N22A200A
5. Place the jack under one of the jack-
ing points shown in the illustration. Use
the jacking point closest to the tyre to be
changed.
C-Front jacking point
N22A201A
D-Rear jacking point
NOTE
Usually set the jack at the jacking point (D).
However, if the ground clearance is insuf-
ficient at the jacking point (D), use the jack-
ing point (E).
WARNING
(1) Don’t place the jack at any posi-
tion other than the one speci-
fied. If the jack is placed at a
wrong position, the body of the
vehicle could be dented or the
jack might fall over and cause
personal injury.
(2) Avoid using the jack on a slope
or on a soft surface.
Otherwise the jack might tilt, and
the vehicle falls down, causing
an unexpected accident.
Always use the jack on a flat,
hard surface. Before placing the
jack, check to ensure that there
are no sand or pebbles on the
surface.
For emergencies
8-9
Div:
Out put date:
Dimensions
EP01BOEb
Item 3-door models 5-door models
1 Front track 1, 560 mm
2 Overall width without side protector moulding 1, 885 mm
with side protector moulding 1, 895 mm
3 Front overhang 745 mm
4 Wheel base 2, 545 mm 2, 780 mm
5 Rear overhang with 235/80R16 size tyre 1, 005 mm 1, 285 mm
with 265/70R16 size tyre 1, 025 mm 1, 305 mm
6 Overall length with 235/80R16 size tyre 4, 295 mm 4, 810 mm
with 265/70R16 size tyre 4, 315 mm 4, 830 mm
7 Ground clearance
(unladen) 3200 models 225 mm
Except for 3200 models 235 mm
8 Overall height without roof rail 1, 845 mm 1, 855 mm
9 with roof rail 1, 875 mm 1, 885 mm
10 Rear track 1, 560 mm
Specifications
10-6Div:
Out put date:
