MAZDA MODEL 3 HATCHBACK 2015 Owners Manual (in English)
Manufacturer: MAZDA, Model Year: 2015, Model line: MODEL 3 HATCHBACK, Model: MAZDA MODEL 3 HATCHBACK 2015Pages: 689, PDF Size: 7.08 MB
Page 261 of 689
4–111
When Driving
i-ACTIVSENSE
NOTE
The LDWS remains on stand-by
until it detects white or yellow lines
on both the left and right sides, or on
either side.
When the system detects a white
or yellow line on one side only, the
system will operate the warning only
when the vehicle deviates to the side
the white or yellow line detected.
Auto cancel
Under the following conditions, the
LDWS is automatically cancelled and
kept on stand-by, and the LDWS warning
light (amber) in the instrument cluster
illuminates.
The system cannot detect white or
yellow lines.
The vehicle speed is less than about 65
km/h (40 mph).
The vehicle is making a sharp turn.
The vehicle is making a turn at an
inadequate speed.
The temperature inside the camera is
high or low.
The windscreen around the camera is
foggy.
The windscreen around the camera is
blocked by an obstruction, causing poor
forward visibility.
The lane indication (bordered line) is
indicated in the active driving display
(Type A instrument cluster
*1 ) or the multi
information display (Type B instrument
cluster
*1 ).
The LDWS is automatically enabled when
the condition changes and the system is
operable.
*1 To determine which instrument cluster
is equipped on your Mazda, Refer to
Meters and Gauges on page 4-24 .
Auto cancel of warning
Under the following conditions, the
LDWS determines that the driver is
making lane changes and the warning is
automatically cancelled.
The LDWS is automatically enabled after
the operation.
The steering wheel is operated abruptly.
The brake pedal is depressed abruptly.
The accelerator pedal is depressed
abruptly.
A direction indicator lever is operated
(after the direction indicator lever is
returned, the LDWS warning may not
operate for about 3 seconds which is the
period of time required to make a lane
correction).
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 262 of 689
4–112
When Driving
i-ACTIVSENSE
NOTE
After about 5 seconds have elapsed
with the direction indicator lever left
operating, the LDWS warning may
operate if the vehicle is close to a
white or yellow line.
The sensitivity of the warning
(sensitivity with which the system
determines the driver's intentional
lane change) can be changed.
Refer to Personalisation Features on
page 9-16 .
Cancelling the System
To cancel the LDWS, press the LDWS
switch. The LDWS indicator light (Green/
Amber) in the instrument cluster turns off.
The lane indication displayed in the
active driving display (Type A instrument
cluster
*1 ) or the multi information display
(Type B instrument cluster *1 ) turns off.
*1 To determine which instrument cluster
is equipped on your Mazda, Refer to
Meters and Gauges on page 4-24 .
LDWS Warning
If the system determines that the vehicle
may be deviating from its lane while the
system is operating, the LDWS warning
sounds and the LDWS indicator light
(green) fl ashes.
Refer to Lane Departure Warning System
(LDWS) Warning Sound on page 7-52 .
In the active driving display (Type
A instrument cluster
*1 ) or the multi
information display (Type B instrument
cluster
*1 ), the direction in which the
system determined that the vehicle may
be deviating from its lane is indicated.
Operate the steering wheel adequately and
drive in the centre of the lane.
*1 To determine which instrument cluster
is equipped on your Mazda, Refer to
Meters and Gauges on page 4-24 .
Indication on display
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 263 of 689
4–113
When Driving
i-ACTIVSENSE
NOTE
If the LDWS warning sound is set to
rumble, the sound will be heard from
the vehicle speaker on the side which
the system determined the vehicle
may be deviating from its lane.
The LDWS warning sound may
not be heard depending on the
surrounding conditions such as
outside noise.
The warning timing with which the
system determines the vehicle may
be deviating from its lane can be
changed.
Refer to Personalisation Features on
page 9-16 .
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 264 of 689
*Some models.4–114
When Driving
i-ACTIVSENSE
Rear Vehicle Monitoring (RVM) System *
The rear vehicle monitoring system is designed to assist the driver in verifying the area
to the rear of the vehicle on both sides during lane changes by alerting the driver of the
presence of vehicles approaching from the rear in an adjacent lane. The system's detection
area extends from the area near the rear edge of the vehicle's front doors to a distance of
about 50 m (164 ft) rearward on both the left and right adjacent lanes. When the system
detects an approaching vehicle, it illuminates the RVM warning indicator light equipped
on the left and right outside mirrors depending on the conditions. If the direction indicator
is operated to either side where the RVM warning indicator light is illuminated, the RVM
warning indicator light starts fl ashing and a warning chime sounds to alert the driver.
A system malfunction or operation conditions are indicated by a warning.
Refer to Warning/Indicator Lights on page 7-35 , 4-118 .
Refer to Rear Vehicle Monitoring (RVM) System Warning Chime on page 7-52 .
Detection area Your vehicle
WARNING
This system is only designed to assist the driver in verifying the area to the rear of the
vehicle before changing vehicle lanes. Before changing vehicle lanes, always verify the
area surrounding the vehicle visually. Due to various limitations on the operation of the
rear vehicle monitoring system, the RVM warning indicator light may not illuminate or
it could be delayed even though another vehicle is present in an adjacent vehicle lane.
Do not rely solely on this system and always verify the area surrounding the vehicle
visually.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 265 of 689
4–115
When Driving
i-ACTIVSENSE
NOTE
The rear vehicle monitoring system operates when all of the following conditions are
satisfi ed:
The ignition is switched ON.
The RVM switch is pressed and the RVM indicator light (green) in the instrument
cluster is illuminated.
The vehicle speed is about 30 km/h (19 mph) or higher.
The rear vehicle monitoring system does not operate under the following conditions:
The vehicle speed falls below 30 km/h (19 mph) even though the RVM indicator
light (green) is illuminated.
The shift lever is shifted into reverse (R) and the vehicle moves in reverse.
In the following cases, the system illuminates the RVM warning light (amber) in the
instrument cluster and stops the operation of the system. If the RVM warning light
(amber) continues to illuminate, have the system inspected at an Authorised Mazda
Dealer as soon as possible:
A malfunction in the system, including the RVM warning indicator light, is detected.
The position of the radar sensors (rear) has changed signifi cantly. The direction
in which the radar sensors (rear) are pointed is factory-adjusted specifi c to the
installation conditions for each vehicle so that they detect approaching vehicles
correctly. If the direction of the radar sensors (rear) has deviated for some reason, it
needs to be readjusted.
Large quantities of snow or ice are on the rear bumper near the radar sensors (rear).
Driving on snow-covered roads for long periods.
The temperature surrounding the radar sensors (rear) becomes extremely high when
the vehicle is driven up-hill for long periods under hot summer weather conditions.
The battery voltage is low.
There is a limit to the detection capability of the radar sensors (rear). In the following
cases, the rear vehicle monitoring system's detection capability may weaken and not
operate normally:
The rear bumper near the radar sensors (rear) is deformed.
Snow, ice or mud adheres to the area near the radar sensors (rear) on the rear
bumper.
Under certain weather conditions including rain, snow, or fog.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 266 of 689
4–116
When Driving
i-ACTIVSENSE
NOTE
It might be impossible or diffi cult for the radar sensors (rear) to detect the following:
Small, two-wheeled vehicles, bicycles, pedestrians, and stationary objects on or at
the edge of the road.
Vehicles with body shapes off of which radar may not refl ect such as unloaded
trailers with a low vehicle height and sports cars.
A vehicle is in the detection area in an adjacent lane to the rear but it is not
approaching. The system makes determinations based on the radar detection data
from approaching vehicles.
Another vehicle is travelling at the same speed alongside the vehicle for extended
periods.
Vehicles approaching from the opposite direction.
Another vehicle which your vehicle is attempting to pass is in an adjacent lane.
A vehicle is in an adjacent lane which is extremely wide. The radar sensors (rear)
detection area is set according to the lane width of general freeways.
In the following cases, the RVM warning indicator light and the warning chime may
not activate or they may be delayed:
Another vehicle moves from a lane two lanes over to the adjacent lane.
When driving on a steep incline.
When going over a mountain pass.
When the turning radius is small (cornering around sharp curves, roundabouts, or
intersections).
There is a difference in height between vehicle lanes.
Immediately after this system is turned on.
If the lane width is extremely narrow, a vehicle in an adjacent lane two lanes over may
be detected. The radar sensors (rear) detection area is set according to the lane width of
general freeways.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 267 of 689
4–117
When Driving
i-ACTIVSENSE
NOTE
The RVM warning indicator light may illuminate for stationary objects in or on the
edge of the road, such as guardrails, tunnels, and side walls.
Objects such as guardrails and concrete walls
running alongside the vehicle.Places where the width between guardrails or
walls on each side of the vehicle narrows.
The walls at the entrance and exits of tunnels,
turnouts.
If a trailer is being towed or a vehicle carrier is equipped to the rear of the vehicle, the
rear vehicle monitoring system may not operate correctly because radar emission could
be obstructed. Turn off the rear vehicle monitoring system.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 268 of 689
4–118
When Driving
i-ACTIVSENSE
RVM Warning Indicator Light
The rear vehicle monitoring system alerts the driver to the presence of another vehicle in
an adjacent lane using the RVM warning indicator lights and the warning chime while the
system is operational.
RVM warning indicator light
The RVM warning indicator lights are installed to the left and right outside mirrors. The
warning indicator light illuminates when a vehicle approaching from the rear in an adjacent
lane is detected. A warning indicator light fl ashes when the direction indicator lever is
operated to the side where the RVM warning indicator light is illuminated to alert the driver.
Illumination dimmer cancel function
Normally, when the headlight switch is turned to the
or position, the brightness of
the RVM warning indicator lights is dimmed when they illuminate.
When driving on snow and fog bound roads where the brightness of the surrounding light
makes it diffi cult to see a RVM warning indicator light while it is dimmed, rotating the
instrument panel illumination knob clockwise fully cancels the dimmer function and restores
the brightness of the RVM warning indicator lights to full brightness.
Refer to Instrument panel Illumination on page 4-28 .
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 269 of 689
4–119
When Driving
i-ACTIVSENSE
RVM Switch
When the switch is pressed, the rear
vehicle monitoring system becomes
operable and the RVM indicator light
(green) illuminates on the instrument
panel. When the switch is pressed
again, the system turns off and the RVM
indicator light (green) turns off.
NOTE
When the ignition is switched off,
the condition before the ignition
was switched off is maintained. For
example, if the ignition is switched
off with the rear vehicle monitoring
system operable, the system will
be operable when the ignition is
switched ON the next time.
If the battery is disconnected or a
fuse is replaced, the rear vehicle
monitoring system will be turned off.
Press the RVM switch to turn this
system on.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 270 of 689
*Some models.4–120
When Driving
i-ACTIVSENSE
Distance Recognition Support System (DRSS) *
The Distance Recognition Support System (DRSS) measures the distance between your
vehicle and a vehicle ahead using a radar sensor while the vehicle speed is 30 km/h or faster
(19 mph or faster), and indicates a recommended distance to maintain between the vehicles.
Furthermore, if your vehicle approaches a vehicle ahead more closely than the appropriate
distance to maintain between the vehicles, the vehicle-ahead indication in the display is
fl ashed to advise the driver to keep a safer distance from the vehicle ahead.
WARNING
Do not rely completely on the Distance Recognition Support System (DRSS) and always
drive carefully:
The Distance Recognition Support System (DRSS) provides advice for safer driving and
notifi es the driver of a recommended, safer distance to maintain with a vehicle ahead.
The ability to detect a vehicle ahead is limited depending on the type of vehicle ahead,
the weather conditions, and the traffi c conditions. Therefore, if the accelerator and
brake pedals are not operated correctly it could lead to an accident. Always verify the
safety of the surrounding area and depress the brake pedal or accelerator pedal while
keeping a safer distance from vehicles ahead or on-coming vehicles.
NOTE
The Distance Recognition Support System (DRSS) operates when all of the following
conditions are met:
The ignition is switched ON.
The Distance Recognition Support System (DRSS) is on.
The selector lever is in a position other than reverse (R).
The vehicle speed is 30 km/h or faster (19 mph or faster).
The objects which activate the system are 4-wheeled vehicles.
The Distance Recognition Support System (DRSS) may also operate in the presence of
motorcycles and bicycles.
The Distance Recognition Support System (DRSS) system may not operate normally
under the following conditions:
The Dynamic Stability Control (DSC) has a malfunction.
The vehicle ahead is travelling at an extremely slow speed.
The system does not operate with the following objects:
Vehicles approaching in the opposite direction.
Stationary objects (stopped vehicles, obstructions)
. B [ E B @ & ' & & " @ & E J U J P O J O E C