ESP inoperative MITSUBISHI MONTERO 2000 Service Repair Manual
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2000, Model line: MONTERO, Model: MITSUBISHI MONTERO 2000Pages: 1839, PDF Size: 29.19 MB
Page 504 of 1839
DIESEL FUEL <4M4> -Troubleshooting13C-13
Code No. 18 Engine speed sensor (backup) systemProbable cause
Range of Check
DExcept for duringengine running andcranking
Set Conditions
DThe difference in the enginespeed sensor output for 4 seconds: 325 r/min or
moreDEngine speed sensor inoperative
DEngine speed sensoropencircuit, short circuit, or
connector contact inoperative
DEngine-ECU inoperative
Check the trouble symptoms.
OK
Check and repair the harness
between the enginespeed sensor
and the control relay connector.OK
OK
NG
Repair
(1) NGMeasure at B-36-2 enginespeed
sensor connector
DConnect the connector.
(Test harness: MB998348 used)
DVoltage between 2 and the earth
(Engine: cranking)
OK:
0.4 - 4.0 V
DVoltage between 2 and the earth
(Engine: Idling)
OK:
1.5 - 2.5 V
NG
Replace the enginespeed sensor.
Replace the engine-ECU.
Check the following connector:
B-36
NG
NG
Check the trouble symptoms.
OK
Repair NG
OK
Repair NG NG
OKRepair NG
NG
OKRepair NG
Check the following connector:
B-36-2
Check the trouble symptoms.
Measure at B-36-2 enginespeed
sensor connector
DDisconnect the connector and
measure at the harness side.
(1) Voltage between 3 and the earth
(Ignition switch: ON)
OK:
System voltage
(2) Voltage between 2 and the earth
(Ignition switch: ON)
OK:
4.8 - 5.2V
(3) Continuity between 1 and the
earth
OK:
Continuity(2) NG
(3) NG
Check the harness between the
engine-ECU and the enginespeed
sensor connector.
Replace the engine-ECU.
Check and repair the harness
between the enginespeed sensor
and the earth.
Check the following connector:
B-36
Check the trouble symptoms.
Check the following connectors:
B-36, D-112
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk
Page 505 of 1839
DIESEL FUEL <4M4> -Troubleshooting13C-14
Code No. 21 Engine speed sensor systemProbable cause
Range of Check
DDuring enginecranking
Or
DExcept for duringengine running andcranking
Set Conditions
DNo change in the sensor output voltage for 3 seconds (no pulse signal has
been input).
Or
DNo change in the enginespeed sensor output for 0.06 seconds (for backup),
or in the sensor output for 0.3 secondsDEngine speed sensor inoperative
DEngine speed sensoropencircuit, short circuit, or
connector contact inoperative
DEngine-ECU inoperative
OK
Check and repair the harness
between the enginespeed sensor
and the control relay connector.OK
OK
NG
Repair
(1) NGMeasure at B-36-1 enginespeed
sensor connector
DConnect the connector.
(Test harness: MB998348 used)
DVoltage between 2 and the earth
(Engine: cranking)
OK:
0.4 - 4.0 V
DVoltage between 2 and the earth
(Engine: idling)
OK:
1.5 - 2.5 V
NG
Replace the enginespeed sensor.
Replace the engine-ECU.
Check the following connector:
B-36
NG
NG
Check the trouble symptoms.
OK
Repair
Check the following connectors:
B-36, D-112
NG
OK
Repair NG
Check the harness between the
engine-ECU and the enginespeed
sensor connector.NG
Check the trouble symptoms.
Replace the engine-ECU.
Check and repair the harness
between the enginespeed sensor
and the earth.OK
Repair
Check the following connector:
B-36
NG
NG
Check the trouble symptoms. OK
Repair NG
Check the following connector:
B-36-1
Check the trouble symptoms.
Measure at B-36-1 enginespeed
sensor connector
DDisconnect the connector and
measure at the harness side.
(1) Voltage between 3 and the earth
(Ignition switch: ON)
OK:
System voltage
(2) Voltage between 2 and the earth
(Ignition switch: ON)
OK:
4.8 - 5.2V
(3) Continuity between 1 and the
earth
OK:
Continuity(2) NG
(3) NG
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk
Page 590 of 1839
13E-1
MITSUBISHI STABILITY
CONTROL
(MITSUBISHI SC)
CONTENTS
GENERAL INFORMATION 2................
SERVICE SPECIFICATIONS 4..............
SPECIAL TOOLS 4........................
TROUBLESHOOTING 5....................
ON-VEHICLE SERVICE 18.................
Operation Test of MITSUBISHI SC 18.........Wheel Speed Sensor (FR) Check 18..........
Vehicle Speed Sensor Check 18..............
SC-ECU* 19...............................
G SENSOR 20.............................
WHEEL SPEED SENSOR (FR) 20..........
VEHICLE SPEED SENSOR 20..............
WARNINGS REGARDING SERVICING OF SUPPLEMENTAL RESTRAINT SYSTEM (SRS) EQUIPPED VEHICLES
WARNING!
(1) Improper service or maintenance of any component of the SRS, or any SRS-related component, can lead to personal
injury or death to service personnel (from inadvertent firing of the air bag) or to the driver and passenger (from rendering
the SRS inoperative).
(2) Service or maintenance of any SRS component or SRS-related component must be performed only at an authorized
MITSUBISHI dealer.
(3) MITSUBISHI dealer personnel must thoroughly review this manual, and especially its GROUP 52B - Supplemental
Restraint System (SRS) before beginning any service or maintenance of any component of the SRS or any SRS-related
component.
NOTE
The SRS includes the following components: front impact sensors, SRS-ECU, SRS warning lamp, air bag module, clock spring and
interconnecting wiring. Other SRS-related components (that may have to be removed/installed in connection with SRS service or
maintenance) are indicated in the table of contents by an asterisk (*).
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk
Page 902 of 1839
Page 1310 of 1839
37A-1
STEERING
CONTENTS
GENERAL INFORMATION 2..................
SERVICE SPECIFICATIONS 5.................
LUBRICANTS 5..............................
SEALANT AND ADHESIVE 5.................
SPECIAL TOOLS 6..........................
ON-VEHICLE SERVICE 8.....................
Steering Wheel Free Play Check 8..............
Steering Angle Check 8........................
Tie Rod End Ball Joint Starting Torque Check 8..
Stationary Steering Effort Check 9...............
Steering Wheel Returnability Check 9............
Oil Pump Belt Tension Check <6G7,4D5> 9......Power Steering Fluid Level Check 10............
Power Steering Fluid Replacement 10...........
Power Steering System Bleeding 10.............
Oil Pump Pressure Test 11.....................
Power Steering Oil Pressure Switch Check
<6G7,4M4> 12.................................
Ball Joint Dust Cover Check 12.................
STEERING WHEEL AND SHAFT* 13.........
POWER STEERING GEAR BOX AND
LINKAGE 16................................
POWER STEERING OIL PUMP 30...........
POWER STEERING OIL HOSES 35..........
WARNINGS REGARDING SERVICING OF SUPPLEMENTAL RESTRAINT SYSTEM (SRS) EQUIPPED VEHICLES
WARNING!
(1) Improper service or maintenance of any component of the SRS, or any SRS-related component, can lead to personal
injury or death to service personnel (from inadvertent firing of the air bag) or to the driver and passenger (from rendering
the SRS inoperative).
(2) Service or maintenance of any SRS component or SRS-related component must be performed only at an authorized
MITSUBISHI dealer.
(3) MITSUBISHI dealer personnel must thoroughly review this manual, and especially its GROUP 52B - Supplemental
Restraint System (SRS) before beginning any service or maintenance of any component of the SRS or any SRS-related
component.
NOTE
The SRS includes the following components: SRS-ECU, SRS warning lamp, air bag module, clock spring and interconnecting
wiring. Other SRS-related components (that mayhave to be removed/installed in connectionwith SRS service or maintenance) are
indicated in the table of contents by an asterisk(*).
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk
Page 1457 of 1839
52A-2
INTERIOR
CONTENTS
SERVICE SPECIFICATIONS 3.................
SPECIAL TOOL 3............................
INSTRUMENT PANEL
INSTRUMENT PANEL
FLOOR CONSOLE 12........................
TRIMS 13...................................
SUNVISOR HOLDER 17......................FRONT SEAT 18............................
REAR/SECOND SEAT 25....................
THIRD SEAT 35.............................
FRONT SEAT BELT 38.......................
REAR SEAT BELT
SECOND/THIRD SEAT BELT
WARNINGS REGARDING SERVICING OF SUPPLEMENTAL RESTRAINT SYSTEM (SRS) EQUIPPED VEHICLES
WARNING!
(1) Improper service or maintenance of any component of the SRS, or any SRS-related component, can lead to personal
injury or death to service personnel (from inadvertent firing of the air bag) or to the driver (from rendering the SRS
inoperative).
(2) Service or maintenance of any SRS component or SRS-related component must be performed only at an authorized
MITSUBISHI dealer.
(3) MITSUBISHI dealer personnel must thoroughly review this manual, and especially its GROUP 52B - Supplemental
Restraint System (SRS) before beginning any service or maintenance of any component of the SRS or any SRS-related
component.
NOTE
The SRS includes the following components: front impact sensors, SRS-ECU, SRS warning lamp, air bag module, clock spring and
interconnecting wiring. Other SRS-related components (that mayhave to be removed/installed in connectionwith SRS service or
maintenance) are indicated in the table of contents by an asterisk(*).
www.WorkshopManuals.co.uk
Purchased from www.WorkshopManuals.co.uk