temp sensor NISSAN 300ZX 1984 Z31 Maintenance Workshop Manual
[x] Cancel search | Manufacturer: NISSAN, Model Year: 1984, Model line: 300ZX, Model: NISSAN 300ZX 1984 Z31Pages: 38, PDF Size: 1.19 MB
Page 2 of 38
PERIODIC MAINTENANCE
The following charts show the normal malntenance schedule Under severe driving conditions, additional or
more frequent maintenance
w~ll be required. Refer to "Maintenance under severe driving conditions".
The periodic maintenance schedule
is repeated beyond the last mileage and period shown.
EMISSION CONTROL SYSTEM MAINTENANCE
MAINTENANCE OPERATION MAINTENANCE INTERVAL
Pertodc rnantenance should be performed Miles x 1,000 15 30 45 60
at number of miles. kilometers or months. (K,lometerr x 1.0001 (241 (481 (721 (961
Months 12 24 36 48
whichever comer first
Reference
Page
Orwe belts I I MA-8
Air cleaner filter R R MA-8
Vapor hnes 1. If MA4
Fuel lines (hoses. piping. connections. etc ) If if MA-9
Fuel filter See NOTE (11. MA-9
Englne coolant R R MA-10
MA-1 1
Engine 081
MA-1
1
Replace every 7.500 mile6
(12.000 kml or6 months
Replace every 5,000
miles
18.000 kmJ or 6 months
Replace
at the first 011
Except turbocharged engine
Turbocharged engine
Ewne 011 f,lter change and then every MA-1 1 second od change
Spark plugs R R MA-12. 13
I"",..""
Exhaust gas sensor I I MA-15. 16
NOTE:
(1) If vehicle is operated under extremely adverse weather conditions or in areas where ambient temperatures are either
extremely
low or extremely high, the filters mlght become clogged. In such an event, replke them immediately.
(2) Maintenance Items and antervals wlth "*" are recommended by NISSAN MOTOR CO., LTD. Other maintenance items and
intervals
are required.
Abbreviations A = Adjust
R =Replace
I = Inspect Correct or replace if necessary
MA-2
.
Page 16 of 38
ENGINE MAINTENANCE
Checking Exhaust Gas Sensor (Cont'd)
Preparation
When checking exhaust gas sensor, make sure that the following are
in good order
0 Battery
0 Hoses
Engine oil and coolant levels
E C C S. components
E.C C S. harness and connectors
Oil filler cap and oil level gauge
Checking procedure
START
Stan engine and warm UP until water
temperature indicator Points
IO middle
of gauge
I +
Run engine at about 2.000 rpm for abut
2 minutes under noload
I
E C C S control unit is turned fully
referring to MIXTURE RA
MA-1 6