transmission MAZDA MX-5 1994 Workshop Manual

TECHNICAL DATA :em - ange - D - S Transmission Mode NC4A-EL HOLD - POWER HOLD POWER HOLD -ine pressure Vehicle speed kmlh {mph) 27-33 {I 7-20) 3545 {22-27) 152-1 58 (94-97) 12-1 8 (8-1 1) 95-1 05 {59--65) 5-4 (36--39) 1 OO--108 {62--66) 98-1 05 (6 145) 44-55 {28--34) 9&108 {56--67) 94--106 {58--66) 11-17 (7-10) 92-1 00 (5742) 4248 (2629) 99--105 {61-65) 95-1 05 (59-45) 56-62 {35-38) 44-55 (27-34) 96-104 {60-64) 11-17 {7-10) 99-1 05 {61--65) 4248 {26-29) 3541 (21-25) 95--105 (59-65) 775-970 {7.9-9.9, 11 3-1 40) 1,972-2,167 l20.1-22.1,286--314) 285-362 {2.9-3.7,42-52) 795-91 2 (8.1-9.3, 11 61 32) 785-921 (8.G9.4, 114-1 33) 79S912 {8.1-9.3, 116--132) 29!5-392 {3.0-4.0,43-56) 883-1,078 I9.0-11 .O, 128-1 56) 2.1 00-2,500 Throttle condition All positions Wide open throttle Half throttle Closed throttle position Kickdown (Wide open throttle) All positions Wide open throttle Half throttle Closed throttle position Kickdown (Wide open throttle) All positions R range kPa {kgf/cm2, psi) D range kPa {kgf/cm2, psi) S range kPa {kgf/cm2, psi) L range kPa {kgf/cm2, psi) I Shift Dl432 D2-'D3 D443 D3+D1 DS lockup ON s142 s2+s3 S3 lockup ON S142 S2-'s3 S3 lockup ON S3+S1 s3-'s2 s241 s3+s2 S3 lockup ON Ld-2 L14-2 L3+L2 L241 L3-'L2 L2-4-1 L241 L3 lockup ON Idle Stall Idle Stall Idle Stall Idle Stall r~m L. PROPELLER SHAFT Adjusting rod length mm {in) 29.0 {I .14) 29.5 {I. 16) 29.75 (1.1 7) 30.0 {I .18) 30.5 (1.20) 31 .O (1.22) 0.5-0.6 0.75-0.85 'ngine stall speeo Item Max. permissible run-out mm {in) lacuum dia- thragm Time lag Specification 0.4 {0.016) Clearance between body and throttle valve mm {in) Below 25.65 {I ,0099) 25.65-25.15 {I .0099-1.0295) 25.90-26.40 {I ,0197-1.0394) 26.1 5-26.65 (1.0295-1.0492) 26.65--27.15 {I .0492-1.0669) 27.1 5 {1.0689} or over N - D sec. N-R sec. L-' Gartner Banana

SPECIAL TOOLS .................... GENERAL INFORMATION ST- 2 ..................................... ENGINE ST- 3 CLUTCH AND MANUAL TRANSMISSION ...... ST- 4 ................. AUTOMATIC TRANSMISSION ST- 5 .............................. DIFFERENTIAL ST- 6 ................... FRONT AND REAR AXLES ST- 7 ......................... STEERING SYSTEM ST- 7 .......................... BRAKING SYSTEM ST- 9 ........... FRONT AND REAR SUSPENSIONS ST-1 0 CHECKERS AND OTHER EQUIPMENT ........ ST-10 4SUOTX-001 Gartner Banana

ST SPECIAL TOOLS CLUTCH AND MANUAL TRANSMISSION TOOL NUMBER d DESCRIPTION PRIORITY ILLUSTRATION PRIORITY ILLUSTRATION 49 SEOl 310A Centering tool, clutch disc Wrench, flare nut 49 0259 440 Holder, mainshaft Guide, interlock pin assembly Wrench, mainshaft lock nut Guide, shift fork assembly 49 0500 330 Installer, bearing Puller, fan pulley boss Puller set, bearing 'usher, main jrive shaft 49 H017 101 Hook $9 071 0 520 Uler, bearing 19 8025 OAO nstaller, dust seal nstaller, main hive gear maring 19 1285 071 'uller, bearing nstaller set, ~aring Gartner Banana

SPECIAL TOOLS ST AUTOMATIC TRANSMISSION ILLUSTRATION rooL NUMBER I DESCRIPTION rooL NUMBER DESCRIPTION 490378400A Gauge set, oil pressure PRIORITY PRIORITY ILLUSTRATION Compressor, clutch spring 49 GO30 795 Installer, oil seal Gauge, oil pressure 49 H019 002 Adapter 49 0378 390 Puller, oil pump 49 SO1 9 OAO Centering tool set Adapter 49 U019 OAOA 49 GO32 355 Adjust gauge Hanger set, transmission 49 0378 346 rlexhead wrench 49 0877 435 Special wrench Gartner Banana

u GENERAL SERVICE INFORMATION TIEDOWN HOOK - FRONT /'-- TIEDOWN HOOK - REAR -?-A TOWING Proper towing equipments are necessary to prevent damage to the vehicle during any towing operation. Laws and regulations applicable to vehicles in tow must always be observed. Release the parking brake, place the shift lever in neutral, and set the ignition switch in the ACC posi- tion. As a rule, towed vehicles should be pulled with the driving wheels off the ground. WITH MANUAL TRANSMISSION If the transmission, rear axle, and steering system are not damaged, the vehicle may be towed on all four wheels. If any of these components are damaged, use a towing dolly. CAUTION The power assist for the brakes and steering are inoperable while the engine is off. Do not use the tiedown hooks under the front or rear of the vehicle for towing. These hooks are designed ONLY for transport tiedown. If the tiedown hooks are used for towing, the front or rear skirt and bumper will be damaged. IDENTIFICATION NUMBER LOCATIONS VEHICLE IDENTIFICATION NUMBER (VIN) ENGINE MODEL AND NUMBER L i Gartner Banana

1700 -1 * TRANSHf5s:ON CASE (MANUAL) 17110 TRANSMISSION CASE (MANUAL) CASE T/MISSION BOLT PLUG ,M4BNET COVER, BEAR1 HG HOUSING, EXTENSION SEAL ,OIL GEAR, DR I VEN N.22 SLEEVE, SPEEDOHETGR SEAL 4 &REAT ON OIL HEH,AIR-+TIMISSI Gartner Banana