light MITSUBISHI iMiEV 2012 1.G Repair Manual

Features and controls
3-53
3
NOTE
To avoid the risk of damage to the tire inflation pressure
sensors, have any punctured tire repaired by a certified i-
MiEV dealer. If the tire repair is not done by a certified i-
MiEV dealer, it is not covered by your warranty.

Do not use an aerosol puncture-repair spray on any tire.
Such a spray could damage the tire inflation pressure sen-
sors.

Using the tire repair kit may damage the tire inflation
pressure sensor. The vehicle must promptly be inspected
and repaired by a certified i-MiEV dealer after using the
tire repair kit.The tire pressure monitoring system may not work normally in
the following circumstances:

A wireless facility or device using the same frequency is
near the vehicle.

Snow or ice is stuck inside the fenders and/or on the
wheels.

The tire inflation pressure sensors’ battery is exhausted.

Wheels other than Mitsubishi Motors genuine wheels are
being used.

Wheels that are not fitted with tire inflation pressure sen-
sors are being used.

Wheels whose ID codes are not memorized by the vehicle
are used.

A window tint that affects the radio wave signals is
installed.
NOTE
Tire inflation pressures vary with the ambient tempera-
ture. If the vehicle is subjected to large variations in ambi-
ent temperature, the tire inflation pressures may be under-
inflated (causing the warning light to come on) when the
ambient temperature is relatively low. If the warning light
comes on, adjust the tire inflation pressure.
WA R N I N G
!
If the tire pressure monitoring system warning light
illuminates while you are driving, avoid hard brak-
ing, sharp steering maneuvers and high speeds.
Driving with an under-inflated tire adversely affects
vehicle performance and can result in an accident.
CAUTION
!
The tire pressure monitoring system warning light
may not illuminate immediately in the event of a tire
blowout or rapid leak.
BK0140800US.book 53 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-58 Features and controls
3
NOTE
Mirror image is displayed on the screen.

Monitor brightness is adjusted automatically by sensors.

It is possible to change the display language of the screen.
For details, please refer to the separate owner’s manual for
“Mitsubishi Multi-Communication System”.

Under certain circumstances, it may become difficult to
see an image on the screen, even when the system is func-
tioning correctly.
• In a dark area, such as at night.
• When water drops or condensation are on the lens.
• When sunlight or headlights shine directly into the lens.
Instrument cluster
N00519000375
1- Energy level gauge
2- Energy usage indicator
3- Odometer/Trip odometer/Dash lights brightness indica-
tor/Service reminder/Cruising range indicator/Outside
temperature display
4- Speedometer
5- Reset button/Dash lights illumination button/Selector
button
BK0140800US.book 58 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-61
3
Odometer/Trip odometer/Dash lights brightness
indicator/Service reminder/Cruising range indi-
cator/Outside temperature display
N00519500439
With the electric motor switch in the “ON” position, odometer,
trip odometer, dash lights brightness indicator, service
reminder, cruising range indicator, and outside temperature are
displayed.To change the display
N00572200015
The display is changed every time the reset button (A) is
briefly pressed.
BK0140800US.book 61 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-62 Features and controls
3
NOTE
The cruising range indicator and outside temperature dis-
play are indicated when the electric motor switch is in the
“ON” position.

If there is no operation for about 10 seconds when the
meter illumination control or service reminder is shown,
the display returns to the odometer.Odometer
N00572300016
The odometer indicates the total distance the vehicle has trav-
eled.NOTE
Even if the electric motor switch is turned to “ACC” or
“LOCK”, the odometer will be displayed for about 30 sec-
onds after the reset button is pressed.
1- Odometer
2-
Trip odometer
3-
Trip odometer
4- Dash lights brightness indicator
5- Service reminder (Drive distance remaining until next
inspection)
6- Service reminder (Number of months remaining until next
inspection)
7- Cruising range indicator
8- Outside temperature display
BK0140800US.book 62 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-66 Features and controls
3
Dash lights brightness indicator
N00572600019
Each time you press the dash lights illumination button (B), the
brightness of the instruments changes.
NOTE
You can adjust to 4 different levels for when the parking
lights or headlights are illuminated and 4 for when they
are not.

If you press and hold the button for longer than about 1
second, the brightness automatically scrolls through its
different levels, and stops scrolling when you release the
button. Select your desired level of brightness.

When the combination headlights and dimmer switch is in
the “AUTO” position, the meter illumination switches
automatically to the adjusted brightness, depending on the
brightness outside the vehicle.

The brightness level of the instruments is stored when the
electric motor switch is turned off.

If the 12V starter battery is disconnected for a long time,
these level of brightness will be reset.
A- Brightness display
B- Dash lights illumination button
Bright Dim
BK0140800US.book 66 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-70 Features and controls
3
NOTE
If the energy level gauge shows 0 bars during use of the
air conditioning, the cooling or heating may stop opera-
tion and the mode is changed to fan only.

If the energy level gauge shows 0 bars, the power down
warning light is illuminated to control the output.

If the energy level gauge shows 2 bars while the main
drive lithium-ion battery is being charged, the warning
indicator flashes. If the energy level gauge shows 1 bar
while the main drive lithium-ion battery is being charged,
the warning indicator and the charging bars flash alter-
nately.
BK0140800US.book 70 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-71
3 Indicator and warning light package
N00519800836
1- Low energy warning indicator → P.3-69
2- Selector lever position indicator → P.3-34
3- Acoustic Vehicle Alerting System (AVAS) indicator
→ P.3-38
4- High-beam indicator → P.3-72
5- Turn-signal indicators/Hazard warning lights → P.3-72
6- Position indicator → P.3-72
7- Front fog light indicator (if so equipped) → P.3-72
8- Service reminder → P.3-63
9- Outside air temperature warning indicator → P.3-67
10- Regenerative brake system indicator → P.3-72
11- Ready indicator → P. 3 - 7 2
12- Tire pressure monitoring system warning light → P.3-50
13- 12V starter battery charging system warning light → P.3-7414- Electric power steering system warning light → P.3-45
15- Electric motor unit warning light → P.3-75
16- Brake warning light → P.3-73
17- Anti-lock braking system warning light → P.3-42
18- Power down warning light → P.3-75
19- Active stability control (ASC) indicator → P.3-48
20- Active stability control (ASC) OFF indicator → P.3-48
21- Charging indicator → P.3-72
22- Theft-alarm indicator → P.3-18
23- Door-ajar warning light → P.3-74
24- Driver ’s seat belt reminder/warning light → P.2-17
25- Supplemental Restraint System (SRS) warning light
→ P. 2 - 2 2
BK0140800US.book 71 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-72 Features and controls
3Indicators
N00519900127
Turn signal indicators/Hazard warning lights
N00520000232
The arrows will flash in time with the corresponding exterior
turn signals when the turn signal lever is used.
Both arrows will flash when the hazard warning flasher switch
is pressed.NOTE
If the indicator flashes faster than usual or if the indicator
stays on without flashing, check for a malfunctioning turn
signal light bulb or turn signal connection.High beam indicator
N00520100086
A blue light comes on when the headlights are on high beam.Front fog light indicator
(if so equipped)
N00520200221
This indicator comes on while the front fog lights are on.Position indicator
N00551300039
This indicator turns on while the position lights are on.Ready indicator
N00573200012
This indicator comes on when the electric motor switch is
turned to “START” and driving becomes possible.
Charging indicator
N00573300013
This indicator flashes when the regular charging cable or quick
charging cable is connected.
After that, the light switches to being illuminated when charg-
ing starts and goes out when charging is completed.Regenerative brake system indicator
N00573400014
The indicator comes on when the regenerative brake perfor-
mance may be weakened. In this case, drive the vehicle at a
lower speed.
BK0140800US.book 72 ページ ２０１１年９月２９日　木曜日　午後３時２８分

Features and controls
3-73
3 Wa r n i n g l i g h t s
N00520300147
Brake warning light (brake warning buzzer)
N00520400500
This light comes on when the electric motor switch is turned to
the “ON” position, and goes off after a few seconds.
The light will illuminate under the following conditions:

When the parking brake has been engaged.

When the brake fluid level in the reservoir falls to a low
level.

When there is a fault in the brake vacuum pressure sys-
tem.

When the brake force distribution function is not operat-
ing correctly.
Before driving your vehicle, release the parking brake and
make certain that the brake warning light has gone out.
Brake warning buzzer
Vacuum pressure is used to help reduce brake pedal effort. If
this vacuum pressure becomes insufficient, a buzzer will sound
to alert the driver that the effort required to apply the brakes
may increase. If the buzzer should continue to sound, park your
vehicle in a safe place and contact a certified i-MiEV dealer.NOTE
When the brake pedal has been repeatedly depressed over
a short period of time, the brake warning light may illumi-
nate and the brake warning buzzer may sound because the
vacuum pressure is temporarily low. It is normal if the
light goes out and the buzzer stops sounding after a few
seconds.
NOTE
At times, you may hear the brake electric vacuum pump
for the power brakes operating when the ready indicator
illuminates or the brake pedal is depressed.
This sound is normal and does not indicate a problem.
CAUTION
!
If any of the following situations occur, stop the
vehicle in a safe location, avoiding any sudden brake
application, and contact a certified i-MiEV dealer.
• The brake warning light does not illuminate when
the parking brake is applied or does not turn off
when the parking brake is released.
• The brake warning light illuminates while the
parking brake is not applied.
• The brake warning buzzer does not turn off.
BK0140800US.book 73 ページ ２０１１年９月２９日　木曜日　午後３時２８分

3-74 Features and controls
3
12V starter battery charging system warning
light
N00573500028
This light will illuminate when there is a problem with the
charging system for the 12V starter battery.
Normally, when the electric motor switch is turned to the “ON”
position, this light will illuminate. Then, when the electric
motor unit is started and the ready indicator illuminates, the
light will go out.
Door-ajar warning light and buzzer
N00520900316
This light comes on when any door or liftgate is open or not
completely closed.
When the vehicle is moving at more than 5 mph (8 km/h) and
any door or liftgate is open or ajar, a tone will sound 16 times
and the warning light will flash 16 times to inform the driver
that a door or liftgate is not properly shut.NOTE
The flashing of the warning light and the buzzer can be
disabled.
For further details, please contact a certified i-MiEV
dealer.

When the driver’s door is open, the door-ajar warning
buzzer does not sound because the electric motor
reminder sounds instead.
CAUTION
!
If the warning light stays on after the ready indica-
tor illuminates, there may be a problem with the
charging system for the 12V starter battery.
• Immediately park your vehicle in a safe place and
contact a certified i-MiEV dealer.
• Do not charge the 12V starter battery.
CAUTION
!
Before driving, make sure that the door-ajar warn-
ing light is off.
BK0140800US.book 74 ページ ２０１１年９月２９日　木曜日　午後３時２８分