jacking points MITSUBISHI GRANDIS 2008 Owner's Manual (in English)

6-14 For emergencies
6
6. Place the jack under one of the jacking points (C) shown
in the illustration. Use the jacking point closest to the tyre
you wish to change.7. Rotate the jack by hand until the flange portion (D) fits in
the groove (E) at the top of the jack.
8. Remove the wheel nut wrench and bar from under the
third seat. (Refer to “Tools and jack” on page 6-10.)
WARNING
!●Set the jack only at the positions shown here. If the
jack is set at a wrong position, it could dent your
vehicle or the jack might fall over and cause per-
sonal injury.●Do not use the jack on a tilted or soft surface.
Otherwise, the jack might slip and cause personal
injury. Always use the jack on a flat, hard surface.
Before setting the jack, make sure there are no sand
or pebbles under the jack base.
BK-XP08E1ENUK.en-uk.book Page 14 Monday, August 13, 2007 2:20 PM