tow bar MITSUBISHI ENDEAVOR 2004 Service Repair Manual

C. Using Puller Shaft (MB990242), Puller Bar (MB990244), Puller Body
(MB991354), and End Yoke Holder (MB990767), push out the axle shaft
assembly and inner shaft assembly (if equipped) from the hub. Remove the
axle shaft from the hub buy pulling the bottom of the brake disc towards you.
Insert a pry bar between the transaxle case and the axle shaft, then pry and
remove the axle shaft from the transaxle. See Fig. 8
. If the inner shaft is hard
to remove from the transaxle, strike the bracket assembly lightly with a plastic
hammer and remove the inner shaft.
D. Use Slide Hammer (MB991721) to remove the output shaft. CAUTION: When pulling the output shaft out from the
transaxle, be careful that the splined part of the
output shaft does not damage the oil seal.

2004 Mitsubishi Endeavor LS
2004 DRIVE AXLES Axle Shafts - Front - Endeavor