ESP MITSUBISHI COLT 2008 (in English) Owner's Guide

8-34 Maintenance
8
●Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.
● The table above shows the ma in equipment corresponding
to each fuse.
Identification of fuse
39 Ignition coil (Petrol-powered
vehicles)
10 A
O2 sensor (Diesel-powered vehi-
cles)
40 Gauge 7.5 A
41 Relay 7.5 A
42 Stop lamps 15 A
43 — ——
44 — ——
No. Symbol Electrical systemCapacity
7.5 A Brown
10 A Red
15 A Blue
20 A Yellow
30 A Green
40 A Orange (fuse type) / Green (fusible link type)

8-36 Maintenance
8
3. Referring to the fuse load capacity table, check the appro-
priate fuse for the problem.
NOTE● If any system does not function but the fuse corresponding
to that system is normal, th ere may be a fault elsewhere in
the system. We recommend that you have your vehicle
checked. 4. Insert a new fuse of the same capacity by using the fuse
puller and insert the fuse at the same place in the fuse
block.
A- Fuse is OK
B- Blown fuse
CAUTION!
● If the newly inserted fuse blows again after a short
time, we recommend that yo u have the electrical sys-
tem checked to find th e cause and rectify it.
●Never use a fuse with a capacity larger than that
specified or any substitute, such as wire, foil, etc.;
doing so will caus e the circuit wiring to heat up and
could cause a fire.