relay MITSUBISHI OUTLANDER SPORT 2014 3.G Owners Manual

Fuses11-18 Maintenance
11
*: Fusible linkzSome fuses may not be installed on yourvehicle, depending on the vehicle modelor specifications.
zThe table above shows the main equip-ment corresponding to each fuse.
E01008001867
16
SRS airbag 7.5 A
17
Radio 15 A
18
Control unit
relay
7.5 A
19
Interior lamps(Room lamps)
15 A
20
Reversing lamps
(Backup lamps)
7.5 A
21
Heated door
mirror
7.5 A
22
Outside rear-view mirrors
10 A
23
Cigarette lighter/Accessory socket
15 A
24
Charge 7.5 A
25
Power seat 30 A
*
26
Heated seat 30 A
No.
Symbol
Electrical sys-
tem
Capacity
Engine compartment fuse location table Behind of the fuse block coverMain fuse block
No.
Sym-bol
Electrical sys-
tem
Capacities
SBF1
Air condition-ing condenser fan motor
30 A
*
SBF2 — — —SBF3 — — —SBF4
Radiator fan
motor
40 A
*
SBF5
Anti-lock brak-ing system
40 A
*
SBF6 — — —SBF7
Anti-lock brak-ing system
30 A
*
BF1
Electric tailgate 30 A
BF2
Audio system
amp
30 A
BF3 IOD IOD 30 ABF4 — — —F1 — — —F2
Wiper deicer 15A
F3 — — —F4
Daytime run-ning lamps
10 A
F5
Front fog lamps 15 A
F6 — — —
BK0203201EN.book 18 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Replacement of lamp bulbs
Maintenance 11-23
11
E01003401912
E01009301421
1. When replacing the bulb on the left sideof the vehicle, remove the bolt (A) hold-ing down the relay box and move therelay box.
2. Turn the cap (B) anticlockwise to removeit.3. Turn the socket (C) anticlockwise toremove it, and then pull the bulb out ofthe socket.4. To install the bulb, perform the removalsteps in reverse.
Inside 1- Luggage room lamp: 8 W2- Room lamp (rear): 8 W3- Map & room lamps (front): 8 W4- Downlight5- Vanity mirror lamps: 2 W6- Glove box lamp: 1.4 W
NOTE
zAn LED, not a bulb, is used in the downlight.Contact a MITSUBISHI MOTORS Author-ised Service Point when there is a need forrepair or replacement.
Headlamps (low beam, halogen bulb) *:Front of the vehicle
*:Front of the vehicle
BK0203201EN.book 23 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Replacement of lamp bulbs11-24 Maintenance
11
E01009401246
1. When replacing the bulb on the right sideof the vehicle, remove the clip (A) hold-ing down the washer tank and move thewasher tank.
2. Turn the cap (B) anticlockwise to removeit.3. Turn the bulb (C) anticlockwise to removeit, and then while holding down the tab(D), pull out the connector (E).4. To install the bulb, perform the removalsteps in reverse.
E01003702231
When replacing the bulb on the left side ofthe vehicle, move the relay box.(Refer to “Headlamps (low beam, halogenbulb): Step 1” on page 11-23)1. Turn the cap (A) anticlockwise to removeit.
Headlamps (high beam) *:Front of the vehicle
*:Front of the vehicle
Position lamps Except for vehicles equipped with high intensity discharge head-lamps *:Front of the vehicle
BK0203201EN.book 24 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分