARNING
When the output restriction warning
light turns on or flashes, check the
safety of the surroundings:
The motor output decreases and the
vehicle speed decreases, which could
lead to an accident. If the vehicle
cannot be driven safety, stop the
vehicle in a safe place.
What to Do in Case of Emergency
Warning/Indicator Light Turns On
8-40
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Electric Power SteeringWarning Light
The warning light turns on if the
electric power steering has a
malfunction.
If the warning light turns on, stop the
vehicle in a safe place and switch the
vehicle power OFF.
There is no problem if the warning light
turns off when the hybrid system is
restarted after some time has passed.
If the warning light turns on even after
the hybrid system is restarted, contact
an Authorized Mazda Dealer.
NOTE
If the warning light turns on, the
electric power steering will not
operate normally. In this case, the
steering wheel can still be operated,
however, the operation may feel
heavy compared to normal.
Repeatedly jerking the steering
wheel left and right while the vehicle
is stopped or moving extremely
slowly will cause the power steering
system to go into protective mode
which will make the steering feel
heavy, but this does not indicate a
problem. If this occurs, park the
vehicle safely and do not operate the
steering wheel. The system will
return to normal after a few minutes.
Shift System Warning Light
The light turns on if the shift system has
a problem.
Park the vehicle in a safe place
immediately and contact an
Authorized Mazda Dealer.
Always apply the parking brake when
parking or stopping the vehicle, as it
may not be possible to hold the
vehicle in a stopped position even with
the selector lever in the P position.
In addition, the hybrid system may not
start again if it is stopped.
What to Do in Case of Emergency
Warning/Indicator Light Turns On
8-42
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

Brake Control SystemWarning Light
The light turns on if the system has a
problem.
Have your vehicle inspected by an
Authorized Mazda Dealer.
Electric Parking Brake(EPB) Indicator Light
The light turns on when applying the
parking brake and it turns off when
releasing the parking brake.
Parking brake warning/Indicator light
inspection
The light illuminates when the parking
brake is applied with the vehicle power
switched to START or ON. It turns off
when the parking brake is released.
Turning on
If the light remains on even with the
electric parking brake (EPB) switch
turned off, the system may have a
malfunction. Have the vehicle
inspected by an Authorized Mazda
Dealer.
Flashing
The light flashes if the system has a
problem. If the light remains flashing
even if the electric parking brake (EPB)
switch is pressed, consult an
Authorized Mazda Dealer as soon as
possible.
What to Do in Case of Emergency
Warning/Indicator Light Turns On
8-44
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

KEY Warning Light (Red)
The light turns on if the system has a
problem or if the key is out of the
operation range.
Check the contents of the message
displayed and take the necessary
action.
CAUTION
If the power switch indicator light
(amber) flashes at the same time, the
hybrid system may not start. Have the
vehicle inspected by an Authorized
Mazda Dealer as soon as possible.
Security Indicator Light
If the security indicator light turns on/
flashes while driving , do not stop the
hybrid system (leave it operating) and
have the vehicle inspected at an
Authorized Mazda Dealer. If you stop
the hybrid system , you may not be
able to start it again.
If the hybrid system cannot be started,
switch the vehicle power OFF, place
the key in another position within the
operation range, and then restart the
hybrid system.
Check the security indicator light and if
it does not turn off, such as it remains
on or flashes, switch the vehicle power
OFF, wait for a while, and then restart
the hybrid system.
If the hybrid system does not start after
three attempts, a system malfunction
may have occurred. Have the vehicle
inspected by an Authorized Mazda
Dealer.
NOTE
When repairing the immobilizer
system, the key codes will need to be
reprogrammed. Bring all the remaining
keys to an Authorized Mazda Dealer.
What to Do in Case of Emergency
Warning/Indicator Light Turns On
8-48
CX-90_8KG7-EA-22L_Edition1_new2022-11-17 16:05:04

Seat Belt Warning Light(Front Seat)
The warning light flashes for about 6
seconds if the driver or front
passenger's seat is occupied and the
seat belt is not fastened with the
vehicle power switched ON.
If the driver or front passenger's seat
belt is unfastened (only when the front
passenger's seat is occupied) and if the
vehicle is driven at about 20 km/h (12
mph) or faster, or about 10 km/h (6
mph) or faster for a continuous 30
seconds, with the seat belt unfastened,
the warning light flashes for a certain
period.
After a short time, the warning light
stops flashing, but remains illuminated.
In addition, when the warning light
flashes, a warning sound is activated.
Wear the seat belt.

NOTE
Placing heavy items on the front
passenger's seat may cause the front
passenger's seat belt warning
function to operate depending on
the weight of the item.
To allow the sensor that detects an
occupant to function properly, do
not sit on the front passenger's seat
with a cushion or other object on it.
The sensor may not function properly
because the additional seat cushion
could cause sensor interference.
If a small child is seated on the front
passenger's seat, the warning light
may not operate.
Seat Belt Warning Light(Rear Seat) (Red)
When the vehicle power is switched
ON, the warning lights turn on if the
seat belts are not fastened.
*1*2
After the hybrid system is started, the
warning lights turn off after a short
period of time.
In addition, if a fastened seat belt is
unfastened, the warning light flashes
for a short period of time and then
turns off.
When the warning light flashes, a
warning sound is activated.
Wear the seat belt.

*1 The warning light also turns on when the rear seat is unoccupied.
*2 The number of seats displayed onthe warning light differs depending
on the specification.
What to Do in Case of Emergency
Warning/Indicator Light Turns On
8-52
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04