window MITSUBISHI MIRAGE 2014 6.G Service Manual

5-22 Comfort controls
5
When the air conditioning turns on, the air selection is con-
trolled automatically. When the air conditioning turns off, the
air selection automatically goes back to the outside air position.
If high cooling performance is desired, or if the outside air is
dusty or contaminated in some way, use the recirculation posi-
tion. Switch to the outside air position every now and then to
keep the windows from fogging up.NOTE
If you press the AUTO switch to select automatic control
after manual operation, the air selection switch will also
be automatically controlled.
Personalizing the air selection (Changing the function
setting)
N00760000089
You can change the following functions to match your prefer-
ence.

Enable automatic air control:
When the AUTO switch is pressed, the air selection
switch will also be automatically controlled.

Disable automatic air control:
Even when the AUTO switch is pressed, the air selection
switch will not be automatically controlled.

Changing the settings
Press the air selection switch for about 10 seconds or
longer.
When the setting has changed, the system will beep and
the “ ” indicator will flash.
• When the setting has changed from enabled to disabled,
the system will beep three times and the indicator will
flash three times.
• When the setting has changed from disabled to enabled,
the system will beep two times and the indicator will
flash three times.
CAUTION
!
Using recirculated air for a long time may cause the
windows to fog up.
BK0162600US.book 22 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-23
5
NOTE
The factory setting is “Enable automatic air control”.

When the defogger switch is pressed, the air selection will
automatically change to the outside air position, even if
the system is set to “Disable automatic air control”, in
order to prevent windows from fogging up.
Air conditioning switch
N00737300343
Push the switch, and the air conditioning compressor will turn
on. The “ ” indicator will be shown in the display (A).
Push the switch again and the air conditioning compressor will
stop and the indicator goes off.
CAUTION
!
Using the air conditioning slightly increases the
engine idle speed. Therefore, make sure your foot is
firmly on the brake pedal when shifting the
transaxle into drive.
BK0162600US.book 23 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-24 Comfort controls
5
Personalizing the air conditioning switch (Changing
the function setting)
N00759800090
You can change the following functions to match your prefer-
ence.

Enable automatic air conditioning control:
When the AUTO switch is pressed, or when the tempera-
ture control switch has been set to the minimum tempera-
ture, the air conditioning switch is automatically
controlled.

Disable automatic air conditioning control:
The air conditioning switch is not automatically con-
trolled, unless the air conditioning switch is used.

Changing the settings
Press the air conditioning switch for about 10 seconds or
longer.
When the setting has changed, the system will beep and
the “ ” indicator will flash.
• When the setting has changed from enabled to disabled,
the system will beep three times and the indicator will
flash three times.
• When the setting has changed from disabled to enabled,
the system will beep two times and the indicator will
flash three times.
NOTE
The factory setting is “Enable automatic air conditioning
control”.

When the defogger switch is pressed, the air conditioning
will run automatically, even if the system is set to “Dis-
able automatic air conditioning control”, in order to pre-
vent windows from fogging up.
BK0162600US.book 24 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-26 Comfort controls
5
Operating the air conditioning system (automatic
mode)
N00731700361
In normal conditions, use the system in the AUTO mode and
follow these procedures:
1. Push the AUTO switch.
2. Set the temperature control switch to the desired tempera-
ture. The temperature can be set within a range of around
61 to 89 (Type 1) or 17 to 31 (Type 2).
The vents, recirculation/outside air, blower speed, temperature
adjustment and ON/OFF of air conditioning will be controlled
automatically.NOTE
Set the temperature at about 75 (Type 1) or 24 (Type 2)
under normal conditions.
Operating the air conditioning system (manual
mode)
N00731800115
Blower speed and vent mode may be controlled manually by
setting the blower speed selection switch and the MODE
switch to the desired positions. To return to automatic opera-
tion, press the AUTO switch.Defrosting or defogging (windshield, door windows)
N00732400466
To remove frost or mist from the windshield and door win-
dows, use the MODE switch or defogger switch (“ ” or
“”).
CAUTION
!
For safety, make sure you have a clear view through
all the windows.
BK0162600US.book 26 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-27
5
For ordinary defrosting
Use this setting to keep the windshield and door windows clear
of mist, and to keep the leg area heated (when driving in rain or
snow).
1. Set the MODE switch to the “ ” position.
2. Set the air selection switch to the outside air position.
3. Select your desired blower speed by pressing the blower
speed selection switch.
4. Select your desired temperature by pressing the tempera-
ture control switch.
5. Push the air conditioning switch.For quick defrosting

1. Push the defogger switch to change to the “ ” position.
2. Set your blower to the maximum speed.
3. Set the temperature to the highest position.
BK0162600US.book 27 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-28 Comfort controls
5
NOTE
While the mode selection is set “ ” position, the air con-
ditioning compressor will run automatically. The outside
air position will also be selected automatically.

If the mode selection is set “ ” position, you cannot turn
the air conditioning off or select the recirculation position.
This prevents the windows from fogging up.

To defog quickly, direct the air flow from the side vents
toward the door windows.

When defrosting, do not set the temperature to the maxi-
mum cool position. This will blow cool air on the window
glass and fog it up.
Important air conditioning operating tips
N00733700336
1. Park the vehicle in the shade whenever possible. Parking
in the hot sun makes the vehicle interior extremely hot
which then requires more time to cool. If it is necessary to
park in the sun, open the windows for the first few min-
utes of air conditioning to expel the hot air.
2. Afterwards, keep the windows closed when the air condi-
tioning is in use. The entry of outside air through open
windows will reduce cooling efficiency.
3. When running the air conditioning, make sure the air
intake, which is located in front of the windshield, is free
of obstructions such as leaves. Leaves collected in the air-
intake chamber may reduce air flow and plug the water
drains.Air conditioning system refrigerant and lubri-
cant recommendationsIf the air conditioning seems less effective than usual, the cause
might be a refrigerant leak.
Have the system inspected by your authorized Mitsubishi
Motors dealer or a repair facility of your choice.
BK0162600US.book 28 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-29
5
During a long period of disuseThe air conditioning should be operated for at least five min-
utes each week, even in cold weather. This includes the quick
defrosting mode. Operating the air condition system weekly
maintains lubrication of the compressor internal parts to keep
the air conditioning in the best operating condition.
Air purifier
(if so equipped)
N00733800180
The air conditioning system is equipped with an air filter to
remove pollen and dust.
The air filter’s ability to collect pollen and dirt is reduced as it
becomes dirty, so replace it periodically. For the maintenance
interval, refer to the “WARRANTY AND MAINTENANCE
MANUAL”.NOTE
Operation in certain conditions such as driving on a dusty
road and frequent use of the air conditioning can lead to
reduction of service life of the filter. When you feel that
the air flow is lower than normal or when the windshield
or windows start to fog up easily, replace the air filter.
Contact your Mitsubishi Motors dealer or a repair facility
of your choice for assistance.
CAUTION
!
The air conditioning system in your vehicle must be
charged with the refrigerant HFC-134a and the
lubricant ZXL 200PG.
Use of any other refrigerant or lubricant will cause
severe damage and may require replacing your vehi-
cle’s entire air conditioning system.
The release of refrigerant into the atmosphere is not
recommended.
The new refrigerant HFC-134a in your vehicle is
designed not to harm the earth’s ozone layer. How-
ever, it may contribute slightly to global warming.
It is recommended that the old refrigerant be saved
and recycled for future use.
BK0162600US.book 29 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-36 Comfort controls
5
To fast-forward/reverse the discFast-forward
The disc is fast-forwarded while the button is held down.
Playback will begin once the button is released.
Fast-reverse
The disc is fast-reversed while the button is held down.
Playback will begin once the button is released.To select a desired trackTrack up
The disc will skip as many songs as the number of times the
button is pressed.
The display window will display the track number of the track
selected.
Track down
The disc will skip as many songs as the number of times the
button is pressed.
The display window will display the track number of the track
selected.
To find a file (MP3 CDs only)Operate the SEL switch to select desired file.
When this mode is activated by pressing the SEL switch, the
SEL indicator will be displayed in the display.NOTE
To cancel the selection, press the button to return to the
previous step.

If no operation is performed for 10 seconds or more or
other button is operated after the SEL switch has been
turned, searching of the desired file is canceled.

If no operation is performed for 5 seconds or more after
the file is displayed, playback starts.

When the SEL indicator is not shown on the display and
the SEL switch is operated, the volume adjustment is acti-
vated.Press the SEL switch : To start this mode or to select the folder
or file.
Turn the SEL switch : To show the folder or file
BK0162600US.book 36 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Vehicle care and maintenance
7-7
7
NOTE
If this does not close the engine hood properly, drop it
again from a slightly higher position.

Do not push down strongly on the engine hood. Depend-
ing on how strongly or where you push down, you could
create a dent in the vehicle body.
View of the engine compartment
N00937600713
1- Engine oil level dipstick
2- Air cleaner filter
3- Battery
4- Brake fluid
5- Windshield and rear window washer fluid reservoir
6- Engine oil filler cap
7- Radiator cap
8- Engine coolant reserve tank
BK0162600US.book 7 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Vehicle care and maintenance
7-15
7 Continuously variable transmission (CVT)
fluid
(if so equipped)
N00938100089
The continuously variable transmission (CVT) should be main-
tained and serviced by an authorized Mitsubishi Motors dealer
or a repair facility of your choice to obtain the best perfor-
mance and longest life. It is important that the transmission
fluid is kept at the correct level.Fluid typeUse only “Mitsubishi Motors Genuine CVTF-J4” transmission
fluid to ensure optimum transmission performance.Special additivesDo not use any fluid additives to the transmission.
Wa s h e r f l u i d
N00938600316
The windshield and rear window washer fluid reservoir is in
the engine compartment.
Check the washer fluid level at regular intervals and add
washer fluid to reservoir if necessary.
Open the reservoir cap and check the level of washer fluid.
When freezing weather is anticipated, flush out the water in the
reservoir by operating the pump. Fill the reservoir with
windshield antifreeze (not radiator antifreeze), and operate the
system for a few seconds to flush out the residual water.
BK0162600US.book 15 ページ ２０１３年３月２２日　金曜日　午後２時４１分