AUDIO Clock The clock can be adjusted during radio, tape, or CD play. I Name I Illustration Clock button (clock display) ALC (Auto level controller) Name 1 Illustration ALCJbodysonic volume control knob I Mute button Roof mode button I Stereo-wide button Operation Press button to display present radio frequency or operation mode If power supply to unit is broken (burnt fuse or disconnected battery), clock setup will be canceled When clock button is pushed for 2 seconds, clock display flashes. At this point, press H button to advance hours and M button to advance minutes Press clock button again to return to normal display If clock button is pressed again while clock display is flashing and time has not been adjusted (that is, H and M buttons have not been pressed), min- utes will be set at :00. If time before adjustment showed 30-59 minutes, time will be set at next hour For example, Operation Press knob to turn ALC on or off 1. At ON, ALC adjusts sound corresponding to vehicle speed; ALC indica- tor light turns on 2. To adjust seat vibration, turn knob to right or left Right -t Seat vibration increases Left + Seat vibration decreases Turn knob right or left to transfer sound Right -+ Door speakers Left -t Headrest speakers Press button to lower overall volume by 10dB Press button to switch between roof-open mode and roof-closed mode; sound quality is adjusted depending on whether roof is opened or closed Press button to turn stereo-wide function on or off At ON, stereo-wide mode improves sound quality Gartner Banana
u HEATER I_-K' AIR MIX WlRE -/ AIRFLOW MODE WlRE VENT bm -:JJ 45UOUX-04 AIR INTAKE WlRE / SHUTTER LEVER 45uoux-041 U-22 Inspection 1. Check for continuity between the terminals of the switch. Fan switch ACS Position I I I I I I I I OFF I I Terminal A~B~C~D~E~F~G~H I 1-1 I I I 1- 1- OFF First Second M: Continuity 0-0: Diode 2. If not as specified, replace the switch. Third 0 -0 0 Adjustment Air mix wire 1. Set the temperature-control lever to MAX HOT. 2. Connect and clamp the wire with the shutter lever on the heater unit all the way to the right. 3. Move the temperature-control lever to make sure the -, wire is securely attached and that it moves fully from HOT to COLD. Airflow mode wire 1. Set the mode lever to VENT. 2. Connect and clamp the wire with the shutter lever on the heater unit at its closest point. 3. Move the mode lever to make sure the wire is securely attached and that it moves fully from DEF to VENT. 0 RECIFRESH wire 1. Set the REC/FRESH lever to FRESH. 2. Connect and clamp the wire with the shutter lever on the blower unit at its closest point. 3. Move the RECJFRESH lever to make sure the wire is se- curely attached and that it moves fully from REC to FRESH. u 0 0-4 Gartner Banana
